A new water supply system was installed in a southern state. Part of the system was a large outdoor holding tank placed in the ground near a farm field. Shortly after installation, unacceptable levels of contamination were found. An investigation revealed that the contamination was caused by dead rats decaying in the holding tank. The problem statement that went out was find a way to keep the rats out of the tank. Prepare a Duncker diagram to analyze this situation.Please answer very soon will give rating surely

A new water supply system was installed in a southern state. Part of the system was a large outdoor holding tank placed in the ground near a farm field. Shortly after installation, unacceptable levels of contamination were found. An investigation revealed that the contamination was caused by dead rats decaying in the holding tank. The problem statement that went out was find a way to keep the rats out of the tank. Prepare a Duncker diagram to analyze this situation.Please answer very soon will give rating surely

Engineering Fundamentals: An Introduction to Engineering (MindTap Course List)

5th Edition

ISBN:9781305084766

Author:Saeed Moaveni

Publisher:Saeed Moaveni

Chapter3: Introduction To Engineering Design

Section: Chapter Questions

Problem 27P

See similar textbooks

Similar questions

Hello, I hope you are well. I was told to resubmit the question, but this is the full question. I do not understand how to solve part a and removed part b. I hope you can help. Thank you very much.
Complete Answer, please. Thank you :)
Table Q1-1 shows the list of the constituents of the treated water in a water treatment facilities prior to discharge. Based on the National Standard for Drinking Water Quality (NSDWQ), state the maximum acceptable value for each of the parameter. Provide a conventional treatment for each of the parameter if the current treatment is inadequate. Table Q1-1 Water Constituents After Treatment Value (mg/litre (unless otherwise stated)) 65.5 NTU 115 TCU Parameter Turbidity Colour Manganese 0.5 BOD 26.8 Arsenic 0.005 Hardness 560
Your organization has been hired to provide a water treatment process or device toremove toxic Chromium 6 [Cr(VI)] from water emanating from an underground source.Your organization has developed a treatment process that removes most of the Cr(VI)from the water to a residual concentration of 0.05 mg/L which is an acceptable level inline with the World Health Organisation. The underground water flows at 40 m3/h andhas Cr(VI) concentration of 100mg/L. The effluent flow rate is 97% of the influent flowrate, and the remainder of the water is discharged as wastewater. Calculate theconcentration of Cr(VI) in wastewater.
Question 1: You have been assigned to design primary clarifiers for a wastewater treatment plant. The average flow rate of the wastewater is 256000 m3/day with a BOD5 of 120 mg/L and suspended solids concentration of 300 mg/L. The goal is to remove 35% BOD5 and 60% suspended solids in primary treatment. Determine the following: 1) The diameter of the primary clarifier for a surface overflow rate of 50 m3/m2-day.2) The detention time in the primary clarifier and the mass of solids removed in kg/day.Assume a depth of 4m.
From these results, using the water quaility assesment, can you determine if the water is safe or not?
7
Please answer clearly
Describe recuperation test for an open well.
Can you please help me with the homework problem
Please answer clearly
Wasterwater Engineering Civil engineering