A mixture of He and N2 gas is contained in a tube at 298 K and 101.32 kPa total pressure. At one point the partial pressure of He is pA1=60.79 kPa and at a point 0.25 m distance away, pA2=20.26 kPa. If the total pressure is constant throughout the tube, calculate the flux of He at steady state if DAB of the He-N2 mixture is 0.687x10-4 m2/s

Q: b.The molar heal capacity of white tin (Sn(whie) Varies with temperalure as follows: T/K 20 30 40 60…

A: Given that,

Q: (a) The graph on the right illustrates the behaviour of 1 mol each of two pV/ Pa m3 CO2 different…

A: PV=nRT  This is the ideal gas equation. In which P is pressure, V is volume , n is number of moles ,…

Q: Estimate the activity coefficient of aluminum at 750k when found at 60% composition in an Al-Zn…

A:

Q: Calculate the solubility at 25 °C of PbCrO4 in pure water and in a 0.0190 M Na₂CrO4 solution. You'll…

A:

Q: You have analyzed an aqueous ammonia solution and find that it contains 30 wt% NH 3.(a) to determine…

A: a.

Q: Calculate the persistency (S) of VX at  25oC ,VX: MW= 267.38; Po = 0.0007 torr @ 25oC

A:

Q: From the general balance equation, write the balance expression for a continuous system, at ste…

A: Continuous systems are those types of systems in which  the outlet and inlet signals are same at…

Q: A ruptured line in a water treatment system resulted in a 20 L tank of water being contaminated with…

A: The solution is given in step 2.

Q: 2. Determine the degree of freedom for the following systems: a) An aqueous solution of KCl at 101.3…

A: Degree of freedom, f= c-p+2-rc= number of componentsp= number of phases presentr= number of…

Q: At 101.3 kPa and 250K, Toluene vapour and Neon mixture is processed. The mixture contains Toluene…

A: Given : Vapour pressure of mixture(toluene + Neon gas) = 101.3 kPa Vapour pressure of toluene = 16…

Q: In a chemical laboratory located on the fourth floor of a heavily populated several bottles of…

A: Given chemicals are nitric acid, methyl ethyl ketone and a petroleum derivative. (i) We know that…

Q: What quantity in moles of chlorine gas at 120.0 °C and 33.3 atm would occupy a vessel of 12.0 L?

A:

Q: One mole of benzene is mixed with two moles of toluene. At 60 °C the vapour pressures of benzene and…

A: Vapour pressure of pure benzene at 60 °C = 51.3 kPa   Vapour pressure of pure toluene at 60 °C =…

Q: A solution contains 1.1 mg of Cu2+ per 0.50 kg solution. Calculate the concentration in ppm.  Enter…

A: ppm concentration used for such Solutions, in which mass of Solute very less as compared to total…

Q: 5H.2 - Estimate the mean ionic activity coefficient for the ions in an aqueous solution at 25°C that…

A: mean ionic activity coefficient= 0.918

Q: Select the closed system that contains the lowest molar concentration of gas dissolved in water at…

A: We know that  higher the value of Henry's law constant Kh at a given pressure, the lower is the…

Q: For the equilibrium reaction then calculate degee of dissociation of A. A(g)= B(g) + C(g) + D(g) if…

A: Vapor density:  Vapor density is that the density of vapor in respect to that of gas. it's going to…

Q: OU T Given thermodynamic equation of state ән ӘР, ӘТ, P from it and the general relations between…

A: To derive the second thermodynamic equation of state from the first thermodynamic equation of state.…

Q: In an experimental study of membrane-like assemblies of synthetic materials, a phase diagram like…

A: First, consider At point a, the mixture is in liquid form. Suppose the liquid mixture reaches the…

Q: L-Serine is an amino acid important for its roles in synthesizing other amino acids and for its use…

A:

Q: From the equivalent conductivities at infinite dilution following at 18°C, find the value of Λ° for…

A: Given: Ba(OH)2 Λ° = 228.8BaCl2 Λ° = 120.3NH4Cl Λ° = 129.8 We have to calculate the value of Λ° for…

Q: Temperature - composition diagram for a two-component A + B system with one eutectic and one…

A: The objective of this question is to show the explaining temperature-composition diagrams and…

Q: Select the closed system that contains the lowest molar concentration of gas dissolved in water at…

A: We know that  higher the value of Henry's law constant Kh at a given pressure, the lower is the…

Q: Find the vapour and liquid phase composition for an air(1)/water(2) system in equilibrium at 25°C…

