The question was sent hours ago and you sent an unclear answer. I hope the solution is on the paper and clear. A reflex klystron operates at the peak of the n-2 mode. If (V1/Vo)=0.363, find theefficiency. Assume ẞ=1.X'11.21.5222.408J₁(X')0.440.50.550.580.582

Here are the steps on how to solve it: Given values:n=2n = 2n=2 (mode)V1V0=0.363\frac{V_1}{V_0} =…

Answered: A reflex klystron operates at the peak…

Delmar's Standard Textbook Of Electricity

7th Edition

ISBN:9781337900348

Author:Stephen L. Herman

Publisher:Stephen L. Herman

Chapter16: Inductance In Ac Circuits

Section: Chapter Questions

Problem 2PP: What frequency must be applied to a 33-mH inductor to produce an inductive reactance of 99.526 ?

See similar textbooks

Question

The question was sent hours ago and you sent an unclear answer. I hope the solution is on the paper and clear.

A reflex klystron operates at the peak of the n-2 mode. If (V1/Vo)=0.363, find the
efficiency. Assume ẞ=1.
X'
1
1.2
1.52
2
2.408
J₁(X')
0.44
0.5
0.55
0.58
0.582

Expert Solution

Step by step

Solved in 2 steps

SEE SOLUTION Check out a sample Q&A here

Similar questions

For the circuit below assuming an ideal switch, preform transient analysis to predict the voltage across resistor, R2 and plot the results. The inductor will have zero current as initial condition. L1 0.005 2 U1 100mH R1 1k V1 20Vdc R2 100
A clipper circuit based on diodes are simple way to modify waveform in mechatronics. Assume that the two diodes shown in the circuit below are ideal diodes. If the input voltage in the circuit is a 1 kHz sinusoid with peak amplitude of 8V, sketch the Va.. (t) 10 kO 8V 10 kO Vin Vin(t) D2 Vout(t) RL Ims D1 6V -8V 4V Page | 1
10 V sine 90 kHz 1 kQ C1 1 nF 2. Using a Square function with 90,000 Hz in your function-generator, a 1000-ohm resistor, and a 1 nano-Farad capacitor, determine the charging time for the capacitor. Show your calculations and show the charging-discharge curve with an oscilloscope in TINKERCAD.
A piezoelectric crystal has a thickness of 2.5 mm and a voltage sensitivity of 0.05 Vm/N. The piezoelectric crystal is subjected to an external pressure of 1.6 x 105 N/m², then the corresponding output voltage is?
Draw a diagram of a 60 Hz AC voltage waveform that is being altered by a 3rd (2)harmonic where the 3rd harmonic is subtractive. (It may assist you to draw the fundamental and the 3rd harmonic then the combined waveform). (2)
Explain how you would use an oscilloscope to measure an alternating potential difference of the order of 10V peak-to-peak. (You may assume that an alternating PD of 5V peak-to-peak is available).What is the RMS value of a peak-to-peak voltage of 10.0V?
A resistor of 20ohms and a capacitance of unknown value when connected. In in parallel across a 100V, 50Hz supply take a current of 6A. The combination is now connected across a 100V supply of unknown frequency and the current falls to 5.5A . What is the frequency?
A capacitor in series with a 200 ohms resistor draws a current of 0.3 ampere from 120 volts, 60 hz source. What is the value of the capacitor in microfarad? a. 8.7 b. 9.7 c. 6.7 d. 7.7
Find the Current in the Circuit in Miliampares
Answer the following with illustration and solution. 1.) A circuit consisting of a resistor of 5kohms in series with a capacitor of 10 nanofarad is connected across a 16v sinusoidal supply. Calculate the output voltage at a frequency of 60Hz and again at frequency of 120Hz. This is the example/guide that might help.
Please answer it only correct.
Problem 6: w- Calculate the voltage across the capacitor every 15 0.1 ms for one complete period of the input waveform. Then, use Multisim to sketch the 25 V (n capacitor waveform. Repeat the calculation and the simulation for a frequency of 2 kHz

SEE MORE QUESTIONS

Recommended textbooks for you

Delmar's Standard Textbook Of Electricity

Electrical Engineering

ISBN:

9781337900348

Author:

Stephen L. Herman

Publisher:

Cengage Learning

Delmar's Standard Textbook Of Electricity

Electrical Engineering

ISBN:

9781337900348

Author:

Stephen L. Herman

Publisher:

Cengage Learning

SEE MORE TEXTBOOKS

A reflex klystron operates at the peak of the n-2 mode. If (V1/Vo)=0.363, find the efficiency. Assume ẞ=1. X' 1 1.2 1.52 2 2.408 J₁(X') 0.44 0.5 0.55 0.58 0.582