A rectangular channel with width 2m conveys flow at 240m^3/min.Manning,n and slope of the channel are given as 0.05 and 0.00937.In the middle of channel find the normal depth and critical depth of flow.Then,analyse the depth of flow upstream, downstream and the construction.

A rectangular channel with width 2m conveys flow at 240m^3/min.Manning,n and slope of the channel are given as 0.05 and 0.00937.In the middle of channel find the normal depth and critical depth of flow.Then,analyse the depth of flow upstream, downstream and the construction.

Structural Analysis

6th Edition

ISBN:9781337630931

Author:KASSIMALI, Aslam.

Publisher:KASSIMALI, Aslam.

Chapter2: Loads On Structures

Section: Chapter Questions

Problem 1P

See similar textbooks

Related questions

Q: Question 17 The water surface slope is 0.001 while the bed slope is 0.002 going downstream. Which of…

Q: To measure discharge of a small river, the river width was divided into 8 segments of 2 m width…

Q: Determine the critical depth (m) for following rectangular open channel: Flowrate = 64 m^3/s Channel…

A: Given that: A rectangular channel, with flow rate, Q=64 m3/sChannel width, B=6m

Q: The following data are given for a stream of uniform flow: average stream cross section =9.45 sqm ;…

Q: A drainage canal in the shape of trapezoidal with a bottom width of 2.5 m and side slopes of 1…

Q: 6- Estimate the TOTAL streamflow in the channel below given the values in the table and the flow of…

Q: A circular channel (Manning's roughness, n = 0.014) with a diameter of 5 met used to convey a…

A: To find velocity of flow

Q: A trapezoidal channel has a bottom width of 6 m and side slope of 2 horizontal and 1 vertical when…

Q: A trapezoidal channel lined with concrete, C=130,B=10m, side slope=1:1,depth=5m,channel slope…

A: It is required to determine the top width of channel. T=b+yz1+z2 Here b is the bottom width, y is…

Q: Find the value of flow velocity Discharge=102 m3/s Area of channel=35 m2

A: Given data : The value of discharge Q=102 m3/s The value of area of channel A=35 m2 Required :…

Q: Calculate the values ofcritical height and critical velocity for water flowing through a rectangular…

A: Given: Width of channel, b = 6 m Flow rate, Q = 21 m3/sec

Q: For #5-7, assume there is a creek with a width of 4.6 m, depth of 23 cm, slope of 0.001 m/m, and…

A: Given: DischargeQ=0.13 m3s Width of rectangular channelB=4.6 m=460 cm Depth of flowy=23 cm…

Q: Consider a channel of irregular and varying x-section, but with the low point of the section…

A: For a open channel flow - Total head - H = z + y + v22g∵v = QA⇒H = z + y + Q22gA2∵A = By⇒H = z + y…

Q: A trapezoidal channel having side slopes of 1:1 and bed slope of 1 in 852 is required to carry a…

A: Given: The side slope of the channel is 1:1. The bed slope is 1 in 852. The discharge is the channel…

Q: The velocity distribution in a rectangular channel of width, B, and depth of flow, yo, was…

Q: The specific flow for a rectangular canal (see Figure 4) for which the bottom is 5 m wide is 2…

A: Canal width, B = 5 m Specific flow, q = 2 m3/s/m Manning's n = 0.015 Normal depth, yn = 1.5 m Find:…

Q: Q5: Perform the flood routing for a reach of river given the table below. The inflow hydrograph with…

A: Given data:- ∆t=0.25 day=0.25×24 hour=6 hoursx=0.5k=0.457 day=0.457×24 hours=10.968 hours Below…

Q: A rectangular open channel carries a discharge of 15 m³/s when the depth of flow is 1.5 m and the…

Q: 1. If the critical depth of a wide rectangular channel is 3 m, determine the unit flow rate?

A: solution Given critical depth yc=3mts

Q: rflow spillway that has a design discharge of 50,000 ft^3/s, if the upstream water depth is at an…

A: Given data Discharge over spillway=50000 ft3/s upstream water depth is at an elevation =800 ft Floor…

Q: of rectangular channel if discahrge value is ne velocity of flow is 4 m/s

Q: Discharge Q2/The flood hydrograph upstream of a proposed bridge Time (hr) (ms) location is as…

A: Muskingum Routing method K = 3 hrs x = 0.3 ∆t = 1

Q: Determine and draw the baseflow using; a. Straight line method b. Fixed based method using N = 5 С.…

A: Baseflow separation from hydrograph can be done using three methods. They are 1. Straight line…

Q: Give Answer fast and right.

