A parallel-plate capacitor has plates with an area of 420 cm² and an air-filled gap between the plates that is 2.30 mm thick. The capacitor is charged by a battery to 550 V and then is disconnected from the battery. Part A How much energy is stored in the capacitor? U = Submit Part B U = Submit Part C || ΑΣΦ 6 The separation between the plates is now increased to 4.40 mm. How much energy is stored in the capacitor nov W = Request Answer Submit 1971 ΑΣΦ Request Answer GREY IVE ΑΣΦ Request Answer ? How much work is required to increase the separation of the plates from 2.30 mm to 4.40 mm ? S ? HJ ? HJ HJ

A parallel-plate capacitor has plates with an area of 420 cm² and an air-filled gap between the plates that is 2.30 mm thick. The capacitor is charged by a battery to 550 V and then is disconnected from the battery. Part A How much energy is stored in the capacitor? U = Submit Part B U = Submit Part C || ΑΣΦ 6 The separation between the plates is now increased to 4.40 mm. How much energy is stored in the capacitor nov W = Request Answer Submit 1971 ΑΣΦ Request Answer GREY IVE ΑΣΦ Request Answer ? How much work is required to increase the separation of the plates from 2.30 mm to 4.40 mm ? S ? HJ ? HJ HJ

College Physics

11th Edition

ISBN:9781305952300

Author:Raymond A. Serway, Chris Vuille

Publisher:Raymond A. Serway, Chris Vuille

Chapter1: Units, Trigonometry. And Vectors

Section: Chapter Questions

Problem 1CQ: Estimate the order of magnitude of the length, in meters, of each of the following; (a) a mouse, (b)...

See similar textbooks

Related questions

Q: Capacitors C₁ = 5.0 μF and C₂ = 2.0 μF are charged as a parallel combination across a 170 V battery.…

Q: Consider the charged capacitor below, that is not connected to anything. The capacitor has vacuum…

A: Energy stored in the capacitor is given by: U=12Q2C where Q is the charge between the plates C is…

Q: Six uncharged capacitors with equal capacitances are combined in parallel. The combination is…

Q: A 10 μF parallel-plate capacitor is connected to a 22.0 V battery. After the capacitor is fully…

Q: A 2.6-cm-diameter parallel-plate capacitor has a 1.8 mm spacing. The electric field strength inside…

Q: Abel is pulling a cart, but he's pulling on a handle that causes his force to be applied to the cart…

Q: Part B Part C How much energy would be stored in the capacitor network if the capacitors were all in…

Q: A 2.4 nF parallel-plate capacitor has an air gap between its plates. Its capacitance increases by…

Q: In the figure (Figure 1), let C₁ = 3.00uF, C₂ = 5.00μF, C3-7.00μF, and V-12.0V. What is the…

A: capacitive circuit

Q: Consider the combination of capacitors shown in the diagram, where C₁ = 3.00 μF, C₂ = 11.0 μF, C3 =…

Q: The capacitors of C₁ = 2 µF and C₂ = 3 µF are each fully charged with potential difference of 30 V.…

A: C1= 2µF C2= 3µF Potential difference is =30 V

Q: A dielectric-filled parallel-plate capacitor has plate area A = 30.0 cm² plate separation d = 10.0…

A: “Since you have posted a question with multiple sub-parts, we will solve the first three sub-parts…

Q: Suppose two parallel-plate capacitors have the same charge Q, but the area of capacitor 1 is A and…

A: Dear student, Since both questions are different, as per guidelines we can author only first one…

Q: A 14.0-V battery is connected to a 4.20-μF capacitor. How much energy is stored in the capacitor?

