A PMMC instrument has a three-resistor Ayrton shunt connected across it to make an ammeter as in Figure 2. The resistance values are R1 = 4.52, R2=0.452 and R3= 0.052. The meter has Rm = 1k2 and If3.d = 50µA. Calculate the three ranges of the ammeter. [10.05mA, 100.05mA, 1.005A] Rm=1kn R. R, Selector Figure 2 to

Q: Given the zener voltage at 9V and the zener power at 1W, what is the range of allowable values of Iz…

A: Given data, Zener voltage VZ=9 V Zener power Pz=1 W

Q: Sketch the Current through through cach Zenner diode 7v+ "Δ 1042 www 3v 5K2 Sve #2.5v

A: Zenor diode

Q: If the line voltage in the figure is increased, ideally +5 V output Please choose one: a. increase…

A: The given circuit has the regulated power supply. Here, the voltage regulator maintains the constant…

Q: Problem Solving A platinum resistance thermometer has a resistance at 0 °c of 100 Q and forms one…

A:

Q: Problem 4 Plot ix versus √x using the 0,7V model for the diodes. ix ¿x Vx (a) √x 1ke D ✓ it 1ksz W…

A: We need to plot graph between voltage and current for given circuits .

Q: A Si solar cell has a short-circuit current of 100 mA and an open-circuit voltage of 0.8 V under…

A: The short-circuit current The open-circuit voltage The fill-factor

Q: 1. Determine whether each silicon diode in Figure 1 is forward-biased or reverse-biased. a) b) c) d)…

A:

Q: hat should I do when I get a current like 0.263187845A, should I round into the simplest form, or…

A: Give a current value and asked to rewrite it in different forms.

Power Measurement

According to Blondel's theorem, the total power is measured with one less number of wattmeters than the number of wires present in the system. So, a single-phase and two-wire system will require one wattmeter and a single-phase and the three-wire system will require two wattmeters, and a three-phase and the three-wire system will also require two wattmeters and a three-phase and the four-wire system will require three wattmeter devices. The wattmeter is a device that measures power using one voltage and one current input as shown in the above figure. Multiple current or voltage input pair cables are used by many power analyzers and digital storage oscilloscopes (DSOs) for measuring watts, in effect within a single instrument acting as multiple wattmeters. It is possible to measure three-phase and four-wire power with one correctly specified power analyzer.