A pressure bulkhead is usually placed:

Q: A cylindric shape steel sample was tested by Rockwell hardness test and showed a hardness value 80…

A:

Q: Neoprene material is an example of which of the following families of materials?: Elastomers…

A: This questions are based on the concept of material properties and material science

Q: Aim: To conduct a full kinematic analysis and calculate dynamic reaction forces in a linkage…

A:

Q: A particle travels along the circular path from A to B in 1 s. If it takes 3 s for it to go from A…

A:

Q: The following is a schematic diagram of the Charpy impact tester. Is from the following. At this…

A:

Q: Match the following statements with the term that best describes each statement. (Enter Number ONLY)…

A:

Q: Why would engineers use Vickers Hardness testing (HV) over Brinell Testing for hardened tool steel…

A: Hardness is the property of the material that can be understand as the resistance to scratch and…

Q: You work for an off-shore wind turbine manufacturer and have been asked to review data from the…

A: Given data:The critical tensile stress must be 30 % more than the service stress of 420 MPa…

Q: three: Three commonly used tests to measure the hardness related properties of materials are:…

A: Hardness is basically resistance offer by material to plastic deformation.

Q: Most metallic materials with crystal structure display a sharp decline in impact energy when tested…

A: B.C.C is Body Centered Cubic crystal structure in which one atom is at centre of unit cell and…

Q: Consider the graph below for 3 test samples A, B and C of the same metal composition which have been…

A:

Q: The ball is kicked from point A with the initial velocity VẠ = 10 m/s. Determine the range R, and…

A: A reaction force opposes an action force by acting in the opposite direction. During sliding,…

Q: Consider the graph below for 3 test samples A, B and C of the same metal composition which have been…

A:

Q: A technician measured the hardness of the steel bar two times. For the first time, he measured the…

A: (a) No, hardness will be changed in both the cases.

Q: What term describes a numerical value that can be applied to a dimensional constraint in a technical…

A: Variation process arranging approach is some of the time called an information recovery strategy.…

Q: You work for an off-shore wind turbine manufacturer and have been asked to review data from the…

A: Given data:The critical tensile stress must be 30 % more than the service stress of 420 MPa…

Q: What are the different types of hardness test? Write a detailed note on each type.

A: Hardness is the ability of the material to resist scratch or indentation. Hardness is also defined…

Q: Explain the following with appropriate examples (at least 2 examples) 1. Grubler's criterion. 2.…

A: The Grubler's criterion gives the number of degrees of freedom of a mechanism involving links and…

Q: Name some mechanical testing methods?

A: There are many types of test are there to determine the different types of mechanical properties. To…

Forming and Shaping

Metal forming is a category of metalworking process through which the material can be given the desired shape and size by subjecting it to plastic deformation, where the component undergoes bulk deformation process upon application of loads. Unlike the shearing and machining process, the material does not undergo up to a failure point as indicated in the stress-strain curve. Hence, the stresses induced during the forming process are greater than yield strength but less than the failure strength of the material. The process does not lead to the loss of material, so it can be said to be an economical process. During forming, the material is subjected to tensile forces, compressive forces, bending, and shearing loading conditions. The material should possess the property of ductility to undergo the forming process.