Answered: A rectangular tank on a tanker is 21m…

A rectangular tank on a tanker is 21m long 26m wide and 18m deep How much oil, in tons, of relative density 0.84 does it contain if the ullage is 2.1m?

Structural Analysis

6th Edition

ISBN:9781337630931

Author:KASSIMALI, Aslam.

Publisher:KASSIMALI, Aslam.

Chapter2: Loads On Structures

Section: Chapter Questions

Problem 1P

See similar textbooks

Related questions

Q: A metallic bearing of diameter 8 mm is dropped into an oil of density 800 kg/m3. If the terminal…

A: Given: Diameter of bearing, D = 8 mm = 0.008 m Density of oil = 800 kg/m3 Terminal velocity of…

Q: lly holds 100 gallons of brine that contains 150 pounds af salt, and tank B holds 100 gallons of…

A: Given:- Tank A holds= 100 gallons of brine Tank A =150 pounds of salt Tank B holds-100 gallons of…

Q: What is the specific weight in kN/cu.m of an oil with specific gravity of 0.75? What is the specific…

Q: Crude oil having a density of 856 kg/m' and dynamic viscosity of 0.0072 Pa-sec flows through a 60 mm…

A: Given data in question Density Discharge Angle Length To find out Which among is correct

Q: the chlorine demand for a water is 3.0 mg/L, and the breakpoint is at 3.0 mg/L, what would the…

Q: A high-rate digester is being operated at a constant temperature of 100°F. The sludge loading rate…

A: Given data- High-rate digester- Temperature = 100oF, Sludge loading rate SLR=396 m3/d, To Find- The…

Q: A tank contains 136 gal of brine made by dissolving 86 lb of salt in water. Pure water runs into the…

A: ASKED: To compute the time required for 2/3 salt to leave the tank. Given, Volume of the tank (Vo)…

Q: A well mixed tank with a capacity of 1500 gals originally contains 1000 gals of fresh water. One…

A: Tank capacity =1500 gals Fresh water content = 1000 galsTo find salt concentration in tank

Q: A cylindrical container with a diameter of 1.0 m and a height of 2.0 m weighs 294N. If the container…

Q: 2. A suspension of particles with a particle density of 2796 kg/m³ is settling in water with a…

A: Given Specific gravity G = 2796/1000 = 2.796 Kinematic viscosity of water at 20 ° C = 1.004 × 10 -6…

Q: Calculate the oil volume, gas volume, and water volume given the following data: Area = 239500 ft2 ,…

A: Given:- Area = 239500 ft2 Thickness = 187 ft Net to Gross = 79% Porosity = 9% Water saturation = 51%…

Q: Assume the described is at steady state. A fluid goes up to an aquifer that has groundwater and a…

A: Volume of groundwater reservoir, Outflow, Chloride Concentration of fluid, Chloride outflow,

Q: An oil tanker carries 1.5 × 106 barrels of crude in its hold. Determine the weight of the oil if its…

Q: B-. Calculate the molecular type distribution of a petroleum fraction of relative density 0.9433,…

Q: By what percent is the volume of water decreased if its pressure is increased to an equivalent to…

A: To determine the percent decrease in volume of water for given increase in pressure and Bulk…

Q: A metallic bearing of diameter 8 mm is dropped into an oil of density 800 kg/m3. If the terminal…

A: Given: Diameter of bearing, D = 8 mm = 0.008 m Density of oil = 800 kg/m3 Terminal velocity, u = 40…

Q: Question 4 Screenings are placed in a debris roll-off dumpster that holds 20 cubic yards of…

A: Let's convert first the 20 cubic yards to gallons: = 20 yards3 x 27 ft3/yd3 = 540 ft3 x 7.48…

Q: Calculate the approximate viscosity of oil. 0.6x0.6 m sauare plate W 15kgr 13 5 12 -0.12 cm oil film…

A: Introduction : The viscosity of oil is the ease with which it pours at a given temperature. Thin…

Q: A hydraulic jack contains 2.0 litres of oil as the working fluid. The compressibility of the oil is…

A: Given, Volume of oil(V) = 2ltr=2×10^-3 m^ compressibility (B)= 1.98×10^-10/pa Pressure (p)…

Q: The 50 cm diameter circular disc rotating at a constant angular speed of 400 rpm / minute is on the…

Q: An open tank has a vertical partition and on one side contains gasoline with a density p = 700 kg/m³…

A: Gate will start to open when the force from water side will be greater than gasoline side When Force…

Q: A ship with cargo weighs 44,480 kN and draws 7.60m of salt water. On crossing a bar at the entrance…

A: Given, Weight of cargo ship =4480kN Draft of salt water =7.60 m decrease in draft of sea water =…

Q: What is turbidity, what causes it, how is it treated why it is undesirable in drinking water.…

A: Solution The range of G value is (200-300) 1/sec Turbidity can be defined as the amount of light…

