A mixture of gases is prepared from 77.7 g of O2 and 19.5 g of H2. After the reaction of O2 and H2 is complete: What is the total pressure of the mixture if its temperature is 138 ºC and its volume is 16.0 L? What are the partial pressures of the gases remaining in the mixture? partial pressure for O2 =____atm partial pressure for H2 =____atm partial pressure for H2O =____atm Total pressure=____atm

A mixture of gases is prepared from 77.7 g of O2 and 19.5 g of H2. After the reaction of O2 and H2 is complete: What is the total pressure of the mixture if its temperature is 138 ºC and its volume is 16.0 L? What are the partial pressures of the gases remaining in the mixture? partial pressure for O2 =atm partial pressure for H2 =atm partial pressure for H2O =atm Total pressure=atm

Chemistry for Engineering Students

4th Edition

ISBN:9781337398909

Author:Lawrence S. Brown, Tom Holme

Publisher:Lawrence S. Brown, Tom Holme

Chapter5: Gases

Section: Chapter Questions

Problem 5.92PAE

See similar textbooks

Similar questions

Consider the following sketch. Each square in bulb A represents a mole of atoms X. Each circle in bulb B represents a mole of atoms Y. The bulbs have the same volume, and the temperature is kept constant. When the valve is opened, atoms of X react with atoms of Y according to the following equation: 2X(g)+Y(g)X2Y(g)The gaseous product is represented as and each represents one mole of product. (a) IfP A=2.0 atm, what is P8 before the valve is opened and the reaction is allowed to occur? What is P A+P B? (b) Redraw the sketch to represent what happens after the valve is opened. (c) What is PA? What is PB? What is P A+P B? Compare your answer with the answer in part (a).
Xenon and fluorine will react to form binary compounds when a mixture of these two gases is heated to 400C in a nickel reaction vessel. A 100.0-mL nickel container is filled with xenon and fluorine, giving partial pressures of 1.24 atm and 10.10 atm, respectively, at a temperature of 25C. The reaction vessel is heated to 400C to cause a reaction to occur and then cooled to a temperature at which F2 is a gas and the xenon fluoride compound produced is a nonvolatile solid. The remaining F2 gas is transferred to another 100.0-mL nickel container, where the pressure of F2 at 25C is 7.62 atm. Assuming all of the xenon has reacted, what is the formula of the product?
You have a 550.-mL tank of gas with a pressure of 1.56 atm at 24 C. You thought the gas was pure carbon monoxide gas, CO, but you later found it was contaminated by small quantities of gaseous CO2 and O2. Analysis shows that the tank pressure is 1.34 atm (at 24 C) if the CO2 is removed. Another experiment shows that 0.0870 g of O2 can be removed chemically. What are the masses of CO and CO2 in the tank, and what is the partial pressure of each of the three gases at 25 C?
105 The decomposition of mercury(II) thiocyanate produces an odd brown snake-like mass that is so unusual the process was once used in fireworks displays. There are actually several reactions that take place when the solid Hg(SCN)2 is ignited: 2Hg(SCN)2(s)2HgS(s)+CS2(s)+C3N4(s)CS2(s)+3O2(g)CO2(g)+2SO2(g)2C3N4(s)3(CN)2(g)+N2(g)HgS(s)+O2(g)Hg(l)+SO2(g) A 42.4-g sample of Hg(SCN)2 is placed into a 2.4-L vessel at 21°C. The vessel also contains air at a pressure of 758 torr. The container is sealed and the mixture is ignited, causing the reaction sequence above to occur. Once the reaction is complete, the container is cooled back to the original temperature of 21°C. (a) Without doing numerical calculations, predict whether the final pressure in the vessel will be greater than, less than, or equal to the initial pressure. Explain your answer. (b) Calculate the final pressure and compare your result with your prediction. (Assume that the mole fraction of O2 in air is 0.21.)
What does “STP’ stand for? What conditions correspond to STP? What is the volume occupied by one mole of an ideal gas at STP
A typical barometric pressure in Redding. California, is about 750 mm Hg. Calculate this pressure in atm and kPa.
93 The complete combustion of octane can be used as a model for the burning of gasoline: 2C8H18+25O216CO2+18H2O Assuming that this equation provides a reasonable model of the actual combustion process, what volume of air at 1.0 atm and 25°C must be taken into an engine to burn 1 gallon of gasoline? (The partial pressure of oxygen in air is 0.21 atm and the density of liquid octane is 0.70 g/mL.)
A cylinder of compressed gas is labeled Composition (mole %): 4.5% H2S, 3.0% CO2, balance N2. The pressure gauge attached to the cylinder reads 46 atm. Calculate the partial pressure of each gas, in atmospheres, in the cylinder.
A halothane-oxygen mixture (C2HBrCIF3 + O2) can be used as an anesthetic. A tank containing such a mixture has the following partial pressures: P (halothane) = 170 mm Hg and P (O2) = 570 mm Hg. (a) What is the ratio of the number of moles of halothane to the number of moles of O2? (b) If the tank contains 160 g of O2, what mass of C2HBrCIF3 is present?
Nitrogen gas is produced not only by NaN3 decomposition, but also in the reaction that captures the sodium by-product. You need to fill a 75 L airbag at 25 °C to a pressure of 3.0 atm. What mass of NaN3 is required? What mass of KNO3 needs to be in the bag to capture the sodium byproduct?
In the Mthode Champenoise, grape juice is fermented in a wine bottle to produce sparkling wine. The reaction is C6H12O6(aq)2C2H5OH(aq)+2CO2(g) Fermentation of 750. mL grape juice (density = 1.0 g/cm3) is allowed to take place in a bottle with a total volume of 825 mL until 12% by volume is ethanol (C2H5OH). Assuming that the CO2 is insoluble in H2O (actually, a wrong assumption), what would be the pressure of CO2 inside the wine bottle at 25C? (The density of ethanol is 0.79 g/cm3.)
94 Mining engineers often have to deal with gases when planning for the excavation of coal. Some of these gases, including methane, can be captured and used as fuel to support the mining operation. For a particular mine, 2.4 g of CH4 is present for every 100.0 g of coal that is extracted. If 45.6% of the methane can be captured and the daily production of the mine is 580 metric tons of coal, how many moles of methane could be obtained per day?