A pressure-vessel is fabricated by gluing the circular plate to the end of the vessel as shown in figure below. If the vessel sustains an internal pressure of 0.45 MPa, determine the average shear stress in the glue and the state of stress in the wall of the vessel.

Q: 3 MPa. Which of the following describes the stress state? A body is subjected to the following…

A: in question stress in various plane is given:  question is asking about stress state: given: SIGMAxx…

Q: A punch of 20 mm diameter is used to punch a hole in 8 mm thick plate. If the force required to…

A: Here, We need to calculate the average shear stress on the plate. diameter = 20 mm thickness = 8 mm…

Q: At an axial load of 25 kN, a 45-mm-wide by 20-mm-thick polyimide polymer bar elongates 2.9 mm while…

A: Axial load (P) = 25 KN = 25 × 103 N Elongation in bar (∆L) = 2.9 mm Change in width (∆b) = 0.19 mm…

Q: At a point in elastic medium normal stresses in two mutually perpendicular directions are 120 MPa,…

A: Normal stresses : = 120 MPa = 40 MPaTangential stress = 30 MPaTo Find :Principal stresses ?

Q: 1. Aluminum-alloy cover sheets are bonded to a plastic core to form the sandwich beam whose cross…

A:

Q: The brass shell (ab = 20.9 × 10-6/°C) is fully bonded to the steel core (as = 11.7 × 10-6°C).…

A: Step 1:Step 2:

Q: Q.3: A steel rod with a cross sectional area of 150 mm² is stretched between two fixed points. The…

A: A )  Given data : Cross sectional area of steel rod = 150 mm2 Tensile load at 20oC is = 5000 N α =…

Q: A homogenous isotropic material of size 20 cm x 20 cm x 20 cm is placed inside a rigid box of…

A: Consider the free body diagram;Given;Young modulus, E=Poisson ratio, v=0.3

Q: Determine the following: a. Young's modulus within the linear portion b. Tangent modulus at a stress…

A: a).Young's Modulus : At the proportional limit, stress is directly proportional to strain stress α…

Q: For a given steel cube section subjected to three dimensional state of principal stress. 75 N/mm ☆J…

A: For steel cube,Yield stress=250N/mm2To find the factor of safety according to maximum strain energy…

Q: A homogenous isotropic material of size 20 cm x 20 cm x 20 cm is placed inside a rigid box of…

A:

Material Properties

Construction in civil engineering demands high strength, durability, and longevity. These targets can be achieved by better design and analysis, along with the correct choice of materials. Different materials have different properties and hence, they respond and performs differently under the various condition of external loadings. It is therefore a critical task of an engineer to select the right material based on the property that the material is supposed to function in real-time. When speaking about the property, there are different categories of material properties like chemical property, physical property, mechanical property, electrical property, magnetic property, thermal property, etc. These material properties form the basis of material selection in various applications.