A piston ring of outer diameter 1.5354in and inner diameter of 1.496in is placed in a ring gage of DIA 1.537. The in-clearance width measured at the gap of the piston ring in 0.0159in. Calculate the corrected in-clearance if the piston ring is placed in a ring gage of DIA 1.5354in.

Q: At one point in a pipeline the water's speed is 3.00 m/sand the gauge pressure is 5.00×10^4 Pa a)…

A:

Q: Using the diagram, determine the maximum diameter for DIA B.

A:

Q: readings from the vernier scales shown below. note (H and J are metric)

A:

Q: cm; pressure = 0.7 mmHg Liquid sample: density = 4 ml; time of flow = 4.5 seconds Ans. the ff…

A:

Q: The area information is given as following. A,=338.6mm A=338.6mm A=233.5mm A-170.2mm A-255.2mm…

A:

Q: Build the following part. Report the volume in in^3. Assume all dimensions are in inches. Hint: Do…

A: It is asked to find the volume of the model based on the given dimensions

Q: Find Ixx and Iyy of lamina in given figure;

A: Given Section To find Moment of inertia about X axis Moment of inertia about Y axis

Q: 3. A pump discharges 126 liters per second of brine (sp.gr.1.20). The pump inlet, 304.8 mm diameter,…

A: Given: The volume flow rate of brine, Q = 126 liters/s = 0.126 m^3/s The specific gravity of brine,…

Q: Fluid of specific gravity 0.83 flows in a 238 mm diameter pipe. Find the critical velocity in m/s.…

A:

Q: Build the following part. Report the volume in mm^3. Assume all dimensions are in mm. A=52 B=19 Your…

A: Given : To find : Volume of the body

Q: Line AB 100 mm long is 30° and 45° inclined to HP & VP respectively. End A is 10 mm above HP and…

A:

Q: The three-wire thread measuring formula for inch-based threads is: 1.5155 M = D+ 3G - N Where: G =…

A: Solution: Given Data:

Q: from pulley A is running a compressor. The belt tensions for pulley A are 1500 N and 600 N. The…

A:

Q: For laminar flow conditions, what size of pipe, in mm, will deliver 5.42 L/s of oil having kinematic…

A: The size of pipe: d = 565.65 mm.

Q: 1. Determine the reading on the vernier scale as indicated by the arrows.

A: According to scale Main scale reading = 41 mm Least count = 1/20= 0.05 mm Vernier scale = 5*0.05=…

Q: Build the following part. Report the volume in mm^3. Assume all dimensions are in mm. A = 65 B = 43

A:

Q: 70 40* 1.10 m 2.00 m 1.25 m

A: (a) The center of gravity of the beam will be at the center of the beam which is shown below –

Q: Two parallel surfaces move relative to each other are separated by a gap of 0.375 in. The gap is…

A: Given Data: Two parallel surfaces having a gap dy=0.375 in Viscosity of Fluid μ=0.00431 lb-secin2…