A: Calculations:Given data y = 2.438 - depth of flow in meters B = 12 - bottom width in meters z =…

Q: Time (hrs) 0 12 24 36 48 60 72 84 96 108 Inflow Discharge (m3/hr) a. Draw the Inflow and Outflow…

A: To plot the inflow and outflow hydrograph. And to identify the peak discharge rate in inflow and…

Q: A rectangular channel 22 feet wide carries a flow of 25,000 cfs on a slope of 0.01. Manning's n for…

Q: Question: A rectangular channel is 3m wide and has a depth of flow of 1.5m. The channel roughness ca…

A: The given data is: Width of channel (B) = 3 m Depth of flow (y) = 1.5 m Channel roughness (n) =…

Q: The river flows passes through a 2.30 wide rectangular sharp-crested weir. If the water level…

Q: calculate the discharge of water

A: Open channel flow- Fluid mechanics:

Q: 10.45 Water flows down a wide rectangular channel having Manning's n = 0.015 and bottom slope =…

A: assume width B and depth of eater in wide rectangular channnel ythen area A=Byand wetted…

Q: Problem 5. A small river is in flood stage and you need to estimate the flow rate through it. The…

A: Q= 1.49nAR23S12 A= 2000 sqft P= 620 ft R= 2000/620= 3.226 ft Assuming S= 0.001 By COX METHOD,…

Q: The stream below shows the velocities of each section at their 0.2D and 0.8D except for the corner…

A: to find - Q(discharge in stream)

Q: rapezoidal open channel. The following data are available:- 1- Cross-sectional area of flow in the…

Q: (a) Complete the table below for the three slope and flow classifications: Relationship between…

A: TypeRelationship between Normal depth (dn) and Critical depth (dc)Type of slopeType of…

Q: What is the depth of the flow (m) in a circular channel of diameter 2.0 m for the maximum velocity?

Q: Given the image of the open channel below and the accompanying geometry, determine the flow (m/s) to…

A: solution The slope is given as S=3.5%=0.035manning's costant for grass is given as N =0.03 depth…

Q: 5. Estimate the discharge in the stream cross section shown below using the given data. Determine…

A: The given values are as follows in the table, Station velocity(ft/s) 1 0.75 2 1.91 3 5.21…

Q: A 5 m wide rectangular channel carries a discharge of 16 m3/s. Manning's roughness coefficient for…

A: Given data in question Width Discharge slope Constant To find out Depth of flow

Concept explainers

Time and time related variables in engineering

Time is the event progression starting from past to present and then, future statistically. The time-related variable is any particular value in relation to time to assess its changes on a specified (XY) plane.

Question

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Step by step

Solved in 2 steps

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Time and time related variables in engineering

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, civil-engineering and related others by exploring similar questions and additional content below.

Similar questions

Q (5-4) / Water flows uniformly in an earth trapezoidal cross section open channel. Data available are: Bed width of the channel B = 10 (m), water flow depth y = 5 (m), longitudinal slope of bed level of the channel S, = 0.0001, n = 0.025 {s/m(1/3)}, water flow rate Q=150 (m³/s), A=75 (m²) and P= 100 (m) and W = 2B. 1- Calculate values of the followings: Q, Z and Fr. 2- Mention Type of flow in the channel.
A trapezoidal channel having side slopes of 1:1 and bed slope of 1 in 805 is required to carry a discharge of 0.001242 m3/min. Find the dimensions of the channel for minimum cross-section. Take Chezy’s constant as 50.
A circular channel (Manning's roughness, n = 0.014) with a diameter of 5 meter is used to convey a uniform flow of 96 m³/s Area of flow,20 m sq m Velocity of flow is?
B6
the river flow passes through a 2.08 wide rectangular sharp crested weir. If the water level several meter upstream is 1.4 m what is the discharge (m^3/s) over the weir given that the flow reaches 0.1m above the crest? assume cw=0.637 and do not consider the velocity approach
Subject : Fluid mechanics Determine the normal depth (m) in a rectangular channel with flowing discharge of 90 m3/s, roughness of n=0.025, slope of 0.001, with bottom width of 6 meters.
A trapezoidal channel having side slopes of 1:1 and bed slope of 1 in 845 is required to carry a discharge of 211.25m3/min. Find the dimensions of the channel for minimum cross-section. Take Chezy’s constant as 50
Q5: The bed slope of a regime canal is 1/5500. Determine the canal section and discharge by using Lacey's theory. The average particle size is 0.35 mm.