A reinforced concrete T-beam carries a uniformly distributed super-load on a simply supported span of 8 m. The stresses in the steel and concrete are not to exceed 125 MN/m2 and 7 MN/m2, respectively. The modular ratio is 15, and the density of concrete is 2400 kg/m3. Determine the permissible super-load.

Q: Find the maximum P that can be applied at point E given that:

A: The below approach entails using material mechanics ideas to the issue of determining the maximum…

Q: page), are bon. force of P = 2,8 e left. Determit ce applied to ea wa FBD of the a only exert horiz

A:

Q: A 8 kN/m B 60°

A: Given data is

Q: A steel I-beam to is designed under the tank for holding it. You know that the deflection of the…

A:

Q: Hydraulic circuits use schematic drawings to 1-Make untrained and improper knowledgeable person…

A: Hydraulic circuits: Hydraulic circuits is used to transmit and control the power from the mechanical…

Q: 5. A beam of uniform cross section and rectangular is 50mm broad,75mm deep and 6m long. It is simply…

A:

Q: support the uniform distributed load of u=1,68 kip/ft and a concentrated force which is applied at…

A: The W24 ×104 A - 36 steel beam Uniform distributed load W = 1.68 kip/ft  (VA ) v1 = WL⁴/ 8EI (VA )…

Q: A1 A uniform bar of length L and cross sectional area A is held vertically at the upper end and…

A: When a uniform bar is hanged hanged vertically, the weight of bar varies from zero to W. At tip, it…

Q: 5. The rigid beam is supported by a pin at Cand a steel wire AB (Esteel = 200 GPa). a) If the wire…

A:

Q: 3. Two rectangular blocks of rubber, each 80 mm wide by 20 mm tall by 40 mm thick (dimension into…

A: Since we only answer up to 3 subparts so we will answer first 3. Please resubmit the question by…

Q: A simply supported T-shaped beam of 6m in length has to be designed to carry an inclined central…

A: W = 448.6NExplanation:Step 1: Solve for the location of the centroid and moment of inertia. Step 2:…

Q: Handwritten solution required,No chatgpt. You must have to include the free body diagram. Don't make…

A: Please see the attached images for the solution.If there are queries or if the images are not…

Q: 5) What are the main components of a function of each part? centrifugal pump and what is the

A:

Q: 3.11 A beam, 12 m long, is to be simply supported at 2 m from each end and to carry a u.d.1. of 30…

A: Let 'C' be the first joint which is located at 5m left from support A.'D' be the second joint and…

Combined Loading

Any functioning component, such as machine parts, structural members, pressure vessels, and so on, are all under the influence of more than one force. When anybody is under the influence of more than one force such as shear forces, bending moments, axial forces, torsion, and so on, then such body is said to be under combined loading. A very practical example of combined loading is the crankshaft of an internal combustion engine (IC engine). The crankshaft of the IC engine is under high rpm, which is caused due to the torsional forces. Due to the presence of piston, counterbalances, and internal imbalances, the crankshaft experiences lateral forces and due to the rise in temperature, the crankshaft undergoes thermal expansion, which pulls the crankshaft along the axial direction and lateral direction. The presence of unbalanced loads along the periphery of the crankshaft also induces a bending moment.