A prospector uses a hand-powered winch to raise a bucket of ore in his mine shaft. The axle of the winch is a steel rod of diameter d = 0.924 inches. Also, the distance from the center of the axle to the center of the lifting rope is b = 5 inches. If the weight of the loaded bucket is W = 80 lb, what is the maximum shear stress in the axle due to torsion in psi? Note Round up final answer to whole number

Q: What is the maximum torsional stress in a 0.9 inch metal shaft with an applied torque of 18 k-in?…

A:

Q: 17.6 A solid steel shaft 3 in. in diameter and 4 ft long is fixed at one end and free at the other,…

A: Given data  Diameter of shaft =3 in  Length of shaft = 4 ft  Axial tensile force = 50000 Lb

Q: A beam has a cross-section that is 11inches tall and 4inches wide. If the max shear in the beam is…

A: Given Load 8 kipsDepth 11 inWidth 4 inTo find out Maximum shear stress

Q: At a point on a steel part of landing gear (E = 200 GPa, v = 0.3, Oy = 225 MPa) subjected to a plane…

A: Given Data: 60 degree Strain rosette  εa=1200×10-6εb=-650×10-6εc=550×10-6E=200GPaμ=0.3σy=225 MPa

Q: The stresses shown act at a point on the free surface of a machine component. Normal and shear…

A:

Q: Consider the rig set up in the figure above. This shows a force being applied to a hollow square…

A:

Q: One shaft is in torsion as shown below. If the magnitude of shear stress at point A is 245.3 MPa,…

A: Given: Magnitude of shear stress at point AζA=245.3 MPa. From the figure, Distance of point A from…

Q: 1) A box beam has the following dimensions: h = 500 mm, b = 180 mm, and t = 22 mm. If the yield…

A: An object stops being elastic when subjected to a particular amount of stress and there is no longer…

Members with compression and bending

Compression members are structural elements that carry compressive axial force. They are the vertical members of a building that support beams and their design, which is governed by buckling and strength. Columns are known as struct or compression members, which are subjected to compressive forces. These members provide stiffness to the building and avoid any imperfection regarding the transfer of axial load. For instance, webs in a truss, braces in a framed structure, tiers, and so on.