A: We know thatU=12CV2WhereU=Energy stored in capacitorC=Capacitance of capacitorV=Potential difference

Q: 1. A parallel-plate capacitor has square plates that have a length equal to 1.2 cm separated by 1.2…

A: Square plate length = 1.2 cm = 0.012 mPotential difference (V) = 10 VRequired:The energy stored in…

Q: Two initially uncharged capacitors, of capacitance C and 2C, are connected in series across a…

Q: A parallel-plate capacitor is made from two aluminum-foil sheets, each 4.00 cm wide and 15.0 m long.…

Q: An object rolls off a 17.0-m high cliff with a speed of 4.50 m/s. a. The time for the coconut to…

A: Given data: Height =17.0m Speed =4.50 m/s The projectile motion of the ball is,

Q: A, B,&C

Q: In (Figure 1), each capacitor has C = 4.90 µF and Vab = 34.0 V. Part H Calculate the potential…

Q: A capacitor is constructed out of a pair of perfectly aligned rectangular metal plates with a small…

A: Initially the plates of a capacitor are filled with air. Dielectric constant for air is K = 1 Now,…

Q: Three capacitors are connected as shown below. C₁ = C₂ = C3 = 32 F. The voltage across the battery…

A: Given capacitance of capacitorsC 1= C2 =32 F

Q: Consider the figure below. 0.300 µF (a) Find the charge stored on each capacitor in the figure shown…

A: The capacitors C1 and C2 are in parallel. Determine the equivalent capacitance.

Q: The electric potential along the a-axis is V = 100e 2 V, where a is in meters. You may want to…

A: Recall Ex=-∂V/∂xSo Ex=200e-2x

Q: The capacitors C₁ = 37 µF, C₂ = 148 μF and C3 = 53.5 µF are connected as shown below. What is the…

Q: Consider the combination of capacitors shown in the diagram, where C, 3.00 P.C₂ 11.0 μF C₂3.00 uF.…

A: Given data: Capacitance are grouped as shown .

Q: Can you answer problem 3? Can you also provide a short explanation for the answer you chose?

Q: In (Figure 1), let C₁ = 2.90 μF, C₂ = 5.10 μF, and Vab = +60.0 V. Figure A Vab= V b gra +0. 1 of 1 T…

Q: Two 1.70-cm-diameter disks spaced 2.00 mm apart form a parallel-plate capacitor. The electric field…

Q: An air-filled parallel-plate capacitor has plates of area 2.90 cm² separated by 2.30 mm. The…

Q: Until 1883, every city and town in the United States kept its own local time. Today, travelers reset…

A: Earth's rotation rate is ratio degrees per rotation and time

Q: A 15.0 µF capacitor is charged to a potential difference of 850.0 V. The terminals of the charged…

A: The first capacitor is initially charged to a potential difference of 850 V Let C1=15 μF=15×10-6…

Q: A parallel-plate capacitor filled with air carries a charge Q. The battery is disconnected, and a…

Q: Suppose you have a 9.00 V battery, a 2.4 μF capacitor, and a 8.85 μF capacitor. Part a Find the…

A: Note : According to our guidelines , we are only allowed to answer 3 subparts per question . If you…

Q: In the figure (Figure 1), let V = 80V and C₁ C₂ C3 = 7.0μF. Figure C₁ C2 C3 HH HH 1 of 1 Part A How…

A: C1 = C2 = C3 = 7 μFVoltage (V) = 80 volts

Q: A potential difference of 106 mV exists between the inner and outer surfaces of a cell membrane. The…

A: Work done in terms of Potential difference and charge is given by the formula: W=q×∆Vwhere, q is the…

Concept explainers

Dielectric Constant Of Water

Water constitutes about 70% of earth. Some important distinguishing properties of water are high molar concentration, small dissociation constant and high dielectric constant.

Electrostatic Potential and Capacitance

An electrostatic force is a force caused by stationary electric charges /fields. The electrostatic force is caused by the transfer of electrons in conducting materials. Coulomb’s law determines the amount of force between two stationary, charged particles. The electric force is the force which acts between two stationary charges. It is also called Coulomb force.

Question

A parallel-plate capacitor has plates with an area of 420 cm² and an air-filled
gap between the plates that is 2.30 mm thick. The capacitor is charged by a
battery to 550 V and then is disconnected from the battery.
Part A
How much energy is stored in the capacitor?
U =
Submit
Part B
U =
Submit
Part C
|| ΑΣΦ 6
The separation between the plates is now increased to 4.40 mm. How much energy is stored in the capacitor now?
W =
Request Answer
Submit
1971 ΑΣΦ
Request Answer
GREY
IVE ΑΣΦ
Request Answer
Sw
?
How much work is required to increase the separation of the plates from 2.30 mm to 4.40 mm?
S
?
HJ
?
HJ
HJ

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1: Determine the given data in the step :

VIEW

Step 2: Determine the capacitance in the step :

VIEW

Step 3: Determine the energy stored in the step :

VIEW

Step 4: Determine the modified capacitance in the step :

VIEW

Step 5: Determine the new energy stored in the step :

VIEW

Step 6: Determine the work done in the step :

VIEW

Solution

VIEW

Step by step

Solved in 7 steps with 7 images

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, physics and related others by exploring similar questions and additional content below.

Similar questions

a. What is the equivalent capacitance of the combination shown by usingC1=C2=C3=C4=C5=C6=7 μF? b. Calculate the charge Q stored in the circuit if it connected to 12 V battery in twoopen terminals? c. Calculate the total energy stored in the capacitor?
Two capacitors give an equivalent capacitance of 8.92 pF when connected in parallel and an equivalent capacitance of 1.62 pF when connected in series. What is the capacitance of each capacitor? smaller capacitance! 1.62 Your response differs from the correct answer by more than 10%. Double check your calculations. pF 8.92 larger capacitance Your response differs from the correct answer by more than 10%. Double check your calculations. pF Need Help? Read It
Four capacitors are connected to a battery as shown in the following figure. Find the equivalent capacitance of the system, the charge on each capacitor, and the potential difference across each capacitor. Show your work in detail. Submit your work through Canvas. ONE pdf file only and ONE attempt only! C₁= 3.00 uF C₁= 6.00 μF F C₂= 2.00 μF c 4.00 µF + 90.0 V
Two 1.70-cm-diameter disks spaced 2.00 mm apart form a parallel-plate capacitor. The electric field between the disks is 4.80×105 V/m. You may want to review (Pages 699-702). For help with math skills, you may want to review: Area Calculations for a Circle Mathematical Expressions Involving Squares Part A What is the voltage across the capacitor? Express your answer to two significant figures and include the appropriate units. V = Submit Part B V = HÅ Value Request Answer Submit An electron is launched from the negative plate. It strikes the positive plate at a speed of 2.40x107 m/s. What was the electron's speed as it left the negative plate? Express your answer to two significant figures and include the appropriate units. μA Value Units Request Answer Units By ? ?
please help with B and C.
Three capacitors are connected as shown, where C = 0.045 F. A. Input an expression for the equivalent capacitance between points a and b, in terms of C. B. What is the capacitance, in farads? C. If the capacitors are charged with a ΔV = 10 V source, how much energy will the circuit store, in joules?
Three capacitors, with capacitances C₁ = 4.4 µF, C₂ = 5.3 µF, and C3= 2.5 µF, are connected to a 13 -V voltage source, as shown in the figure. What is the charge on capacitor C₂ ? C₁ a. ΑΣΦ www ? C3 μC
Consider the capacitor below, that is not connected to anything. The capacitor has a dielectric between its plates initially. The dielectric is slowly pulled out from between the plates. As that happens, how will the energy stored in the capacitor change? V1+ C1 O It will increase. O It will decrease. O It will stay the same.
A 5.15 nF parallel-plate capacitor contains 26.0 µJ of stored energy. ▼ Part A What is the potential difference across the capacitor? Express your answer in volts. V = Submit Part B V = ΑΣΦ Submit Request Answer By how many volts would you have to increase this potential difference in order for the capacitor to store 52.0 μJ of potential energy? Express your answer in volts. VG ΑΣΦ ? Request Answer ?
Which of the following statements is true? O A capacitor is charged when connected to a load O Capacitors in series means: CT = C1 + C2 + ... + Cn After inserting the dielectric between the plates, the amount of charge remains the same O After inserting the dielectric between the plates, the amount of capacitance remains the same
For a system of 4 capacitors shown in the figure below: Determine the following:A. The equivalent capacitance of the systemB. The charge on each capacitorC. The potential difference across each capacitorD. The stored energy in each capacitor
A potential difference of 98 mV exists between the inner and outer surfaces of a cell membrane. The inner surface is negative relative to the outer surface. How much work is required to eject a positive sodium ion (Na+) from the interior of the cell? J