Q: undisturbed sample is 6 cm in diameter and 10.61 cm high. The sample is oven-dried for 24 hr at 110…

Q: A child playing in the pool is using a cylindrical can as a boat for his toy soldiers. The can…

A: Following are the given information. Weight of can, F = 778.5 N Height, H = 1.5 m Diameter, d =…

Q: total solidification time

A: Volume: V=(14+8)2x4x10V=440 cm3

Q: A Brine containing 2 lb of salt per gallon runs into a tank at 2 gal/min, brine from this first tank…

A: The figure is shown below,

Q: A steel sphere, 1.5 mm diameter and of mass 13./ mg, falls steadily in oil through a vertical…

A: The given data is: Diameter of sphere=1.5 mm Mass of sphere=13.7 mg The vertical distance=500 mm…

Q: 1. If 5.6 m³ of oil weighs 46,800 N, calculate the following: a.) Unit weight b. ) density c. )…

A: Given data:Volume of oil V=5.6m3Weight of oil W=46800N

Q: kinematic viscosity

A: To find: Kinematic viscosity

Q: How much bleaching powder is needed to chlorinate 5000l of water whose chlorine demand is 2 mg/l,…

A: Objective: To determine the required quantity of bleaching powder required. Given: Volume of the…

Q: What depth (in feet) of oil with a specific gravity of 0.87, will produce a pressure of 40.0 psi?…

Q: 7. If the BOD5 of two wastes having k values of 0.0800 d-¹ and 0.120 d'¹ is 280.0 mg/L, what would…

A: Given Data BOD5 = 280 mg/L k = 0.08 d-1 k = 0.12 d-1 Determine the ultimate BOD for each value of…

Q: certain liquid flows in a 10 mm diameter smooth pipe that is 20 m long. The total head lost in the…

A: Given Reynolds number Re=1800 <2000 so laminar flow so friction factor…

Concept explainers

Pressure and Stress

Question

A rectangular tank on a tanker is 21m long 26m wide and 18m deep How much oil, in tons, of relative density 0.84 does it contain if the ullage is 2.1m?

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

This is a popular solution!

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Trending now

This is a popular solution!

Step by step

Solved in 2 steps with 2 images

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, civil-engineering and related others by exploring similar questions and additional content below.

Similar questions

I need fast answer
THE DEAD SEA HAS BEEN FOUND TO HAVE SEAWATER WITH A UNITWEIGHT OF 75 Ib/ft^3; GLYCERIN HAS A SPECIFIC GRAVITY OF 1.26 AND HONEY HAS A DENSITY OF 1450 kg/m^3, IF EACH LIQUID WAS POURED INTO A BREAKER ONE AT A TIME(WITHOUT MIXING), WHAT WILL BE THE ORDER OF THE LIQUIDS FROM THE BOTTOM OF THE BREAKER?
APPLICATIONS OF DIFFERENTIAL EQUATION: A tank is initially filled with 100 liters of pure water. Brine containing 6 grams of salt per liter comes in at a rate of 4 L/min. Well-mixed solution comes out of the tank at the same rate. After what time, in minutes, will the tank concentration be 3 g/L
An oil of density 892 kg/m³ is flowing in a pipe having an internal diameter 5cm. This pipe is connected to another one with diameter 7.5cm which branches into two smaller pipes each one having a diameter of 3.75cm. If the flow rate in the first pipe is 1.388 x 10 m³/s, calculate: a- The mass flow rate in the first pipe and in the branches of the second pipe. b- The average velocity in the first pipe and in the branches of the second pipe.
Q\Determination of liquid levels in industrial strong tanks using police radar?
Civil
A cylindrical container is 185mm in diameter and weighs 3.55N when empty. When filled to a depth of 250 mm with acertain oil, it weighs 55.4 N. Calculate the specific gravity ofthe oil.
A child playing in the pool is using a cylindrical can as a boat for his toy soldiers. The can weighs 778.5 N with a height of 1.5 m and a diameter of (0.5)0.5 m. Which of the following most nearly gives the maximum number of toy soldiers, each weighing 1 kN, that the can could carry without sinking? Choose a match 6 0.519 m 0.3210 m 0.588 m 1.298 m 0.2021 m
Please answer, this is due in an hourPlease show correct figure
SAE 30 oil is contained in a cylinder with inside diameter of 2.5 cm and length of 30 cm. What is the pressure required to decrease the volume of the oil by 2%?
The value of the equivalent volume of 1100 gallons is . m^3. 4.00 O 4.75 5.00 5.75 O other answer
A rectangular plate of 0.50 m x 0.50 m dimensions weighing 500 N slides down an inclined plane making 30° angle with the horizontal, at a velocity of 1.75 m/s. If the 2 mm gap between the plate and the inclined surface is filled with a lubricating oil, find its viscosity and express it in poise as well as in Ns/m².