A mechanism for pushing small boxes from an assembly line onto a conveyor belt is shown with arm OD and crank CB in their vertical positions. For the configuration shown, crank CB has a constant clockwise angular velocity of 0.97 rad/s. Determine the acceleration a of E (positive if to the right, negative if down). Amechanism for pushing small boxes from an assembly line onto a comveyor belt is shown with arm OD and crank CB in their vertical positions. For the configuration shown, crank CB has a constant clockwise angular velocity of 0.9z rad/s. Determine the acceleration ag of E (positive if to the right, negative if down). 185 mm 375 mm 695 mm 225 mm 60 mm 120 mm 115 185- mm' mm

Q: What about Mohr's circle?

A: In the previous question, Given: The diameter of shaft, d = 20 mm = 0.02 m The maximum bending…

Q: State the difference between the eutectic and eutectoid points.

A: Eutectic point: In the iron carbon phase diagram at 2 percentage of carbon is called eutectic point.…

Q: Describe the Spherical Vessel?

A: A vessel is a closed structure containing liquids or gases under pressure. Familiar examples include…

Q: Consider the shaded area in (Figure 1). Take a 520 mm. Figure 150 mm 150 mm 100 mm 300 mm Determine…

A: The distance a=520 mm

Q: Each cylinder in a four-cylinder car engine has a bore diameter of 63.53 mm and the stroke for each…

A: Consider a vehicle engine where number of cylinder are situated whose bore diameter is D and stroke…

Q: -d12 The figure shows a tabletop experi- nent that can be used to determine an unknown homent of…

A:

Q: Customary units by using the values listed for length and mass as defined values: Bending moment or…

A: As moment bending moment or torque has two variables, force and distance. So, M = F × r…… (1) The SI…

Q: = The cross-section of a wooden, built-up beam is shown below. The dimensions are L w = 20 mm.…

A:

Q: When does a couple of moment work?

A: A couple is when a system of forces has no net force but has a net moment. A couple causes pure…

Q: d W Pm a Ps

A: The free body diagram of the system is showing below –

Q: where do you get the form factor (y=.337) from? Please.

A: Form factor for full depth 20° at 24 teeth can be taken from standard table. I have provided the…

Q: 2 Brass expands more than iron when heated. How would the strip look after prolonged exposure to…

A:

Q: Consider the bracket shown in Fig-3. If: • F1 = 10 lb @ -90° • a = 2 ft •b = 4 ft • c= 1 ft then,…

A: Consider the free body diagram of member AC, Here,

Q: It is observed that the density of an ideal gas increases by 10 percent when compressed isothermally…

A:

Q: 2. Orientation is the general term used to describe the features. O linear O most important…

A: The meaning of orientation in terms of relationship between features is to be chosen from given…

Q: Consider the bracket shown in Fig-3. If: • F1 - 10 lb @ -90° • a- 2 ft • b- 4 ft • c-1 ft then, what…

A:

Q: • F1- 10 lb @ -90° • a- 2 ft • b-4 ft • c-1 ft then, what is the magnitude of the vertical reaction…

A: