Answered: A magnetic field of strength 0.25 T is… | bartleby

Related questions

Question

A magnetic field of strength 0.25 T is directed perpendicular to a plane circular loop of wire of radius 23 cm. Find the magnetic flux through the area enclosed by this loop.
T·m²

Expert Solution

Step by step

Solved in 2 steps with 1 images

SEE SOLUTION Check out a sample Q&A here

Blurred answer

Similar questions

Problem 4. A magnetic field directed into the page changes with time according to B = 2.0t³ - 4.0ť² + 3.0, where B is in tesla and t is in seconds. The field has a circular cross section of radius R = 2.5 cm (see figure below). (a) When t= 1.00 s and r₁= 5.0 cm, what are the magnitude and the direction of the electric field at point P₁? (b)When t = 2.00 s and r2 = 2.0 cm, what are the magnitude and the direction of the electric field at point P₂? xxxxx xxxxx xxxx** ** xxx T97 xxx R x xxxxx ****** xxxxx Bin n P₁
At a particular point on Earth, the magnitude of the Earth's magnetic field is 3.50 x 10-5 T. At this point, the field through a small square loop is essentially uniform. The area of the loop is 30.0 cm2. What is the magnitude of the magnetic flux (in T: m2) through the loop when the loop is at the following orientations? (a) the magnetic field is perpendicular to the plane of the loop 1.05*10**-3 X T. m2 (b) the magnetic field and the normal to the plane of the loop are at a 20.0° angle 6.68*10**-8 T.m2 (c) the magnetic field and the normal to the plane of the loop are at a 90.0° angle T.m?
The figure below shows three edge views of a square loop with sides of length ℓ = 0.240 m in a magnetic field of magnitude 1.25 T. Calculate the magnetic flux (in Wb) through the loop oriented perpendicular to the magnetic field, 60.0° from the magnetic field, and parallel to the magnetic field. (a) perpendicular to the magnetic field The SI unit of magnetic flux is the weber (Wb), given by 1 Wb = 1 T · m2. Wb (b) 60.0° from the magnetic field Wb (c) parallel to the magnetic field would like an explanation to go with problems, please.
A square wire with side a = 0.085 m is in a time-varying magnetic field with magnitude B(t) = At, where A = 0.15 T/s. The plane in which the square is located has an angle θ with the direction of B. Express the magnitude of the magnetic flux going through the loop, Φ, in terms of A, t, a and θ. a. Express the derivative of the flux with respect of time, dΦ/dt. b. Express the magnitude of the emf induced in the loop, ε, in terms of A, a, and θ. c. Calculate the numerical value of ε when θ = 0, in volts. d. Calculate the numerical value of ε when θ = 90°, in volts.
Consider the cylindrical conductor with a hollow center and copper walls of thickness b-a as shown. The radii of the inner and outer walls are a and b respectively. and the current I is uniformly spread over the cross section of the copper (shaded region). What is the magnitude of the magnetic field in units of nT at r- 24.1cm. a=13cm, b=30.5cm, 7- 200mA, Hom4 x 10 Tm/A. Provide your answer with two decimal places. A -- 01 (out of page)
A magnetic field directed into the page changes with time according to B = 0.031 ot² + 1.40, where B is in teslas and t is in seconds. The field has a circular cross section of radius R = 2.50 cm (see figure below). xxxx vPg xxx xxx xxxx x Rx Bin P₁ (a) When t = 4.80 s and r₂ = 0.020 0 m, what is the magnitude of the electric field at point P₂? 0.00030 X Your response is off by a multiple of ten. N/C (b) When t = 4.80 s and r₂ = 0.020 0 m, what is the direction of the electric field at point P₂? perpendicular to r₂ and counterclockwise O into the page O out of the page. O perpendicular to ₂ and clockwise