A method for the analysis of Ca2+ in water suffers from an interference in the presence of Zn2+. When the concentration of Ca2+ is 100 times greater than that of Zn2+, an analysis for Ca2+ gives a relative error of +0.5%. What is the selectivity coefficient for this method?

Q: Why does the solubility of a salt of a basic anion increase with decreasing pH? Write chemical…

A: On decreasing the pH of the solution, the concentration of H+ in the solution increases. The…

Q: On a 0.109-mm-diameter column with a 0.813-μm-thick stationary phase, an unretained solute passes…

A: Phase ratio is ratio between volume of the column and thickness of the film coated inside wall of…

Q: Describe the principle and operation of anodic stripping voltammetry (ASV). How does it differ from…

A: Here we have to understand three points 1. Anodic Stripping Voltammetry (ASV) 2.  adsorptive…

Q: Consider the extraction of UO22+ ions from pregnant solution which contains Pb2+, K+, Na+, and Ca2+…

A: A question based on analytical separation that is to be accomplished.

Q: You are a chemist, you know that in the analysis for total hardness, formation of Ca-EDTA complex in…

A:

Q: How can the matrix effects affect the determination of Calcium in seawater by using AAS

A: A question based on analytical process that is to be accomplished.

Q: Use the Debye-Hückel equation to calculate the activity Ion Ion size (a, pm) coefficient (y) for…

A: Given that : According to Debye-Huckel equation : log γi=-0.51×Zi2×μ1+3.28αi×μHere γi=activity…

Q: Calculate the average activity (a±), the average activity coefficient (γ±) and the activity of the…

A:

Q: The potential difference between a potassium ion and saturated calomel electrode immersed in 100.0…

A:

Q: Calculate activity coefficient (y) for Ca2* in a solution of 0.001M Ca(NO3)2 using the Extended…

A: The ionic strength (I) of the species is determined by the formula as follows: I=12∑(CiZi2)   ...(1)…

Q: Fill in the blanks with the following choices:

A: answer -   (a) The precipitation of bulky precipitates (e.g. MgNH4PO4) traps significant amount of…

Q: Find the conditional formation constant for Ca(EDTA)2- at pH 10.00, where log Kf is 10.65 and ay is…

A:

Q: The calibration curve y=0.0218x - 0.0001 for Fe2+ in buffer at 450 nm in a 0.5 cm cuvette. Is Beer's…

A: The calibration curve equation is  y = 0.0218x - 0.0001 at 450 nm in a 0.5 cm cuvette. Path length =…

Q: Construct a titration curve that is expected to be obtained by titration 50.00mL of 0.1000M Sr2+…

A: To plot the titration curve firstly, calculate the equivalence point which is the point at which the…

Q: 4 In the determination of sulphate ion concentration in natural water a turbidimeter was calibrated…

A: A question based on tools in analytical chemistry that is to be accomplished.

Q: The equilibrium constant for the reaction 2CrO,2 + 2H → Cr,0;² + H,O is 4.1x1011. The molar…

A:

Q: At 21 °C, a solution of 12 mL each of 0.00200 M Fe3+ and 0.001000 M SCN- was mixed and brought to…

A: The given reaction is: Fe3+(aq) + SCN-(aq) → Fe(SCN)2+(aq) Here the product, Fe(SCN)2+(aq) is…

Q: Molar absorptivities of Nickel and Cobalt with 8-quinilinol are εCo = 3529 and εNi = 3228 at 365 nm,…

A: Answer is explained below.

Q: (2) A solution is 1.0x104 M in NaF, NazS, and Na3PO4. What would be the order of precipitation as a…

A: Given that  [NaF] = [Na2S] = [Na3PO4] = 1.0*10-4 it means that , concentration of  [F-] = [S2-] =…

Q: A solid mixture weighing 0.515 g contained only ferrous ammonium sulfate and ferrous chloride. The…

A:

Q: The following data are the results of an experiment in which 0.5mL aliquots of invertase solutions…

A: The objective is to determine the correct statement regarding invertase activity.Given:Temperature…

Q: The ionization constant (Ka ) equation of a monoportic weak, HA, acid is given by ca2 K = (1-0) The…

A: The solution is given below -

Q: possible ways in which Cu2+ could sorb to a hematite surface

A: Sorption methods for purifi cation of contaminated natural and wastewater have been fi nding…

Q: A student determined the concentration of total reducible iodine in the aqueous phase based on the…

A: Given: Total reducible iodine in the aqueous phase is 0.0177M. The concentration of I2 in the CH2Cl2…

Q: Calculate the pZn2+ for solutions prepared by adding 0.00, 5.00, 10.00, 15.00, 20.00, 25.00 and…

A: Note - Since you have posted a question with multiple sub-parts, we will solve first three…

Q: 3. After correction for water conductivity, the conductivity of a 2.50 x 104 M aqueous solution of…

A: The reaction taking place is given as, => Mg2+ (aq) + SO42- (aq) -------> MgSO4 (aq) Given:…

Q: A 28.93 mL aliquot of trimethylamine that has a concentration of 0.661 M will be titrated with 0.752…

A:

Q: a) Discuss the possible mechanisms involved in the destabilization of a suspension of mineral…

A: The objective of this question is to show the initial pH of the suspension and the pH of the…

Q: Calculate the pZn of a solution prepared by mixing 25.0 mL of 0.0100 M EDTA with 50.0 mL of 0.00500…

A: Concentration of Zn2+ can be determined as follows: M1V1(Zn2+)=M2V2(EDTA) pZn2+ is determined as…

Q: Measurement of adsorption of 40 mL of solution containing Hg by atomic absorption spectrometer…

A: Measurement of adsorption of 40 mL of solution containing Hg by atomic absorption Spectrometer…

Q: A sample of water from the North Sea was analysed by ion-chromatography and the suifate…

A: On mixing two aqueous solutions, if a solid is separated out then the reaction is termed as…

Q: What is the molar extinction coefficient at 625 nm for this copper (II) acetate solution? How was it…

A: According to Beer Lambert law, the absorbance of any solution is directly proportional to the…

Q: Find the activity coefficient of Cu2+ using the Mean Salt Method. (HINT: Start by solving for the…

A: