A pitot tube is installed in a pipe (ID= 0.6m) where air is flowing at 66°F. Manometer reading is 0.11m of H20 and a static pressure measurement at the position of the pitot tube reads 0.205 m H20 above atmospheric. Calculate the following: a) maximum velocity, in m/s, and b) volumetric flowrate, in m³/s.

Q: Pressure in the inner tube of a bike tire is 118 psi. Change this pressure to atm. O A. 8.03 atm B.…

A: Answer: A. 8.03 atm

Q: Air at atmospheric pressure flows across a staggered tube bank consisting of 8 rows of tubes in the…

A:

Q: A 4 inch Sched 40 steel pipe carries crude oil at 80°C. The crude oil has a dynamic viscosity of 1.2…

A: Given: 4 inch Schedule 40 steel pipe dynamic viscosity μ =1.2 x 10-2 Pa·s density ρ= 680 kg/m3

Q: K()" where K=0.05 Pa.sº.. It A non-Newtonian fluid is modelled by the equation of r = K ( flows…

A: Given, Diameter of pipe = 6 mm i.e R = 0.003 m

Q: 5. A Pitot tube in the pipe in which air is flowing is connected to a manometer containing water as…

A: Given that- Manometer difference in water level, x=87.5 mm= 0.0875m Tube coefficient, CP=0.90…

Q: The value of the maximum velocity of a fluid flowing inside a circular pile has a value of O A.…

A:

Q: 2. Air at 50°C and essentially atmospheric pressure is flowing through a 10 cm x 10 cm rectangular…

A: Given that- Length of duct, L=50 m Average velocity, vavg=10 m/s Wall temperature, Ts=250C…

Q: air h, h, water

A: Given Density of water ρw =1000 kg/m3 h1 = 60 cm h = 45 cm h2 = 180 cm Find-Difference of…

Q: Q3) Water flows through a 10-mm diameter pipe at a flow rate of 1.33×104 m³/s. Find (a) Velocity (V)…

A: As water is flowing through the pipe with a flow rate of Q. Reynold's number is the dimensionless…

Q: 17. Calculate the pressure at point A in Fig. 2.50. The slope of the tube is 4 horizontal to 1…

A: Reservoir review is given.Calculate pressure at point A.

Q: A centrifugal exhauster is takin in dry air from a room where the temperature is 60 °F and the…

A: Simple figure for above question Z=1ft pressure change=1.2 in of water Find Temperature of air in…

Q: For the water flow at 20 °C, use the manometer measurement to estimate the (a) centerline velocity…

A:

Q: The initial free fall of water from a faucet can be thought of as an inviscid flow because friction…

A: Given: The distance between points 1 and 2 is 7 cm i.e. z1 - z2 = 7 cm or 0.07 m The diameter of…

Q: Air (y = 0.075 lbf ft3) is flowing as in figure. If u = 13.9 ft s and the centerline velocity, vc =…

A: Given : Density of air = 0.075 lbf / ft3 Velocity ( V1 ) = 13.9 ft / sec Velocity ( V2 ) = 15.7 ft /…

Q: A 10-cm inner diameter pipe has air flowing through it at 50 m/s at 30°C and 1.6 bar (gauge)…

A: Given velocity of air at pipe inlet ,v1=50m/s diameter of pipe at inlet = 10 cm=0.1 m gauge pressure…

Q: Water is flowing inside the pipe shown in the sketch below. A Venturi meter equipped with a…

A: Given thatdp =12 cmdt = 6 cmh =4.5 cm

Q: 4.36. A steady-flow water power plant has the following inlet and outlet conditions: Pressure, psig…

A: Given data for steady flow water plant are as follows:   Inlet Outlet Pressure, psig 0 0…

Q: Chapter 5: Water (density is 1000 kg/m) is in the cylindrical tank. When the valve at B is 1)…

A: In fluid mechanics, according to Swiss mathematician and physicist Daniel Bernoulli, the total fluid…

Q: Q1: Air flows in a pipe 10 mm diameter and 120 cm length at 0.25 MPa and 25 °C. if the exit pressure…

A:

Q: For the vertical pipe with manometer attached, as shown in Fig. 2-19, find the pressure in the oil…

A:

Q: Show illustration of a large, open cylindrical tank is 18ft deep having a radius of 7ft is layered…

A: This is a problem of fluid statics and comprises of three materials:   Mercury Water Oil We will…

Q: Water at 20°C flows in a cylindrical pipe with internal diameter of 2 cm. At what critical fluid…

A:

Q: 4. (20 points) Water (25°C) flows at 4.5 gpm (gpm is gallons per minute) in the system shown below.…

A: a) flow rates will be same along the pipe assuming no change in density.   1 gpm =0.00006309 m3/s…

Q: 3.36 Determine v the velocity V in the pipe if the fluid in the pipe of Fig. 3.15 is: (a)…

A: “Since you have posted a question with multiple sub parts, we will provide the solution only to the…

Q: Q.2. Air flows steadily adiabatically through a pipe with a cross-sectional area of 0.002 m?. At the…

A:

Q: velocity distribution of the fluid,

A:

Q: parallel piping hor. plane. pipe consists of two pipelines, i.e. Pipe 1 and Pipe 2. Pipe 1 is 60 m…

A: As per Bernoulli's equation applied between points A and B,PAγ+VA22g+ZA=PBγ+VB22g+ZB+hL1Neglecting…

Q: A pitot-static tube measures the total pressure pr and the local pressure p in a uniform flow in a…

A: Given : a) Total pressure Local pressure Diameter of the pipe

Q: Water -Bo C CC14 D 2B.9 Analysis of a capillary flow meter. Determine the rate of flow (in lb/hr)…

A: Diameter of the capillary = 0.01 in Density of the manometric fluid, CCl4 = 1.594 g/cm3

Q: onsider the steady flow of water at 70 °F through the piping system shown below whe oution at…

A: Basis of calculation  The problem can be solved by using the following concepts:  • Equation of…

Q: Two mercury manometers, one open-end and the other sealed-end, are attached to an air duct. The…

A: Given data:For sealed end manometer ,The reading(h) on the sealed-end manometer is 789 mm. For open…

Q: A jet of water flows from a 4-in diameter nozzle such that the velocity at point 1, the top of the…

A: Given Data; Steady Flow Diameter of Nozzle; D1 = 4 inches=0.1016 m Diameter of Pipe; D2= 6 inches=…

Q: True or false: Osmotic pressure can be explained by the difference in fugacities

A: It is to be mentioned whether fugacity difference explains the osmotic pressure or not.

Q: The pressure drop in a 6-in. pipe (I.D. = 6.065 in.) of length L is 1 psi with the flow in the…

A: The objective of the question is to find the pressure drop in a 3-in. pipe when the same liquid…

Q: Here's an interesting one. Consider a sled .. a rocket cart which is used to study acceleration and…

A: Select a moving Control volume surrounding the scoop and sled select a stationary reference…

Q: 2) Both ends of the nozzle with an inlet cross-sectional area of lx10-S ft² and an outlet cross-…

A: In fluid mechanics, Bernoulli's theorem is described as the total mechanical energy of the flowing…