A path in a digital circuit-switched nw has a data rate of 1Mbps, the exchange of 10000 bits is required for the setup and teardown phases The distance between two parbes is 3000 km Answer the following questions if the propagation speed is 2x10 ms. 1. what is the total delay if 1000 bits of data are changed during the data transfer phase 2 What is the total delay if 1000000 bits of data are exchanged dunng the data transfer phase. 3.What is the total delay if 1000000 bits of data are exchanged during the dats transfer phase? 4. Find the delay per 1000 bits of data for each of the above cases and compare them what can you infor?

A path in a digital circuit-switched nw has a data rate of 1Mbps, the exchange of 10000 bits is required for the setup and teardown phases The distance between two parbes is 3000 km Answer the following questions if the propagation speed is 2x10 ms. 1. what is the total delay if 1000 bits of data are changed during the data transfer phase 2 What is the total delay if 1000000 bits of data are exchanged dunng the data transfer phase. 3.What is the total delay if 1000000 bits of data are exchanged during the dats transfer phase? 4. Find the delay per 1000 bits of data for each of the above cases and compare them what can you infor?

Database System Concepts

7th Edition

ISBN:9780078022159

Author:Abraham Silberschatz Professor, Henry F. Korth, S. Sudarshan

Publisher:Abraham Silberschatz Professor, Henry F. Korth, S. Sudarshan

Chapter1: Introduction

Section: Chapter Questions

Problem 1PE

See similar textbooks

Similar questions

Digital- to analog conversion is the process of changing one of the characteristics of signal (carrier signal) based on the information in no carrier. (a) Analog, Digital (b) Digital, Analog (c) Analog, Analog (d) Digital, Digital
How many bytes of data can be transferred in 10 seconds via a serial link in asynchronous mode with a baud rate of 2800 and three parity bits and two stop bits in the frame?
Using dB, sketch the output SNR (Signal-to-Noise Ratio) of a decoded linear PCM signal against the received SNR for a PCM signal, for 4-, 8- and 16-bit PCM. On your sketch clearly indicate the noise limited and quantisation limited regions. Calculate the numerical values of the quantisation limited output SNR for the 4-, 8- and 16-bit PCM curves.
The output signal from a conventional AM modulator isu(t)= 4 cos(3600pi t) + 24 cos(4000pi t) + 4 cos(4400pi t)1. Determine the modulated signal m(t) and the carrier c(t).2. Determine the modulation index.3. Determine the power in the sidebands and the power of the carrier.
PPM modulation can be generated from PAM signal O False True
Explain M-ary. Explain the relationship between bits per second and baud for a QPSK system
Calculate the time of one horizontal scanning line for frames repeated at 25 Hz with 625 lines per frame.
The transmission impairment that refers to a signal with high energy in a very short time is Impulse Noise why?
Determine each output signal and draw the constellation diagram: 1. 8-PSK TX Inputs: 000-111 Carrier: -cos ut Phase shifter: -90 deg
in a 4 bit adc if 0001 is 0.3125 volt then 1110 is
Define Asserted signals.
I need the answer as soon as possible