QuestionA manganin swamp resistance is connected in serieswith a moving coil ammeter consisting of a milli-ammeter and suitable shunt in order toABDminimise the effect of temperaturevariationobtain large deflecting torquereduce the size of the meterminimize the effect of stray magneticfields

Answered: A manganin swamp resistance is…

A manganin swamp resistance is connected in series with a moving coil ammeter consisting of a milli- ammeter and suitable shunt in order to

Power System Analysis and Design (MindTap Course List)

6th Edition

ISBN:9781305632134

Author:J. Duncan Glover, Thomas Overbye, Mulukutla S. Sarma

Publisher:J. Duncan Glover, Thomas Overbye, Mulukutla S. Sarma

Chapter3: Power Transformers

Section: Chapter Questions

Problem 3.9MCQ: Match the following: (i) Hysteresis loss (a) Can be redud by constructing the core with laminated...

See similar textbooks

Related questions

Q: 3. Two batteries A and B are connected in parallel and load of 10 N is connected across their…

A: First Assume any random directions for loop currents If solution has positive value then it will be…

Q: 3. Two circuit elements in series consume 60 VAR when connected to a 120 – V, 60 – Hz source. If the…

A: Total supply voltage = 120 V. pf is 0.6 . Input VAR = 60. Input watt = 60/tan(x). So watt = 60/tan…

Q: Capacitors are used after the converter toA. smooth out the DC current.B. suppress the noise.C.…

A: A converter is used to convert the input AC voltage into DC voltage. The capacitor is used after the…

Q: What are the types of semicondoctors available

A: The objective of the question is to identify and describe the different types of semiconductors…

Q: Determine the DC currents (1s. Ic and le) and dc junction voltages (VBE, VCE and Vca) In-Blank 1 mA,…

A: Given, VBB = 3 VRB = 5 kΩRC = 232 ΩVcc = 18 VβDC = 65

Q: converter topologies in pv system

A: It is asked to discuss about the converter topologies in PV system.

Q: Explain the differece between continous and discountinous current mode of convetrer operation

A: There are basically two modes of converter operations 1) Continuous Converter Operation the current…

Q: Problem 5. Find the range of parameters g and r in which the circuits below are stable: a) о b) gVc…

Q: A second order control system has a damping ratio as 0.6 and natural frequency of oscillations as 11…

A: Given- 2nd order control system- Damping ratio=0.6, Natural frequency ωn=11 rad/sec, To Find- The…

Q: In volt ampere characteristics the current increases with voltage a. Equally b. Sinusoidal c.…

A: The volt ampere characteristics is the characteristics between voltage and current of a diode.

Q: 7- DC-DC converters can be classified depending on the flow direction of current and voltage.…

Q: What is the accurate LVDT output voltage when the core is at the centre position? a. 5.22V b. 2.5V…

A: Given: LVDT

Q: 3. The secondary voltage can rise above its rated value when the load is a. resistive. b.…

A: We are authorized to answer one question at a time, since you have not mentioned which question you…

Q: • If properly biased JFET acts as A. Current controlled current source, B. Voltage controlled…

A: A JFET is a voltage controlled three terminal device. This device is available in n channel and p…

Q: what is the use of DC/DC tension converter DC/DC booster MT3608

A: Types of mostly used DC DC Converter Step up Converter ( Boost converter) Step Down Converter (…

Q: For figure (1)draw and calculate the voltages waveform across each half of secondary winding and…

A: The figure shows a full wave rectifier circuit using two diodes D1 and D2. The supply voltage is…

Q: In single phase fully controlled converter, if the form factor is 2.75 then the ripple factor of the…

A: We know relationship between ripple factor and form factor , from that formula we will find out…

Q: Determine the DC currents (Ig, Ic and lĘ) and dc junction voltages (VBE, VCE and VCB) IB=Blank 1 mA,…

Q: -p.m lap-wound dc series ge voltage 220 V and the pow

A: Q4 . Number of poles P=6 N = Speed of armature = 900 rpm Z = number of conductors = 720…

Q: calculate the Load current and Load voltage of the given figure

Q: Find i in the network using superposition. 5Ω 10 Ω 2 A 5Ω 4Ω 20 V

A: This theorem is used to find current in any particular branch. To apply this minimum 2 sources are…

Q: A snubber circuit has snubber time constant (10 msec), voltage source (10 kV), discharge current of…

A: Given data, Time constant,τ= 10 msec Voltage source V = 10 KV = 10000 V Discharging current is,…

Q: Determine: the current and voltage across each load. Μ 35 V Μ 14 Ω 10 Ω 12 Ω < 18 Ω

Q: draw the schematic diagram for single phase AC Voltage regulator and three phase AC Voltage…

A: Step-1->schematic diagram for single phase AC Voltage regulator-:

Q: The principle operation of LVDT is based on the variation of Select one a. Self inductance b.…

A: Right Answer option C.Mutual Inductance

Q: Draw the schematic diagram of the Regulated Power Supply with the following components: Transformer,…

A: Given A regulated power supply has following components: transformer , rectifier bridge type,…

Q: A current of 12 A is reversed in a 3-H coil in 24 ms. The induced voltage is

A: In this question, We need to determine the induced voltage across the inductor? We know Induced…

Q: A snubber protection circuit has snubber time constant (5msec), voltage source (5kV), discharge…

A: Given a snubber protection circuit has, Time constant, τ=5 msec Voltage source, V = 5 kV Discharging…

Q: A snubber circuit has snubber time constant (10 msec), voltage source (10 kV), discharge current of…

A: When a switching device is in it's reverse recovery states, various charge carriers recombine. This…

Q: These question from electronics two course

Question

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1: Given Data:

VIEW

Step 2: Explanation of the application of manganin swamp resistance in PMMC.

VIEW

Solution

VIEW

Step by step

Solved in 3 steps

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Mathematical Modeling of Mechanical System

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, electrical-engineering and related others by exploring similar questions and additional content below.

Similar questions

The speed of a dc motor is directly proportional to the flux O inversely proportional to applied voltage O inversely proportional to back emf inversely proportional to the flux
This course Is this armature winding a progressive or a retro-progressive winding? 3. d х у a Select one: O a. Both O b. Progressive OC. Neither O d. Retro-progressive
Maximum torque is realized when an armature winding is with the magnetic field O at 90° O inline or at 0° at 45° O turning
If residual magnetism of a shunt generator is destroyed due to any reason, it may be restored by connecting its shunt field O to an AC source O to a DC source O to neutral O to earth
Explain why the lockout relay coil energizes instead of the contactor coil. See Figure 6.34.
The magnetic flux through each turns off a 100-turn coil is (³-2) milli-webers where t is in seconds. The induced EMF at t = 2 second is?
Magnetic losses of a compound and shunt generator is approximately ranges from : A) 41-50% B) 10-15 % C) 20-30 % D) 35 - 409 %
4-ls the residual magnetism on the generator is necessary how can you cancel these residual magnetism in D.c generator
DC shunt generator may fail to generate in the case of O Small resistance Existence of frequency Absence of residual flux High speed
In a 2 pole wave wound DC Machine has 620 conductors, the number of parallel paths is
In DC machines the number of parallel paths for a wave winding generator is Select one: O a. Three O b. Two OC. Half the number of poles O d. Equal to Number of Poles
A commutator has 456 segments. Indicate whether or not the windings are possible a. Duplex-wave, eight poles b. Simplex-wave, 10 poles