A negative-feedback amplifier has a closed-loop gain of 200 V/V and an open-loopgain of 104 V/V.What is the feedback factor? If a manufacturing error results in a reduction of open-loop gain to 103 VIN, what closed-loop gain results? What is the percentage change inclosed-loop gain corresponding to this factor of 10 reduction in open-loop gain?

Answered: Image /qna-images/answer/aeecfc90-2014-4bbd-9e12-a6a0a24e79ca.jpg

A negative-feedback amplifier has a closed-loop gain of 200 V/V and an open-loop gain of 104 V/V. What is the feedback factor? If a manufacturing error results in a reduction of open- loop gain to 103 V/V, what closed-loop gain results? What is the percentage change in closed-loop gain corresponding to this factor of 10 reduction in open-loop gain?

A negative-feedback amplifier has a closed-loop gain of 200 V/V and an open-loop gain of 104 V/V. What is the feedback factor? If a manufacturing error results in a reduction of open- loop gain to 103 V/V, what closed-loop gain results? What is the percentage change in closed-loop gain corresponding to this factor of 10 reduction in open-loop gain?

Introductory Circuit Analysis (13th Edition)

13th Edition

ISBN:9780133923605

Author:Robert L. Boylestad

Publisher:Robert L. Boylestad

Chapter1: Introduction

Section: Chapter Questions

Problem 1P: Visit your local library (at school or home) and describe the extent to which it provides literature...

See similar textbooks

Similar questions

4. The circuit uses current- (or shunt-) feedback bias. The Si transistor has ICEO = 0, VCEsat =0, and B= 100. If RC = 2k and VCC =12V, size RF for ideal maximum symmetrical swing (that is, location of the quiescent point such that VCEQ =VCC/2). +V cc RC Cc Rs RL VL Cc R. R
(A) Draw and clearly label the circuit diagram of an op-amp configured as a practical inverting differentiator circuit. (B) For the op-amp in part (A), explain how the DC-offset volatge is reduced at the output? (C) Calculate the feedback resistance Rf and the input reistance R, in a practical diffrentiator if fo =1 kHz and a high-frequency gain of 15 is required. Choose a capacitor of 1µF.
Design a feedback amplifier corresponding to the block diagram shown below. The amplifier (A) must be a multistage-cascaded common source with a minimum number of stages. Draw the circuit and then analyze the feedback amplifier to find A, B, AVf, and Rif Is A o Vo If
A negative feedback closed loop system gain, y(t) /r(t) ), of at least 7.5 is needed with a ß = 0.1. a. What is the minimum value of the forward gain, 4, that will allow this? b. What is the loop gain for this system?
Find the desired values below in the feedback amplifier circuit in the figure. a) Voltage and current in amplifier circuit when Rf resistor is open circuit and RL resistor is present Show step-by-step the formula that gives the profit. b) Step of the formula showing the feedback current gain Ai when the Rf feedback resistor is connected find step.
1. A unity feedback system is characterized by an open loop transfer function The system will have a damping factor of 0.55. For this value determine the natural frequency of the system. It is subjected to a unity step input. Also obtain all the time specifications.
When negative voltage feedback is applied to an amplifier of gain 200, the overall gain falls to 100. Calculate (i) the fraction of the output voltage fedback. (ii) If this fraction is maintained, calculate the value of the amplifier gain required if the overall stage gain is to be 75.
Consider the series-shunt feedback amplifier of Figure below. Assume that the voltage divider (R1, R2) is implemented with a 1-MN potentiometer. Assume that the MOSFET is %3D biased so that gm = 4 mA/V and r, is large. Also, Rp = 10 kN. VDD Find the value of R1 that results in a closed-loop gain of 5 V/V. Rp R2 R
Given the four statements, which of the following statements are not true about the operation of an op-amp? i. Op-amp's close loop operation employs negative feedback that takes portion of the output and applies it back out of phase with the input. 1i. In an op-amp, amplification of the common input signals is much less than that of the opposite input signals. iii. In open-loop operation, the output of the op-amp is driven to saturation with Vo- +Vsat. iv. Op-amp's close loop operation employs positive feedback that takes portion of the output and applies it back out of phase with the input. O i, iii, iv O i, iv O i i, ii O i, iv
An amplifier has open loop gain of 10, and input impedance of 1 kQ and output impedance of 100 Q. If negative feedback with feedback factor of 0.99 is connected to the amplifier in a voltage series feedback mode. The new input and output impedance are.
Collector-feedback bias Please select one: a. based on the principle of positive feedback b. not very stable c. based on the principle of negative feedback d. based on beta multiplication