A reaction between liquid reactants takes place at 2.0 °C in a sealed, evacuated vessel with a measured volume of 30.0 L. Measurements show that the reaction produced 50. g of boron trifluoride gas. Calculate the pressure of boron trifluoride gas in the reaction vessel after the reaction. You may ignore the volume of the liquid reactants. Round your answer to 2 significant digits. pressure: atm x10

Q: If the student increased the rate at which drops were added to the pan, this would increase the v of…

A: The given cindition: If the drops are dropped increasing rate.  i.e more drops are added in a given…

Q: Analytical Chemistry II Please do a table of comparison on the following GC with respect to their…

A: For many applications, GC-MS offers very good sensitivity. It’s usually not as sensitive as a good…

Q: SPECTROSCOPY 1. If the concentration of solute in a solution is high, the Absorbance will be high or…

A: #Q.1: Concentration(C) of a solution and absorbance(A) are related through Beer's law formula which…

Q: O potassium sulfate barium hydroxide O lithium nitrate Two of the above are correct. (a). (b), and…

A:

Q: The aluminum in a package containing 70. ft of kitchen foil weighs approximately 12 ounces. Aluminum…

A: Given the area of the aluminium foil, A = 70. ft2  mass of the aluminium foil, m = 12 ounces…

Q: Statement 1: TLC is considered more convenient and efficient than paper chromatography. Statement 2:…

A: Thin layer chromatography is chromatography in which glass plate is used and it is also known as TLC…

Q: Complete the table below by deciding whether a precipitate forms when aqueous solutions A and B are…

A: A precipitation reaction occur when cations and anions of two solutions in aqueous medium combine to…

Q: * Balame Pedox R,D in auidic media -2 +2 → Mn + Co, -2 stiochiometric co-epiciantbof Mol4, soá, Mos"…

A: The reaction given is MnO4- + C2O42-  ---------->  Mn2+   + CO2  The oxidation number for O is…

Q: 2 Determine the weight % composition of the sample of Cut 3 from the gc trace you ran Peak Area for…

A: The objective of this question is to calculate the weight percentage composition of Cyclohexane and…

Q: Please don't use hend raiting and step by step solutions

A: The peak seen at 56, 18 points below the molecular ion peak i at m/z = 74 is enough to identify the…

Q: An atomic absorption method for the determination of the amount of iron present in used jet engine…

A:

Q: UV - spectra of two Bomers of cinmamic auld g dentify the is amer 2016|| The absorb at 272 nm & 268…

A: This Problem Is Based upon UV Spectroscopy, and it can be solved by the concept of steric hindrance…

Q: 1. What is the difference between dye and pigment? 2. Why is it vital for a chromophore to be a part…

A: 2. Chromophore is that part of the dye which is responsible for its colour. This colour is made…

Q: THE Y-INTER In K# -10749 -27 -35.0 -35.2 -35.4 -35.6 -35.8 -36.0 -36.2 THE WING GRAPH IS: 974 NOT…

A: Given -> Equation: lnK# = -10749/T - 27

Q: Cu/Cu 11 Ag/ Ag Zn/Zn || Ag /Ag Zn/Zn2 || Cu /Cu

A: The way of representation of the reaction D/D+2||E+/E denotes Anode reaction then bridge and then…

Q: 12. This detector is not used in HPLC: a) ECD b) MS c) Fluorescence d) RI

A: Mixture components are estimated using HPLC detectors. The actual separation in HPLC (High…

Q: 2 Determine the weight % composition of the sample of Cut 3 from the gc trace you ran Peak Area for…

A: The objective of the question is to calculate the weight percentage composition of Cyclohexane and…

Q: 1. Why is it recommended to have a carbon monoxide detector on each floor of a home?