A: Here given that, Temperature  = 25 °C and  Pressure = 1 atm =101.325 kPa And vapour pressure of…

Q: The interfacial tension y of the interface between mercury and an aqueous solution of an ectrolyte…

A: Given Data:Interfacial tension  at the interface between mercury and an aqueous solution of an…

Q: b. (i) (ii) A given bioreactor supports S. cerevisiae growth with oxygen uptake rates (OUR) of 0.34…

A: (i)Write the mass balance equation for oxygen in the bioreactor under steady-state conditions.The…

Q: please answer part a and part b properly

A: Composition given = 30 wt% Sn and 70 Wt% Pb and 200° C a- Draw a vertical line from 30 wt% Sn and a…

Q: (b) Based on the table above, at 25°C, will calcite dissolve or precipitate? Will dolomite dissolve…

A:

Q: Phase equilibria data for the system water / acetone / trichloroethane phase equilibria data for the…

A:

Q: Q2) Sulfur dioxide (A) diffuses through a stagnant layer of air (B) of 2 cm thickness at 45°C and…

A: Hi  аnd  thаnks  fоr  the  questiоn.  Sinсe  yоu  hаve  роsted  а  questiоn  with  multiрle…

Q: Please help me match the correct items

A: As the temperature is increased from point f, liquid L1 becomes more concentrated in water and L2…

Q: Consider the following system at equilibrium where AH° = 87.9 kJ, and K. = 1.20×102, at 500 K: %3D…

A: From the thermodynamical data, it is cleared that the reaction is endothermic and the chemical…

Q: P (kPa) X1 y1 85.265 82.202 0.0579 0.0253 76.719 0.1665 0.0804 72.422 0.2482 0.1314 68.005 0.3322…

A:

Q: For each experiment what should be the Molarity of HCI ? What kind of indicator will you use?

A: The equation showing the neutralization reaction between HCl and NaOH is-   Thus, at equivalence…

Q: In the leachate pond, carbon, sulphur and nitrogen mostly exist as reducing compounds due to the…

A:

Q: 4.12. For one of the following liquids,determine the heat of vaporization at its normal boiling…

A: Clausius-Clapeyron Equation : lnP1P2=∆HvapR1T2-1T1 where P1 and  P2  are the vapor pressures at two…

Q: The Henvy's law constant for hydrogen in water at 25 Cs7.7 x 10mol dmkPa.Estimate the number of…

A: Hello. Since the question contains multiple parts, the first part is solved. In case the solution…

Q: Imagine that we have a closed system containing pure isobutane that is in a state of vapor-liquid…

A: The correct answer and explaination is given below steps

Q: Q.2. The purification of hydrogen gas by diffusion through a palladium sheet: Compute the number of…

A:

Q: Bromobenzene is immiscible with water. A mixture of bromobenzene and water at 1 atm boils at 95.7°C.…

A: Distillation is the process of separating the components or substances from a liquid mixture by…

Q: Determine the molar solubility (in mol/dm3) of solute A in a binary mixture at 1.32 bar if Henry’s…

A:

Q: A mixture of 87.3 mole % methanol and 12.7 mole % isopropyl alcohol is vaporized at 101.325 kPa…

A:

Q: (a) Based on the tabulated data, prove that the distribution of benzoic acid in water and and…

A: From the data, the ratio of CwaterCbenzene is as follows, Cwater Cbenzene CwaterCbenzene…

Q: Natural Gas will have 95% Methane CH4 4% Ethane CzHo 1% CO₂ assummed composition of: } by volume

A: The density of an ideal gas mixture can be calculated as: ρ=PMavgRT where P is the pressure, Mavg is…

Kinetic-Theory of Gases

Kinetic theory of gases is the model or method which was developed in the 19th century by Maxwell and Boltzmann. This is possible as the interatomic force which is of short-range forces that are important for solids and liquids can be neglected for gases. This theory or gas law gives a molecular interpretation of the pressure and temperature of a gas and is consistent with gas laws and Avogadro’s hypothesis. This theory is very helpful to correctly explain the specific heat capacities of many gases, kinetic energy and it also explains the transport qualities such as viscosity, thermal conductivity, and diffusion with molecular parameters. As stated in the kinetic-molecular theory, the temperature of a substance or gas particle is related to the average kinetic energy of the particles of that substance. When a substance is heated, some of the absorbed energy is stored within the particles, while some of the energy increases the motion of the particles, called average kinetic energy.