Question-6A non-salient pole, three-phase, Y-connected synchronous generator with synchronousreactance of Xs=14.0 delivers active power P = 1.68 MW to the power system at inductivepower factor. The line-to-line voltage is VL-L=11 kV and armature current Ia= 100 A. Find:a. The power factor (cos D).b. The load angle (8).c. The EMF E, induced in the armature winding.*The armature winding resistance is negligible (R= 0).

Power delivered = sqrt(3)* Line to line voltage* armature current* power factor. EMF induced in…

A non-salient pole, three-phase, Y-connected synchronous generator with synchronous reactance of Xs= 14.Q delivers active power P = 1.68 MW to the power system at inductive power factor. The line-to-line voltage is Vi-L=11 kV and armature current Ia= 100 A. Find: a. The power factor (cos D). b. The load angle (8). c. The EMF E, induced in the armature winding. *The armature winding resistance is negligible (R= 0).

A non-salient pole, three-phase, Y-connected synchronous generator with synchronous reactance of Xs= 14.Q delivers active power P = 1.68 MW to the power system at inductive power factor. The line-to-line voltage is Vi-L=11 kV and armature current Ia= 100 A. Find: a. The power factor (cos D). b. The load angle (8). c. The EMF E, induced in the armature winding. *The armature winding resistance is negligible (R= 0).

Introductory Circuit Analysis (13th Edition)

13th Edition

ISBN:9780133923605

Author:Robert L. Boylestad

Publisher:Robert L. Boylestad

Chapter1: Introduction

Section: Chapter Questions

Problem 1P: Visit your local library (at school or home) and describe the extent to which it provides literature...

See similar textbooks

Similar questions

The commercial efficiency of shunt generator is maximum when its constant loss equal . . loss * Choose ( Constant or Variable )
The information of a three-phase synchronous generator is shown as follows: rated capacity is Sy = 20kV. A, rated voltage is UN = 400V and rated power factor is cosoN = 0. 8 (lag). Find the ra- ted current IN, rated active power output PNand reactive power output QN of the generator.
A synchronous generator supplies rated power at 0.8 pf lagging.ra = 0.015p. u., andxl 1p.u. . Find out the possible terminal voltage. In case of the practical operation, which terminal voltage is more feasible? =
Draw the phasor diagrams for the following values of the power coefficient, ignoring the armature winding resistance of a 3-phase, star- connected, dislocated-pole synchronous generator. a) 0.8 inductive b)0.8 capacitive c) 1 omic
A 3-phase, 50 Hz, 16 pole generator with concentrated windings has 144 slots with 10 conductors per slot. The flux/pole of 24.8 mWb is sinusoidally distributed. The coil is full pitched. Find the line emf.
Three identical steam-turbine generators G1, G2, and G3 are operating in parallel. Each generator is: 7.2 KV, 24 MVA, 50 Hz, 0.85 PF lagging, 4-poles, Y-connected, with synchronous reactance of 2 Q and an armature resistance of 0.05 Q. Each of generators G1 , G2 , and G3 has a characteristic power-frequency slope of 4.2 MW/Hz , 4.5 MW/Hz, and 5.0 MW/Hz, respectively The no-load frequency of each generator is set to 52.4 Hz. The load increases with no changes in the settings of the no-load frequencies, until a generator reaches its maximum rated power first. At what system frequency does this limit occur? Select one: O a. fsys = 49.2 Hz O b. None O c. fsys = 48.9 Hz O d. fsys = 48.32 Hz Clear my choice
Discuss about generator modeling and drive the formula for the real and reactive power supply it .
Question (0) 5.39. The induced emf in a separately excited generator is 135 V at no load, while terminal voltage at full load is 115. What is its voltage regulation?
Draw a complete circuit diagram of 1 phase synchronous alternator including the field excitation circuit. Then, draw the phasor diagram of the generator a general leading power factor. Include the phase resistance in the diagram.
Solve it clearly please with clearly steps