A: Since you have asked multiple question, we will solve the first question for you. If you want any…

Q: Felodipine calcium channel blocker standard (0.251mg/ml) and felodipine sample (0.245mg/ml)…

A: Given that: concentration of felodipine standard = 0.251mg/ml concentration of felodipine sample =…

Q: pounds with common... Write the empirical formula for at least four ionic compounds that could be…

A: When there is completely transfer of electrons from one atom to another, then an ionic compound is…

Q: 2 Determine the weight % composition of the sample of Cut 3 from the gc trace you ran Peak Area for…

A: The objective of this question is to calculate the weight percentage composition of Cyclohexane and…

Q: help fill out this sheet based on structure

A:

Q: Complete the balanced neutralization equation for the reaction below: HCIO:(aq) + CSOH(aq) →

A: The answer to the following question is given as:

Q: ed with seawa asalt, before al

A: The basalt before alteration values were given. Estimated values of sea water can against the value…

Q: 68. This process is an example of O Liquid Chromatography O Atomic Absorption Spectrophotomer O Thin…

A: Liquid chromatography is used to identify and seperate each part of a solution. Atomic Absorbtion…

Q: urses/ 2951 2. A linear standard curve of KMnO4 is prepared from a set of standard solutions by…

A: The objective of this question is to determine the slope of the standard curve of KMnO4 and use it…

Q: 1. What does adsorb mean? 2. What is chromatography used for? 3. Why must a pencil rather than a pen…

A:

Q: 2 Determine the weight % composition of the sample of Cut 3 from the gc trace you ran Peak Area for…

A: The objective of this question is to calculate the weight percentage composition of Cyclohexane and…

Q: Two different methods were investigated for Cu2+ detection in water sample and both methods…

A: To choose the correct option:

Q: Suzy Baker What two chemicals are incompatible with copper metal (used in Expt 5)? (refer to ACS…

A: Incompatible chemicals are the substances which are when mixed gives an undesired chemical reaction.

Q: For the data given in Part A, above, from the trendline of your Excel x-y plot, determine and enter…

A: Given data:

Q: 23 Which one below is true for the reaction stages during photocatalytic activity of TiO,? * O2…

A: Photocatalytic reaction is accelerated by a catalyst (photocatalyst). In photocatalysis, light is…

Q: 23.4 Edit Laboratory temperature ("C) Concentration (M) of stock Fe(NO,), solution 0.0020 Edit…

A: The percentage transmittance for trial 1, trial 2, trial 3 and trial 4 is 15.6, 21.6, 28.6 and 40.8,…

Q: 6) What is the difference between CI-MS and EI-MS? What is CI and EI ?

A: The general flow chart of the mass spectrometry is -  sample - ion source - mass analyser - detector…

Q: Plot the calibration curve of absorbance versus molar concentration for the standard solutions. nly…

A: 1) To Plot the Calibration curve of Absorbance vs Molar Concentration for the standard solution. 2)…

Q: The quenching of tryptophan fluorescence by dissolved O₂ gas was monitored by measuring the emission…

A: From the data above, predict the value of [O2] required to decrease the intensity of tryptophan…

Q: Based on calibration curve, extinction coefficient for Red 40 Absorbance of Red 40 in Gatorade at…

A: "Since you have asked multiple questions, we will solve the first question for you. If you want any…

Q: O TDSB Bookmarks Summary - PayPal 9 Steam Guard Mobil. Booter Panel ll Asylum Stresser - H. O Free…

A:

Q: M =0.01500 M

A: Initial moles of FeCl3 as, = 2.00M × 10.00mL = 20mmoles

Q: Calculate the number of gold atoms in a 150.0 g sample of gold(III) chloride (Au,Cl,). Be sure your…

A: Given-> Weight of Au2Cl6 = 150.0 gm

Q: What is limit of detection? What is standard deviation?

A: To determine: limit of detection and standard deviation

Q: 6b. why doce CE have better performance than LC in separation

A:

Q: Briefly explain THREE (3) limitations of GC in analytical chemistry.

A: Gas chromatography (GC) is an analytical technique used for seperating and analysing the chemical…

Q: A UVisible spectrophotometer was zerced with distilled water at $10 nm, using a s The absorbances of…

A: We are given experimental data for the concentrations(C) of Co2+ standard solution and their…

Q: 2 Determine the weight % composition of the sample of Cut 3 from the gc trace you ran Peak Area for…

A: The objective of this question is to calculate the weight percentage composition of Cyclohexane and…

Q: Given the following size frequency for a dust: Size Interval (μm) 7-17.5 17.5-21 21-25 25-28 28-30…

A: The vibrational excitation at 30 Hz is found to be the most effective exciting frequency for dust…

Mole Concept

Mole concept is a method to determine the amount of any substance that consists of some elemental particles using a grouping unit called ‘mole’. The mole concept enables one to handle the large amount of small elementary particles. The mole concept can be used in many calculations related to mole calculation, molar amount, mole ratio, and so on, which are significant in chemistry.