A rectangle has sides approximately 380 metres and 260 metres. If the area is to be determined to the nearest 10 m² what will be maximum error permitted in each line and to what accuracy should the lines be measured. Assume equal precision ratio for each length..

Q: The sides of a closed figur

A: Accuracy ratio is the ratio of the error of the measurement to the distance measured. Accuracy…

Q: Calculate the amount of vertical displacement that will occur at point E with the VIRTUAL  METHOD.…

A: A = 10 cm2 = 1000 mm2 E = 100000 MPaDetermine the vertical displacement of joint E using virtual…

Q: The length of a line was measured repeatedly on three different occasions and probable error of each…

A: 1st set of measurements = 1201.50±0.02m2nd set of measurements= 1201.45±0.04m3rd set of measurements…

Q: Using Centroid by Integration, determine the x- and y-coordinates of the centroid of the shaded…

A:

Q: 2. Determine the resultant of the given illustration below. |y - axis 14 kips 64 48 kips 29° x -…

A: To Find :- Resultant of given force system

Q: 1- Find the area enclosed by the points and the x axis by using the Gauss quadrature (one point…

A:

State Plane Coordinate Systems

The state plane coordinate system (SPCS or SPS) is a collection of 124 coordinate systems or geographic zones prepared for particular regions of the U.S. Every state consists of one or more than one state plane zone, the boundaries of which generally follow the county lines. Inside the U.S., there are 110 zones in total, 10 more zones in Alaska, 5 in Hawaii, and 1 for Puerto Rico and US Virgin islands. The system is extensively used for geospatial and geographic data assembling by the state and local governments.