A rectangular gate having a width of 4 ft is located in the sloping side of a tank as shown in the figure below. The gate is hinged along its top edge and is held in position by the force P. Friction at the hinge and the weight of the gate can be neglected. Determine the required value of P.

A rectangular gate having a width of 4 ft is located in the sloping side of a tank as shown in the figure below. The gate is hinged along its top edge and is held in position by the force P. Friction at the hinge and the weight of the gate can be neglected. Determine the required value of P.

Name: A rectangular gate having a width of 4 ft is located in the sloping s
Uploaded: 2024-03-20T06:56:55.000Z
Channel: Bartleby
Description: A rectangular gate having a width of 4 ft is located in the sloping side of a tank as shown in the figure below. The gate is hinged along itstop edge and is held in position by the force P. Friction at the hinge and the weight of the gate can be neg

Elements Of Electromagnetics

7th Edition

ISBN:9780190698614

Author:Sadiku, Matthew N. O.

Publisher:Sadiku, Matthew N. O.

ChapterMA: Math Assessment

Section: Chapter Questions

Problem 1.1MA

See similar textbooks

Similar questions

Q4//Determine the required vertical force F to be applied at the lower edge to open the square gate (2.8m*2.8m) as shown in figure below: Negative pressures 8250Pa 1.8m Gasoline s-0.7 hinge gate
Weighted piston type accumulator is shown in the figure below. If area=340 cm², a lift of the ram =1190 mm. Calculate the capacity of the accumulator in terms of liters.
- A 3.5m - high . 5m wide rectangular gate is hinged at the top edge at A and is restrained by a fixed ridge at B. Determine the force exerted on the gate at Point B
A homogeneous, 1.2 m wide, 2.1 m long rectangular gate weighing 100 kg is held in place by a horizontal flexible cable as shown in figure 2. Water pressure acts against the gate which is hinged at point A. Friction in the hinge is negligible. Determine the tension in the cable.
I need the answer as soon as possible
Cords are loop around a small spacer separating two cylinders each weighing 400 kg and pass, as shown in figure over a frictionless pulleys to weights of 200kg and 400 kg. Determine the angle and the normal pressure N between the cylinders and the smooth horizontal surface. 200kg Total W = 800 kg 400kg
1. A cylinder of diameter 1.5 m and length 3 m is located in the edge of an oil tank as shown in the figure. The cylinder and the wall are smooth and the cylinder is in equilibrium. Calculate (a) The horizontal contact force of the wall. (b) the weight of the cylinder in kN. oil, p = 800 kg/m
A homogeneous, 4-ft-wide, 3.1-ft-long rectangular gate weighing 800 lb is held in place by a horizontal flexible cable as shown in the figure below. Water acts against the gate, which is hinged at point A. Friction in the hinge is negligible. Determine the tension in the cable. Assume L₁ = 3.1 ft, L₂=1.9 ft, and 0= 70% T-i 666.50 medle lb Water Cable Gate Hinge
Please do it your own
I've been struggling with this question for a long time and not sure how to find the correct answer.So far, my wrong answers were; 792, 128.6816, and 90.32.
A rectangular gate (6m x 4m) is e hinged at A and supported by a stopper as shown. Find the reaction Lé at the hinge neglecting the weight of the gate
Statics and rigid bodies