A pupil walks from X to Y and then from Y to Z, as shown in the diagram. 4-0 km 3-0 km The walk takes the pupil 2 hours to complete. Identify which row in the table shows the average speed and the average velocity for the pupil, during this walk. average speed | 2-5 kmh 2-5 kmh' at 053° 3-5 kmh" 3-5 kmh' at 053° 3.5 kmh" average velocity 2-5 kmh at 053° 2-5 kmh" 2-5 kmh' at 053° 3-5 kmh A D E 3-5 kmh' at 053°

A pupil walks from X to Y and then from Y to Z, as shown in the diagram. 4-0 km 3-0 km The walk takes the pupil 2 hours to complete. Identify which row in the table shows the average speed and the average velocity for the pupil, during this walk. average speed | 2-5 kmh 2-5 kmh' at 053° 3-5 kmh" 3-5 kmh' at 053° 3.5 kmh" average velocity 2-5 kmh at 053° 2-5 kmh" 2-5 kmh' at 053° 3-5 kmh A D E 3-5 kmh' at 053°

Structural Analysis

6th Edition

ISBN:9781337630931

Author:KASSIMALI, Aslam.

Publisher:KASSIMALI, Aslam.

Chapter2: Loads On Structures

Section: Chapter Questions

Problem 1P

See similar textbooks

Similar questions

Q1. During a 60 seconds period, a loop detector is occupied by vehicles for the following times for the following, 0.34s (car1), 0.38s (car2), 0.40s (car3), 0.32s (car4) and 0.52s (car5). Estimate the value of flow, density and velocity. You can assume that length of the loop detector is equal to 10 feet and the average length of all vehicles is 20 feet. Vehicle Ground Loop Detection Circuit Ż
Two helicopters, H1 and H2, are traveling together. At the time t 0, they separate and follow different straight line paths given by H1: x = 6+ 40t y = -3+ 10t z = -3+2t H2: x 6+ 110t y = -3+ 4t z = -3+t Time t is measured in hours and all coordinates are measured in miles. Due to an error, H2 stops its flight at (446, 13, 1) and lands at (446, 13, 0). Two hours later, H is informed about H2 and moved toward H2 at 175 mph. How long will it takes Hi to reach H2?
A pace is the length of a step-in walking; it is measured from where? O a. toe to heel O b. tip of the toe to tip of the heel O c. heel to toe O d. heel to heel
Traffic engineering
1. Convert 80 kph to m/s using dimensional analysis.
3. Compute the Time Mean Speed and Space Mean Speed Vehicle Time (s) Speed (km/hr) A 15 100 B 25 150 45 350
four decimal places
A sign is required to be put up asking drivers to slow down to 30 km/h before entering zone Y (see figure). On this road, vehicles require 174 m to slow down to 30 kmn/h(the distance of 174 m includes the distance travelled during the perception reaction time of drivers). The sign can be read by 6/6 vision drivers from a distance of 48 m. The sign is placed at a distance of x m from the start of Zone Y so that even a 6/9 vision drive can slow down to 30 km/h before entering the zone. The minimum value of x is m. Direction of vehicle movement Road Sign | X Start of Zone Y Zone Y
During 5 successive 1.07 min intervals, a runner moves at the following constant speeds: 0,396 km/min, 0.248 km/min, 0.160 km, 0.160 km/min, and 0.320 km/ Compute the total distance traveled and the average speed.
A man and a woman both walked towards each other on a straight path but started at the opposite ends. Assuming they take the same step at a time, and that the woman is only 2/3 of the man's pace factor, and the length of the path is 100 meters. How many steps did they take before they were really close to each other if the man's pace factor is 0.76m/pace?