A Machine vice has single start square threads with nominal diameter 22 mm and pitch 5 mm. Collar diameters are 55mm and 45mm respectively. Coefficient of friction for threads 0.15 and u for collar 0.17 The machinist can comfortably apply a force of 125N on handle of mean radius 150 mm. Assuming uniform wear theory calculate, (1) The clamping force developed between the jaws, (2) The overall efficiency of screw

Q: A double-threaded power screw is used to raise a load of 5 kN. The nominal diameter is 60 mm and…

A:

Q: A screw jack mechanism is to be incorporated into the machine as part of a levelling system. The…

A: Given data as per the question Diametre of jack =45 mm Thread pitch =6 mm coefficient of friction…

Q: 1. A machine vice, as shown in the figure has single start, square threads with 22 mm nominal…

A:

Q: Given a 10 mm diameter steel bar with Su = 1200 MPa and Sy = 950 MPa, with a machined surface,…

A:

Q: In a plane strain cutting process, it is found that the coefficient of friction μ (Coulomb) along…

A:

Q: Compute the thread pitch and friction angle for a screw,

A: to compute the thread pitch and friction angle for a screw,

Q: Question No.16: A double threaded power screw with ISO metric trapezoidal threads with 15°…

A: To determine a)the torque required to raise the load.b)the torque required to lower the…

Metrology of Screw Threads

Screw threads are a series of ridges having the profile of a helix. This helix profile runs continuously along the length of a uniform solid or a hollow bar of a circular cross-section at periodic intervals. These helix ridges are also formed over a conical bar. These continuous helical ridges are termed threads.