A pump is located near the edge of the horizontal platform shown. The nozzle at A discharges water with an initial velocity of 25 ft/s at an angle of 55° with the vertical. Determine the range of values of the height h for which the water enters the opening BC. The opening begins 20 ft. from the nozzle (i.e. distance to point B) and is 4 ft. wide.

Q: 49. Which of the objects seen above would be the best choice to be completely machined on a lathe?…

A: Given:Find:49) The objects seen above would be the best choice to be completely machined on a…

Q: Question Completion In the figure below, which of the following represents the dedendum? zeta gamma…

A: Circular pitch is the distance measured from a point on one tooth to the corresponding point on the…

Q: Q3: Mark the Following True or False 1. Hidden lines are used in sectioned area when they are needed…

A: 1.TRUE 2. TRUE 3.TRUE 4.FALSE 5. FALSE 6.FALSE 7.TRUE 8.FALSE 9.FALSE 10.FALSE 11.TRUE 12.TRUE…

Q: For the bearing shown below in the figure which of the following represents the bearing bore? For…

A: This question is based on the concept of deep groove ball bearing.

Q: In the FILLET command, when selecting the objects to fillet, holding down the <Shift> key: a.…

A: By holding the <Shift> key before selecting the second object when using a FILLET command, the…

Q: 1.00 1.38 3.38 38 2.00

A: Select the correct statement about the notation circled in green and marked as letter D. Assume all…

Q: Write TRUE is the statement/s is True. If the statement is false, identify the word/s that makes the…

A: The chip compression ratio can be defined as the ratio of the chip thickness and uncut chip…

Q: QUESTION 3 Code for a clockwise circular move to an end point that is 1 inch over in the X direction…

A: consider the following diagram:

Q: Write the NC part program for the part. Holes are threaded and requires two tools; T1 is a 0.5" HSS…

A: I have attached the image belowExplanation:

Q: Determine the skin due to perforation for a vertical well completion scheme described below: Payzone…

A: To Find:the skin factor due to perforation for a vertical well completion scheme.Given:The pay zone…

Q: In the figure below, Which of the following represent the dedendum

A:

Q: A 25 ft long solid steel rod is subjected to a load of 10,000 Ib. This load causes the rod to…

A: Data given -  L = 25 ft = 25 × 12 P = 10000 lb  ∆L = 0.477 in  E = 30 × 106  psi

Q: How many cutting-plane lines are shown on this print?

A: Cutting plane lines:Cutting plane lines are the lines used to show the direction of the cut-way…

Q: 2) Orthogonal Cutting: Consider a person who is shoveling snow from the sidewalk. This person can…

A: To find: The ratio of the force for shovel A to the force for shovel B.Given:Coefficient of friction…

Q: 1. What is the name of the circuit? 2. How many reservoir symbols are shown, and how many reservoirs…

A: As per Bartleby Answering Guidelines we are supposed to give answer first three sub parts of the…

Q: Quenching is a process that can reduce the grain size and form a lot of grain boundaries in the…

A: Quenching: In this process metal is heated above its recrystallization and than cool it rapidly. The…

Slope and Deflection

The slope in a deflected beam is described as an angle in radians made by the tangent of the section with the original axis of the beam. The deflection at any point on the axis of the beam is defined as the lateral displacement of the point before and after loading.