A mechanism for pushing small boxes from an assembly line onto a conveyor belt is shown with arm OD and crank CB in their vertical positions. For the configuration shown, crank CB has a constant CW angular velocity of a rad/s. Determine the acceleration of E. 200 mm 400 mm 600 mm 50 mm 200 mm 100 mm 100 200 mm mm

Q: Problem 6 Rod AB is pin connected with the piston rod of the hydraulic cylinder at end A and with…

A: Given: The velocity of slider B, aB = 2 m/s The acceleration of slider, aB = 30 m/s^2 The length of…

Q: • For the four-bar linkage shown, the input angular velocity is w₂ = 20 rad/s CCW and a = 100…

A: •Given: For the four-bar linkage shown, the input angular velocity is w₂ = 20 rad/s CCW and a = 100…

Q: The diagram below shows one of these arrangements. Using vector diagrams, determine by the use of…

A:

Q: 2. The slender bar AB shown is attached to small wheels, which roll on the horizontal and inclined…

A:

Q: At the instant shown in Figure P6, the slider block, C, is moving at a constant speed of 700 mm/s to…

A: Consider the diagram of the given mechanism as shown below. Also,

Q: The elements of a power hacksaw are shown in Figure 2. The saw blade is mounted in a frame that…

A: Given dataN=60rpmθ=90°To find acceleration of the blade & link AB

Q: For the slider-crank mechanism shown, let R=1.9 in., L 6.1 in.. and H-1.2 in. Assuming that WAB-…

A: R = 1.9 in, L  =  6.1 in,  = 27o, =4940 RPMTo determine1. Angular acceleration fo connecting rode…

Q: 300 mm 600 mm A B 800 mm L

A:

Q: For the problem related to Fundamental.5, a sketch of the system showing the respective velocity and…

A: Introduction In this problem, we will compute the linear acceleration of point A, as well as the…

Q: At the instant w-3 rad/s, pulley A is given an angular acceleration a- (0.76) rad/s, where is in…

A: Given data: ωA=3 rad/secα=0.7θ rad/s2

Q: Given: The piston rod of the hydraulic cylinder C imparts a speed to pin A of VA = 4 m/s (upward).…

A:

Q: For the inverted slider-crank linkage in the posture shown, crank 2 has a constant angular velocity…

A: Given:To find:Velocity and acceleration of BAngular velocity and acceleration of link 4

Q: Figure B1 shows an extendable boom mobile crane, typical of the type that was used to construct the…

A: Given: AB=25 mθ=60oaB,r=0.5 m/s2αAB=0.1 rad/s2

Conservation of Energy

In physics, the rule of the conservation of energy states that energy doesn’t disappear from the atmosphere; instead, it changes its form from one type to another. Energy is one of the most important physical quantities in nature, and it cannot be created or destroyed — only transformed.