A paralel-plate capacitor is constructed using a dielectric material whose dielectric constant is 2.40 and whose dielectric strength is 3.00 x 10" wm. The desired capacitance is 0.100 g, and thecapacitor must withstand a maximum potential difference of 4.00 kv. Find the minimum area of the capacitor plates.Jm²

Introduction The potential difference between two points is the work done to move a charge from one…

A paralel-plate capactor is constructed using a dielectric material whose dielectric constant is 2.40 and whose dielectric strength is 3.00 x 10 m. The desired capacitance is 8.300 p, and the capacitor must withstand a maximum potential difference of 4.00 kV Find the minimum area of the capacitor plates

A paralel-plate capactor is constructed using a dielectric material whose dielectric constant is 2.40 and whose dielectric strength is 3.00 x 10 m. The desired capacitance is 8.300 p, and the capacitor must withstand a maximum potential difference of 4.00 kV Find the minimum area of the capacitor plates

Delmar's Standard Textbook Of Electricity

7th Edition

ISBN:9781337900348

Author:Stephen L. Herman

Publisher:Stephen L. Herman

Chapter19: Capacitors

Section: Chapter Questions

Problem 3RQ: A capacitor uses air as a dielectric and has a capacitance of 3 F. A dielectric material is inserted...

See similar textbooks

Related questions

Q: As discussed in your reading material, the MAIN reason for calculating a capacitance value is to…

A: (i) The main reason for calculating capacitance value is to improve power factor (ii) Most…

Q: сараcitors

A: Capacitance in parallelCeq=C1+C2+...... Capacitance in series-1/Ceq=1/C1+1/C2+......

Q: Through a capacitor of capacitance 15 micro-farad with a frequency of 50 hz. Compute its reactance

Q: equivalent

A: Here,

Q: A capacitor made of 130 plates in parallel is separated by a 0.0297 m thick of insulator with a…

Q: A 100uf capacitor and a3.6kohm are connected in series. How long will it take for the capacitor to…

Q: A capacitor with a capacitance of 3.6360426666667E-10 pF is a parallel plate capacitor. Each plate…

Q: A parallel plate capacitor has an electrode area of 100 mm², with spacing of 0.1 mm between the…

A: Given that E=100 VA=100 mm2d=0.1 mmε0=8.85×10-12 F/m

Q: -43.7 V Time Time 10 0 13 H 0.05 F

A: The given RLC circuit is shown below: (a) The RMC voltage of the circuit is calculated as shown…

Q: Determine the equivalent capacitance at terminal A and B

Q: The current through an inductor is always the voltage across it by. A leading, 90 B leading, -90 C…

A: In this question we will find current angle in inductor and capacitor.....

Q: 2 pF T Cl 7 pF JC₂ 5pP G S LOUF = Gy

Q: By convention, the sign of reactive power to an inductance is and the sign of reactive power to a…

Q: In a given parallel plate capacitor with a capacitance of "C" Farad, if the distance between the…

A: We know formula for parallel plate capacitance .

Q: 2. Find the equivalent capacitance. Assume all capacitors are 1F. Cea

Q: 80 12 40 H a 50 12 30 10 bo 60 20

A: To determine an equivalent capacitance in uF of the circuit given below:

Q: The reactance of an inductor is 550 ohm and the frequency of input ac is 50 Hz. What will be the…

A: If XL represents the reactance of an inductor and if f represents the frequency of the input ac,…

Q: The capacitance of a capacitor is not affected by A. Distance between plates B. Area of plates C.…

A: The capacitance of a parallel plate capacitor is expressed as: C=εAd Where, ε is permittivity of…

Q: MAKE ONE ORIGINAL WORDED PROBLEM WITH DIAGRAM AND ITS FREE BODY DIAGRAM FOR CAPACITANCE IN SERIES…

A: It is given that: MAKE ONE ORIGINAL WORDED PROBLEM WITH DIAGRAM AND ITS FREE BODY DIAGRAM FOR…

Q: The plates of a parallel-plate capacitor are square and have the length of one side. 20 cm and the…

Q: C3 Vin \oov AC Cr Vin Vat lout /calculate Vout and explain the following circait. ALl capacitor…

A: According to the question, for the figure shown below We need to calculate the energy stored in…

Q: The capacitor dissipation factor is the ratio of o inductive reactance to its resistance O…

A: Capacitor is an electrical component used to store electrical energy in the form of charge. It…

Q: 3. Use Boolean algebra to simplify the expression: Z = AB + ABC + ABC

A: The boolean expression,

Q: What is the capacitance of a parallel-plate capacitor having rectangular plates 10 cm by 20 cm…

A: In this question We need to determine the capacitance If the parallel-plate capacitor having…

Q: 1 Ohm 6 Ohm 2 Ohm 10sin628t

A: What is the voltage falling on the capacitor in the circuit shown in the figure?

