Answered: A piston has applied Force of 30 N and…

A piston has applied Force of 30 N and an area of 9. A connected piston has an area of 0.8. What is the force on the second piston

Glencoe Physics: Principles and Problems, Student Edition

1st Edition

ISBN:9780078807213

Author:Paul W. Zitzewitz

Publisher:Paul W. Zitzewitz

Chapter13: State Of Matter

Section13.3: Fluids At Rest And In Motion

Problem 28PP

See similar textbooks

Similar questions

A container of water has a cross-sectional area of A=0.1m2 . A piston sits top of the water (see be following figure). There is a spout located 0.15 m from the bottom of tank, open to the atmosphere, and a stream of water exits the spout. The cross sectional area of the spat is As=7.0104m2 . (a) What is the velocity of the water as it leaves the spout? (b) If the opening of the spout is located 1.5 m above the grand, how far from be pout does water hit the floor? Ignore friction and dissipative forces.
(a) A 75.0-kg man floats in freshwater with 3.00% of his volume above water when his lungs are empty, and 5.00% of his volume above water when his lungs are full. Calculate the volume of air he inhales—called his lung capacity—in liters. (b) Does this lung volume seem reasonable?
An airplane has a mass M, and the two wings have a total area A. During level flight, the pressure on the lower wing surface is P1. Determine the pressure P2 on the upper wing surface.
The inside volume of a house is equivalent to that of a rectangular solid 13.0 m wide by 200 m long by 2.75 m high. The house is heated by a forced air gas heater. The main uptake air duct of heater is 0.300 m in diameter. What is the average speed of the duct if it carries a volume equal to that of the house’s interior every 15 minutes?
(a) As blood passes through the capillary bed in an organ, the capillaries join to form venules (small veins). If the blood speed increases by a factor of 4.00 and the total cross-sectional area of the venules is 10.0 cm2, what is the total cross-sectional area of the capillaries feeding these venules? (b) How many capillaries are involved if their average diameter is 10.0 m?
Bird bones have air pockets in them to reduce their weight—this also gives them an average density significantly less than that of the bones of other animals. Suppose an ornithologist weighs a bird bone in air and in water and finds its mass is 45.0 g and its apparent mass when submerged is 3.60 g (the bone is watertight). (a) What mass of water is displaced? (b) What is the volume of the bone? (c) What is its average density?
A small statue is recovered in an archaeological dig. Its weight is measured to be 96 lb, and its volume 0.08 ft3. (a) What is the statue's weight density? (b) What substance is it?
You are pumping up a bicycle tire with a hand pump, the piston of which has a 2.00-cm radius. (a) What force in newtons must you exert to create a pressure of 6.90105 Pa (b) What is unreasonable about this (a) result? (c) Which premises are unreasonable or inconsistent?
What fraction of an iceberg floating in the ocean is above sea level? Assume the density of the iceberg is 917 kg/m3.
. A certain part of an aircraft engine has a volume of 1.3 Ft3, (a) Find the weight of the piece when it is made of iron. (b) If the same piece is made of aluminum, what is its weight? Determine how much weight is saved by using aluminum instead of iron.
Refer to Problem 16 and Figure P14.16. A hydrometer is to be constructed with a cylindrical floating rod. Nine fiduciary marks are to be placed along the rod to indicate densities of 0.98 g/cm3, 1.00 g/cm3, 1.02 g/cm3, 1.01 g/cm3, 1.14 g/cm3. The row of marks is to start 0.200 cm from the top end of the rod and end 1.80 cm from the top end. (a) What is the required length of the rod? (b) What must be its average density? (c) Should the marks be equally spaced? Explain your answer.
Let AI represent the density of aluminum and Fe that of iron. Kind the radius of a solid aluminum sphere that balances a solid iron sphere of radius rFe on an equal-arm balance.