A mass m = 1.35 kg and spring (with spring constant k = 440 N/m) are placed along a ramp inclined at 0 =22 degrees, as shown in the figure. The mass has been moved down the ramp by a distance Ax= 3.0 cm and this same distance is the amount the spring has been stretched from its relaxed state. What is the minimum static friction coefficient, μg such that the mass will remain stationary (neither moving up nor down the ramp from its position)? Assume that if the friction

A mass m = 1.35 kg and spring (with spring constant k = 440 N/m) are placed along a ramp inclined at 0 =22 degrees, as shown in the figure. The mass has been moved down the ramp by a distance Ax= 3.0 cm and this same distance is the amount the spring has been stretched from its relaxed state. What is the minimum static friction coefficient, μg such that the mass will remain stationary (neither moving up nor down the ramp from its position)? Assume that if the friction

Elements Of Electromagnetics

7th Edition

ISBN:9780190698614

Author:Sadiku, Matthew N. O.

Publisher:Sadiku, Matthew N. O.

ChapterMA: Math Assessment

Section: Chapter Questions

Problem 1.1MA

See similar textbooks

Similar questions

stirrer Problem 3: A vertical piston cylinder arrangement consists of a spring and two stops as shown in following Fig. Piston diameter is 20 cm, and mass is 10 kg. Piston is frictionless and is free to move between the stops (H1=10 cm and H2=20cm). Assume the thickness of piston and stops to be negligible. Spring is linear, with K=20 kN/m and natural length=15 cm. Initially, the piston is held at the upper stop. It contains air at a pressure 200 kPa and 800K. Heat is gradually extracted from the system till the pressure reaches 50 kPa and the piston is situated on the lower stop. Make suitable assumptions and take data for standards constants from reference books/ lecture notes. (a) Find the net work done by the system (b) Find total heat extracted from the system. Assume specific heat to be 0.9 kJ/kg K (c) Draw the complete process on a P-V diagram. Show all pressure and volume values 3/4 H2
A computer is protected against impact by foam packaging (spring stiffness, k = 100 N/cm; mass, m = 11 kg, including packaging). The maximum acceleration that the computer can withstand on impact with a hard surface is 4g. At the maximum acceptable impact acceleration, how much does the packaging compress upon impact? Give the answer in cm. What is the maximum height, h, in cm that the case can fall from without damaging the computer?
A car weighs 150 kilograms with a center mass at G. The horizon force P= 600 newton’s. Please find the normal force of every wheel and the change in velocity. Please draw the free body diagram if necessary. Please refer to illustration. Thank you. G 1.25 m P = 600 N %3D 0.25 m 0.25 m 0.5 m -1.25 m |0.75 m
In the figure, a cube of edge length L = 0.556 m and mass 1200 kg is suspended by a rope in an open tank of liquid of density 1.03E+3 kg/m3. Find (a) the magnitude of the total downward force on the top of the cube from the liquid and the atmosphere, assuming atmospheric pressure is 1.00 atm, (b) the magnitude of the total upward force on the bottom of the cube, and (c) the tension in the rope. (d) Calculate the magnitude of the buoyant force on the cube using Archimede's principle. %3D L/2
A block of mass m = 1.7 kg is dropped from height h = 70 cm onto a spring of spring constant k = 1830 N/m. Find the maximum distance the spring is compressed. m m
Example A can having a mass 0.5 kg is pushed a lot a slot by a rotating arm. A portion of the slot is in the form of a spiral defined by the equation r = (0.10) m where is measured in radians. The arm rotates at a rate à = 4 rad/s. Determine the force of the arm on the can. Neglect friction and the size of the can. Aalto University r = 0.10 6 = 4 rad/s
Which spring, the truncated cone spring or the helical spring, would have a larger spring constant? Explain.
There is a box with height 1.2 m, width 0.8 m and mass 50 kg. It contains a very expensive equipment, which cannot be tilted while moving. There is a rope connected to the top-right corner of the box that you can pull with. The static friction coefficient between the floor and the box is 0.4. Assuming the rope angle θ is 30 degrees and m/s2. a) Is it possible to move the box using the rope without tilting the box? (need to show details) b) What is the minimum force required to move the box on the floor?
-1m 1) A block of mass M is dropped from rest on the spring as shown in the figure. The spring compresses a maximum of 25 cm. Calculate the speed of the block when the compression of the spring is 15 cm. (M = 5 kg, h=1 m, k = 1000 N / m) -Aumu-
A mass of 9kg compresses a spring with spring constant 400 N/m in a vertical position for 2 meters and latched. The mass will reach . m if the latch is released. (Assume g = 10 m/s2) Yanıt:
Read the question carefully before answering. Show complete solution with proper derivatives/ integral, and units. Box or indicate your final answers. If not stated, ure g = 9.51 m 2 5² 3. A platform supported by 4 parallel springs : 2 long and 2 short springs. have a spring of 1.30 kN/m and 10.95 kN/m. A 35 kg box is dropped onto it from a peight of 15 m. Find the compression of each spring if the short springs are of m shorter than the long springs.
3. Consider a hot-air balloon with fixed volume VB = 1.1 m³. The mass of the balloon envelope, whose volume is to be neglected in comparison to VB, is m̟ = 0.187 kg. The balloon shall be started, where the external air temperature is T1 = 20°C and the normal %3D