Q: For the given circuit, the value of capacitor is in mF. So that the system will be critically damped…

A: Given- Circuit is given, Resistance R=40 ohm, Inductance = 4 H, To Find- The value of the capacitor…

Q: Assume all capacitors = 10 µF. Find total capacitance %3D C4 Ans. 4.0 µF

A: Given data: C=10 μF

Q: A certain parallel-plate capacitor has plate length of 2 cm and width of 3 cm. The dielectric has a…

A: Given values are =

Q: What capacitance should be connected in series with 12 µF capacitor if the equivalent capacitance is…

A: If two capacitors C1 and C2 are connected in series than equivalent capacitance is C1×C2C1+C2 Given…

Q: Equivalent capacitance across terminal AB

A: Given circuit- To find- Equivalent capacitance at terminal AB.

Q: A 470- uF capacitor is connected in series with a 120-k2 resistor. How long will it take the…

Q: What is the equivalent resistance ?? and what is the total inductance ??

A: Resistors, inductors and capacitors form an integral part of any electrical circuit. A source,…

Q: In MEMS the ratio between the forces of parallel plate and the forces of interdigitated capacitors…

A: It is asked to determine the ratio between the forces of parallel plate and the forces of…

Q: In a given parallel plate capacitor with a capacitance of "C" Farad, if the distance between the…

Concept explainers

Capacitor

The capacitor is an element used to store electrical energy in the electrical field. A capacitor is a form of passive energy.

Question

A paralel-plate capacitor is constructed using a dielectric material whose dielectric constant is 2.40 and whose dielectric strength is 3.00 x 10" wm. The desired capacitance is 0.100 g, and the
capacitor must withstand a maximum potential difference of 4.00 kv. Find the minimum area of the capacitor plates.
Jm²

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

This is a popular solution!

SEE SOLUTION Check out a sample Q&A here

Step 1

Step 2

Step 3

Step 4

Trending now

This is a popular solution!

Step by step

Solved in 4 steps

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, electrical-engineering and related others by exploring similar questions and additional content below.

Similar questions

A postage stamp mica capacitor has the following color marks starting at the upper left dot: yellow, violet, brown, green, no color, and blue. What are the capacitance value, tolerance, and voltage rating of this capacitor?
List the five capacitor replacement rules.
What frequency must be applied to a 33-mH inductor to produce an inductive reactance of 99.526 ?
A postage stamp capacitor has the following color marks starting at the upper-left dot: black, orange, orange, black, silver, and white. What are the capacitance value and tolerance of this capacitor?
You are an electrician working in an industrial plant. You discover that the problem with a certain machine is a defective capacitor. The capacitor is connected to a 240-volt AC circuit. The information on the capacitor reveals that it has a capacitance value of 10 mF and a voltage rating of 240 VAC. The only 10-mF AC capacitor in the storeroom is marked with a voltage rating of 350 WVDC. Can this capacitor be used to replace the defective capacitor? Explain your answer.
You find that a 25-F capacitor connected to 480 VAC is defective. The storeroom has no capacitors with a 480-VAC rating. However, you find two capacitors rated at 50 F and 370 VAC. Can these two capacitors be connected in such a manner that they can replace the defective capacitor? If yes, explain how they are connected and why the capacitors will not be damaged by the lower voltage rating. If no, explain why they cannot be used without damaging the capacitor.
You are working in an industrial plant. You have been instructed to double the capacitance connected to a machine. The markings on the capacitor, however, are not visible. The capacitor is connected to 560 volts and an ammeter indicates a current of 6 amperes flowing to the capacitor. What size capacitor should be connected in parallel with the existing capacitor? What is the minimum AC voltage rating of the new capacitor? What is the minimum DC voltage rating of the new capacitor? What is the minimum KVAR size that can be used in this installation?
Capacitive Circuits Fill in all the missing values. Refer to the formulas that follow. XC=12fCC=12fXCf=12CXc Capacitance XC Frequency 38 F 60 Hz 78.8 400 Hz 250 pF 4.5 k 234 F 10 kHZ 240 50 Hz 10 F 36.8 560 nF 2 MHz 15 k 60 Hz 75 nF 560 470 pF 200 kHz 6.8 k 400 Hz 34 F 450
In a pure capacitive circuit, does the current lead or lag the voltage?
4. In what form is the energy of a capacitor stored?
Can current flow through a capacitor?
Two capacitors having values of 80 F and 60 F are connected in series. What is the total capacitance?