A rectangular scow 9.15 m wide by 15.25 long and 3.65 m high has a draft of 2.44m in sea water its center of gravity is 2.75m above the bottom of the scow. A.) Determine the initial metacentric height B.) If the scow tilts until one of the longitudinal sides is just at the point of submergence determine the righting couple or the overturning couple

Q: 250 kN 250 kN 250 kN B D E 0.9 m 0.9 m 0.9 m 0.9 m Fig. P8.5

A:

Q: The hypotenuse allowance (in m) for 30 m long chain, if the slope is 1:10 is (a) 0.1 (b) 0.12 (c)…

A: given- L=30 m,slope=1:10,

Q: The base width of a solid gravity dam is 35 m and the specific gravity of dan material is 2,45. What…

A:

Q: The figure shows the section of weir, the base of which is 1.5m below the ground. The necessary flow…

A:

Q: For the given couple-force system shown, determine the horizontal component of Q. P= 335 KN Q= 44 KN…

A:

Q: P B D. L L O 72.8 kN О 37.2 kN 61.0 kN 45.0 kN 57.9 kN

A:

Q: determine the magnitude and direction of F3

A: We know: The summation of the components of each force in the horizontal direction is equal to the…

Q: Determine the average shear stress of a trapezoidal channel having base width 6m, depth 5m and side…

A: When we assume that the soil is incoherent, and we can study the effect individually, the basic…

Q: masonry dam has a given cross-section shown. The intensity of hydrostatic uplift varies uniformly…

A:

Q: The cross-section of a dam is shown below. Headwater is on the vertical face of the dam and is flush…

A: Part 3a is solved only. Because as per bartleby guidelines experts are allowed to solve only first…

Q: 6.0 kN 2.0 kN/m C B - 1.0 m 1.0 m »« 2.0 m 4.0 m

A: Apply equilibrium condition : ∑FX=0∑FY=0∑M=0

Q: 3. The section of a masonry dam is shown. Find the base width considering hydrostatic uplift to vary…

A: Depth of water (h) = 20 mDepth of dam (H)= 24 mTop width, b = 3 m

Q: The intensity of the hydrostatic uplift varles uniformly from 20 % of the full hydrostatic uplift…

A: u=.6

Q: ind the factor of safety against overturning. ind the factor against sliding if the coefficient of f…

A:

Q: Analyze the given continuous beam carrying UDL of 2.5kN/m using three moment equation. Take El as…

A:

Q: Situation 1: A rectangular gate 3 m high and 1.5 wide is hinged at the top. A force to keep the gate…

A:

Q: A scow 6 m wide and 20 m long has a mass of 200,000 kg. Its center of gravity is 30 cm above he…

A: Given 6m wide 20m long ∆y=30cm CG = 30 cm above water surface weight of body = mg = 200,000 x 9.81 =…

Q: Determine the value of El y at the right end of the overhanging beam. a = 4.3 m, b = 2.8 m, Wo =…

A: GIVEN- a =4.3 m, b = 2.8 m,Wo = 18.5 kN/m                     Determine- the value of EI y at the…

Q: The hypotenuse allowance (in m) for 30 m long chain, if the slope is 1:10 is (a) 0.1 (b) 0.12 (c)…

A:

Q: 4. Deflection at the overhanging end. 20 N-m B. 2EI El 2 m 4 m 5. Deflection at midspan. EI is…

A:

Q: A rectangular scow 9.5 m wide, 14 m long and 3.2m high has a draft in water of 2.4 m. Its center of…

A: Reference : Fluid mechanics, Submergence point. Given : Size of scow, Center of gravity To determine…

Q: trough full of oil has each end in the form of a semi-ellipse8 ft. wide across the top and 5 ft…

A: To find force acting on one end

Q: A rectangular scow 12-m long, 7.20m wide, and 2.40m 1.50m above the bottom. It carries a total load…

A:

Q: Concider a harbour gate 16.8m wide. If the sea faceing side had a depth of 18.11m and produces a…

A: Reference : Water resources, Harbour. To determine : Position of Resultant force line of action

Q: Dam is concrete gravity dam that impounds water both on the upstream and down stream sides. if the…

A:

Q: A square plate having each side equal to 3m is submerged vertically in water such that the upper…

A:

Q: The base width of a solid gravity dam is 25 m. The material of the dam has a specific gravity of…

A:

Q: _11. The value of the lateral torsional buckling modification factor for figure a is nearest to w,…

A: 1. value of the lateral torsional buckling modification factor for figure 11 is 1.30

Q: If the total passive thrust is 200 kN/m2 and total active thrust is 500 kN/m2, then determine the…

A: Given: Total passive thrust = 200 kN/m2 Total active thrust = 500 kN/m2

Q: 5- A 13-m-high, 7-m-wide rectangular plate blocks the end of a 12- m-deep freshwater channel, as…

A:

Q: 1.) Determine the support reactions: 3m 41.8 KN 7.2 m 29.2 LN/ 3.6 m 2225 KN -3.6m-

A: Determine the support reaction of the frame.

Q: Question A gravity dam of elementary profile is made of concrete of specific gravity 2.5. The safe…

A: Given - Specific gravity, G  = 2.5 Stress of foundation material, f =3.87 Mpa f = 3.87 ×103 pa…

Q: Problem 1.2 Find the

A: solution of above problem is below:

Q: 9, = 18 kPa 0.5 m 80 Ysat =19 kN/m? %3D = 25° 6.3 m Backfill Drainage blanket 1.0 m Y 23.5 kN/m3 0.9…

A: Active Earth Pressure (Ka) 3. Passive Earth Pressure (Kp) (Passive is more like a resistance) Earth…

Q: 14. The cost of borrow per cubic meter is P500 and the cost of haul per meter station is P20. The…

A: "Since you have asked multiple question, we will solve the first question for you. If you want any…

Q: During Aang's training for his battle against Fire Lord Ozai, he tried moving the large,…

A: Asked: To determine the value of force P required for tipping to impend.   Given: Mass of block DEFH…

Q: Determine the reactions and the shear and bending moment diagrams for the frame shown below. Use the…

A: ##Determination of reactions and shear force and bending moment diagram using slope deflection…

Q: 2000 mm 8000 mm 6000 mm

A: Dam is resisting lateral horizontal force applied by water by its own self weight this type of dam…