A piece of iron rebar on a construction site measures 2 cm in diameter and is 3m long. What electrical resistance do you expect this to have? The electrical conductivity of rebar is 1.0299x10² Q-¹m-¹ A. 9.27 x 10-4 Ω B. 7.87 x 10-3 C. 8.65 x 10-²0 D. 1.13 x 10-¹ Below is a chart showing how a real battery voltage changes in time. How much current flows through a 1 k resistor when the battery has been discharging for 120 minutes? (Pick the closest approximation.) 13V- 12V- 1.1V- midpoint voltage (1.18 Vets) end of discharge (127 minutes Cell Voltage (Volts) NH 0.9V- 60 120 Time (minutes) Figure 2. Single Cell 300mA Discharge Curve. A. 1.1 MA B. 3.0 mA C. 0.75 mA D. 0.50 mA 140

A piece of iron rebar on a construction site measures 2 cm in diameter and is 3m long. What electrical resistance do you expect this to have? The electrical conductivity of rebar is 1.0299x10² Q-¹m-¹ A. 9.27 x 10-4 Ω B. 7.87 x 10-3 C. 8.65 x 10-²0 D. 1.13 x 10-¹ Below is a chart showing how a real battery voltage changes in time. How much current flows through a 1 k resistor when the battery has been discharging for 120 minutes? (Pick the closest approximation.) 13V- 12V- 1.1V- midpoint voltage (1.18 Vets) end of discharge (127 minutes Cell Voltage (Volts) NH 0.9V- 60 120 Time (minutes) Figure 2. Single Cell 300mA Discharge Curve. A. 1.1 MA B. 3.0 mA C. 0.75 mA D. 0.50 mA 140

College Physics

11th Edition

ISBN:9781305952300

Author:Raymond A. Serway, Chris Vuille

Publisher:Raymond A. Serway, Chris Vuille

Chapter1: Units, Trigonometry. And Vectors

Section: Chapter Questions

Problem 1CQ: Estimate the order of magnitude of the length, in meters, of each of the following; (a) a mouse, (b)...

See similar textbooks

Similar questions

A 1 m long electrically conductive wire made of material X has electrical conductivity of 0.2x107(ohm-m)-1, and end-to-end resistance of 10 ohms. What is the diameter of the wire? 0.15 mm 0.20 mm 0.25 mm 0.30 mm
Question Completion Status: QUESTION 1 What happens to the amount of current running through a circuit if you increase the RESISTANCE of the circuit? Oa. decreases Ob. none of these OC. no change Od.jncreases QUESTION 2 You are looking at two batteries, the first has a voltage of 1.5 volts while the second has a voltage of 24 volts. Which battery will supply a greater current flow when connected to a 4 ohm resistor? a. O volt battery Ob. 24 volt battery Oc. 1.5 volt battery Od. None of these QUESTION 3 What is the current travelling through a 25.5 ohm resistor if there is a 9 volt battery connected to it? a. 0.343 amps b.2.833 amps OC. 4 amps d. 230 amps Click Save and Submit to save and submit. Click Save All Answers to save all answers.
1. What current flows through a 0.50 mm diameter rod of silver that is 80.0 cm long, when 12 V is applied to it? Resistance of silver rod = Ω Current flowing through the rod of silver = A Resistivity p (ohm m) Material Silver 1.59 x 10-8 Соpper 1.68 x10-8 Copper, annealed 1.72 x10-8 Aluminum 2.65 x10-8 Tungsten 5.6 x10-8 Iron 9.71 x10-8 Platinum 10.6 x10-8 Manganin 48.2 x10-8 Lead 22 x10-8
Which of the following expression(s) represents the electrical energy stored by a capacitor? O A. QV/2 O B. CV²/2 O C. Q/2C O D. CV/2 E. Q²/2C
9. Four resistors R₁=7.00 2, R₂=11.0 2, R3=10.0 2, and R4=8.00 2 are mounted as shown in the figure. The voltage of the battery is V = 22 Volts. What is the current in the R₂ resistor? Amps -www- R₁ R₂ -www- R3 -www- R4
Drift King. A 14-gauge copper wire (diameter of 1.63 mm) carries a current of 2.64 A. The free-electron density of copper is 8.50×1028 m-3. What is the drift velocity of the electrons in the wire? A. 9.30 x 10-5 m/s C. 9.30 × 10–11 m/s B. 2.33 x 10-5 m/s D. 2.33 x 10-1 m/s
A certain person will experience a mild electric shock when the current between two fingers exceeds 72uA. If. The resistance between their thumb and index finger is measured to be 215ohms, how much voltage can be applied before they feel a mild shock? a. 15.5uV b. 33.5uV c. 29.9uV d. 29.9V e.15.5V
Instructions Show You are given a solid gold cube of side length 1.0 cm and asked to fabricate a uniform wire that has a total resistance of 0.048 12. If all the gold must be used, the length of the wire is equal to [Pold-2.44 100m) 1 cm. a. 0.71 m O b. 2.0 m c. 14 m d. 200 m e. 1.4 m Save Answer -1=?
One electron has a charge of 1.60 x 10^-19 C. A current of 2.47 A flows in an electric circuit. How many electrons are flowing past a point in the circuit every second? A. 1.54 x 10^19 electrons B. 1.54 x 20^20 electrons C. 1.45 x 10^20 electrons D. 1.45 x 10^19 electrons
A wire of resistivity ρ must be replaced in a circuit by a wire of the same material but 4 times as long. If, however, the resistance of the new wire is to be the same as the resistance of the original wire, the diameter of the new wire must be A. 1/4 the diameter of the original wire. B. 1/2 the diameter of the original wire. C. the same as the diameter of the original wire. D. 4 times the diameter of the original wire. E. 2 times the diameter of the original wire
1. Consider a cylindrical wire that has conduction electron density 6.0 x 1028 and radius 0.5 mm. An electric field with strength 1 m3 7.5 x 10-4 creates a current of 4.8 × 10" electrons per second. a) What is the average drift speed for an electron? (include units) b) What is the average time in between electron collisions? fs (express your answer in femtoseconds)
A copper wire has a resistance of 0.020 02. What would be the resistance of another copper wire that has three times the length and one-half the radius? (See the diagram below.) a. 0.16 Q b.0.24 Q c. 0.20 0 d. 0.08 Q O e. 0.12 Q -Radius of Wire -Area of Wire