A Loud Cimpedan ce Z =90+ 6o r is to be matched to a 75 e line using a scnyle shunt - sub tuner Find two designs using open - ciraulted stubs. uscing Smith charts

Q: an input voltage of 230v is applied to a tep up chopper and the output voltage is 690v.the pulse…

A: The pulse width of the output voltage is equal to 172.5 microseconds. The detailed solution is…

Q: Diiferentiate open loop system and close loop system

A: The desired output in an open loop system is independent of the control action, which is one of the…

Q: An LVDT has a maximum core motion of +14 cm and the transfer function is 2 mV/mm. The LVDT can be…

A: A Linear Variable Differential Transformer, or LVDT for short, is an electromechanical position…

Q: For the Phase-Shift oscillator, determine the oscillator frequency C, = C2 = C3 = C = 0.001 µF R2 =…

A:

Q: draw the output voltage and current waveforms

A:

Q: Multiplexers and statistical multiplexers may be differentiated by

A:

Q: In step-down regulator in Figure below, calculate the output voltage if the switching frequency is…

A: Switching frequency, f(sw)=76.923 kHz Time period, Ts=1fswTs=176.23 ×103Ts=13  μs

Q: Firing angle-50 Degree 1:2 -200/200v For the circuit shown the DC ratting current of the Thyristor…

A: Secondary voltage of the transformer, Vs=200*2=400V

Q: Information: 2 Vp-p (Am = 1V) 20 Hz sine wave Carrier: 4 Vp-p (Ac = 2V) 500 Hz sine wave Modulation…

A: Given message signal is Amplitude, Am =1V frequency, fm=20Hz Hence,…

Q: In RG 59 coaxial cable RG term represents

A:

Q: & The mod lating signal )= 2 Cos 200kt+ Cos Houckt in applied to AM modulator f arrierbloszt lot.…

A:

Q: practical modulater wodlator aften ha apeakponer Linitation in AMbmodulater areoperatiywi DSB and…

A: Given thatmodulated dt=0.8 cos 200πtcarrier waveform ct=10 cos 2πfcta) Peak power for DSB Pt=Ac2…

Q: rtlov loka Vth: 2V

A:

Q: Filter for power supply can be in fom of A.LC filter B.RC filter C.RL filter

A: In this question we will write about power supply filter.....

Q: The oscillation frequency for the oscillator below is 3.12 MHZ for c=150 PF, L1=L2= 2.2 mH and M=0.5…

A:

Q: single phase fully controlled bridge circuit with RL with continuous output current is used for…

A:

Q: mb 言=? 2. 6m- = ? for 2m +20 n/m -4n Cm2 Prob, 2, 3 charyed sphencal skells

A:

Q: Which frequency components are seen at the output of the Adder in the figure? 90kHz ve 110kHz…

A: From the given circuit the carrier frequency is  FC = 100 K Hz.   Message signal  FM = 10 K Hz.…

Q: What is the max frequency of the MOD-10 synchronous counter?

A: Fin = input clock frequency  Fin = 1 Hz . Mod of the counter  N = 10 . Fout = Fin / N.

Q: (Question # 31- 40) For a Fixed-Bias Configuration, if: Rc = 2.2 kQ VCE = 7.2V IB = 0.005 lE Ic =…

A:

Q: Two Vesistors R =l0 k and Rae12.5 k2 are series - If i = 14.7 sin(Wt +39)mA what are Ve and VRz ?

A: To solve above problem, one should know how to find equivalent resistance for series and parallel…

Q: 21. Determine the output voltage waveform for the Schmitt trigger in Figure 14-59 in relation to a 1…

A: Given circuit, Given data, Voltages:- V+=+9 VV-=-9 V Biased resistance Rb=39 kΩ Resistance R1=10 kΩ

Q: Determine Rg in k2 for a fixed-bias configuration (shown below) if Vcc = 12 V, ß = 241, and Icq =…

A: To solve above problem, one should know about DC analysis of BJT. DC analysis of transistor is done…

Q: Define the following terms for an series RLC circuits a. Resonant frequency b. Power factor C.…

A: In the given questions we need to discuss about the resonant frequency, Power factor and phasor…

Q: step up

A:

Q: In a CE configuration, the output voltage is with the input voltage. O a. in-phase O b. out-of-phase…

A: Answer: b.out-of-phase by 180 degrees.

Q: Vo RL Vin 5Ve -2V Find Vout and draw sub: alteranating current AC circuts

A: In this question,  We need to draw the output voltage waveform if input waveform is given.  Assume…

Q: %D Calculate the output impedance for the circuit shown in figure. Assume VA = 0. Circuit parameters…

A: Given data:

Q: For the common emitter class A power Amplifier shown next figure, answer the following questions: a)…

A: Note: We are authorized to answer three subparts at a time since you have not mentioned which part…

Q: ex) for the Series di de conFiqu ation and alo de cMabacteristics detr mine a) Voa and Ipa VD b) NR…

A:

Q: Q5) the following waveform is the inductor current of the boost converter, the ripple current is…

A:

Q: What is the lower cutoff frequency due to C,,C2 and C3 for circuit in figure 1? Assume re' = 4.5 ohm…

A: The lower cutoff frequency can be obtained by considering the RC network.

Q: Vin o Cy Vcc = 12 V RC 3.3 K RB 270 K www Please determine the AC voltage gain. Cx 1.5 K RE Vout Cy…

A: Step-1-> In this question we need to find the AC voltage gain

Q: Handbes lit odi dguou odboot avidson H.W: od vd babiv R₂ = Re A Wien Bridge Oscillator circuit is…

A:

Q: Design asynchronuus counter Mod 14

A: Given, To design a 14 mode asynchronous counter

Q: SY collester Feedback blas hit work Showh in figure belahcalchlate Are Valke os SRE) the 18 V 560 KR

A:

Q: deriving of the are Hall Voltage Value ans Ave= #S sin(wt) dt

A: It is asked to determine the average value of voltage (sinusoidal wave) for half cycle of voltage.

Q: A certain JFET data sheet gives VGS = -6V and loss = 12mA. When VGS- OV, what is the lo for the…

A:

Q: RB A RA Vo C2 CI Rx kp the cirzult in figure Qi4, Rx=2 kR, Rz= lkh, : 6.1 MF. C2 0-2 MF and RA = I…

A:

Q: How do I determine the closed loop gain and the rate of fall?

A: The circuit is given as This is an integrator circuit. So that output response will be as low pass…

Q: Determine internal bias voltage vont V-=-15 V+=15

A: Op-amp is multistage amplifier.  The ideal op-amp have  infinite input resistance and infinite gain.…

Q: Re Cout Cin 王。 Qr Re Build an oscillator with fo = 30MHZ Using Using Q = 2N2222 %3D

A:

Q: where to place probes on class c am modulator to measure it

A: Given:A class C AM modulator circuit.To find:Where to place probes on the circuit to measure AM…

Q: In a RC type low pass fitter, the cut-off frequency is 1500 Hz, Assuming the capacitance to be 500…

A: It is given that:

Q: A boost regulator has input voltage of 4 V and the average output voltage of 20 V. The duty cycle is…

A: Given a Boost regulator having, Input voltage, vi=4 V Output voltage, vo=20 V

Multistage Amplifier

The multistage amplifier is generally a voltage or power amplifier. The multistage amplifier has a number of single stage amplifier that are cascaded together. Since a single stage amplifier output is not useful, they are being replaced with multistage amplifiers or multistage transistor amplifiers. The multistage amplifier are used where the gain required is high or the input signal is very small such that only a single stage amplifier cannot amplify it.