A plate receives a jet of water (p = 1000 kg / m3) which it distributes symmetrically. The plate has a mass of 756 kg and is supported by the tips shown in the figure. Determine the force exerted by the jet on each tip and the instantaneous acceleration the plate would experience if the tips were abruptly removed. 0.4 m/s 500 mm

A plate receives a jet of water (p = 1000 kg / m3) which it distributes symmetrically. The plate has a mass of 756 kg and is supported by the tips shown in the figure. Determine the force exerted by the jet on each tip and the instantaneous acceleration the plate would experience if the tips were abruptly removed. 0.4 m/s 500 mm

Elements Of Electromagnetics

7th Edition

ISBN:9780190698614

Author:Sadiku, Matthew N. O.

Publisher:Sadiku, Matthew N. O.

ChapterMA: Math Assessment

Section: Chapter Questions

Problem 1.1MA

See similar textbooks

Similar questions

A hiker throws a stone from the upper edge of a vertical cliff. The stone's initial velocity is 25.0 m/s directed at 40.0° with the face of the cliff, as shown in the figure. Cliff 40.0⁰ 25.0 m/s Ground The stone hits the ground 3.75 s after being thrown. How far from the foot of the cliff does the stone land? Ignore air friction and express your answer in meters.
(2) Total force of 18 N is applied to 6 kg body. This force causes body to move from the state of rest. Find the change in momentum of the body during 3rd second considering tìme is measured from the start of the motion. (a) 6 kg-m/s (b) 9 kg m/s (c) 18 kg-m/s (d) 24 kg-m/s
my brain is overheating because of this question pls help
A vertical take-off and landing aircraft has a mass of 9000 kg. A constant upward thrust of 100 kN is applied to it. Determine the vertical distance it will travel when it reaches the velocity of 10 m/s. Clearly write down here what principle or law you use in this problem. Draw FBD of the aircraft here.
Prob6 conveyor belt discharges gravel into a barge as shown at a rate of 40 m³/min. If the gravel specific weight 18860 N/m³ 120 lbf, what is the tension in the hawser that secures the barge to the dock? Conveyor belt F-10 ft/s Hawser, Dock Gravel Barge Gravel 20⁰ +
The crane shown in the figure is lifting a 389-kg crate upward with an acceleration of 3.79 m/s². The cable from the crate passes over a solid cylindrical pulley at the top of the boom. The pulley has a mass of 108 kg. The cable is then wound onto a hollow cylindrical drum that is mounted on the deck of the crane. The mass of the drum is 190 kg, and its radius (the same as that of the pulley) is 0.449 m. The engine applies a counterclockwise torque to the drum in order to wind up the cable. What is the magnitude of this torque? Ignore the mass of the cable. Number i Units Pulley- Drum Boom
Help with this practice question
A jet strikes a stationery curved vane without shock and is deflected 150° from its original direction. The discharge from the jet is 0.68kg/s and the velocity is 24m/s. Assume that there is no reduction of relative velocity due to friction and determine the magnitude and direction of the
A water jet with velocity of 15 m/sec leaving the 10 cm diameter nozzle strike to the plate in normal direction. Upon impact with the plate, the water is equally divided into two parts, i.e. one half leaves at 60° with respect to horizontal and the other half in a straight vertical direction. The density of water is 1000 kg/m3. Find the velocity at outlet neglecting change in elevation between inlet and outlet, gravity and friction between water and plate. Show your control volume
In the figure below, the tank containing the water is very large and open to the air, and the pipe through which the water drains is very small. The pipe is not open to the air and the water can be treated as an ideal fluid. Find the speed at which the water is traveling in the pipe.
3 liter per 26 sec is discharged from nozzle to impact 60°target if the distance between nozzle and target equal four times a nozzle's diameter and the diameter for nozzle equal 1cm depend on this information to answer following questions: 1. determine the velocity at nozzle 2. determine the impact force 3. if we change the target to hemispherical, determine the ration between two forces
A block of mass m slides on a horizontal rough surface head on into a spring of spring constant k = 730 N/m, as shown in Figure. When the block is x = 0.8 meter away from the spring, it has a velocity v = 4.33 m/s. When the block stops, it has compressed the spring by 6.5 cm. The coefficient of kinetic friction between the block and the surface is 0.1. What is the block's mass m (in kg)? Provide your answer with 2 decimal places. Take g = 9.81 m/s2 V