A lossless transmission line withcharacteristic impedance of 50n isan unknown loadis terminated with impedance. 1/4from the load on the lineat some point awayvoltage and current values as V10j10v, I = -0.2 + j0.6Arespectively.are given. Find the load impedanceaccordingly.

According to the question we need to calculate the value of load impedance.

A lossless transmission line with characteristic impedance of 500 is an unknown load is terminated with impedance. A/4 from the load on the line at some point away voltage and current values as V = 10 - j10V, I = -0.2 + jo.6A respectively. are given. Find the load impedance accordingly.

A lossless transmission line with characteristic impedance of 500 is an unknown load is terminated with impedance. A/4 from the load on the line at some point away voltage and current values as V = 10 - j10V, I = -0.2 + jo.6A respectively. are given. Find the load impedance accordingly.

Introductory Circuit Analysis (13th Edition)

13th Edition

ISBN:9780133923605

Author:Robert L. Boylestad

Publisher:Robert L. Boylestad

Chapter1: Introduction

Section: Chapter Questions

Problem 1P: Visit your local library (at school or home) and describe the extent to which it provides literature...

See similar textbooks

Related questions

Q: 6-A lossless T.L. has Zo = 100 Q and is loaded by an unknown impedance . Its VSWR is 4 and the first…

A: Given data: Zo=100 Ω VSWR=4

Q: A Parallel wire line has its radius of the conductor is 0.2 mm and the distance between the…

Q: A lossless transmission line has a capacitance per unit length of 90 uF/m (microFarad/meter) and an…

A: Lossless transmission line A transmission line with no line resistance and no dielectric loss is…

Q: A load of 135 MW at a power factor of 0.9 lagging can be delivered by a 3-phase transmission line.…

A: The line current supplied to the load and the resistance per phase for a 3∅ transmission line are…

Q: Q) A 50 0 lossiess transmission line is terminated by a load of impedance Zi. The VSWR on the line…

A: We come to know that there exist a minimum at the load end hence reflection coefficient must be…

Q: b. Determine what is the necessary length and characteristic impedance of a cable to be used as a…

Q: Discuss the methods used to minimize inductance in transmission lines and their effects on signal…

A: Twisted Pair Configuration: Twisting adjacent signal lines in a transmission system helps minimize…

Q: An equilateral transmission line (3-4) has a corond Power Loss of 53kw at lo6kv P and a loss on 98kw…

Q: A transmission line delivers 1200MW at 500kV and 85% power factor. The series impedance of the line…

Q: Draw convergent and divergent positive characteristic lines on an x-t plane. Indicating the time and…

A: The objective is to draw the convergent and divergent positive characteristic lines on an x-t plane…

Q: Consider a transmission line of characteristic impedance 50 ohms. Let it be terminated at one end by…

A: Given: Characteristic impedance, Z0=50 Ω Load impedance, ZL=j50 Ω

Q: [Q8] Consider a transmission line of characteristic impedance 50 ohms. Let it be terminated at one…

A: In this question we need to find a VSWR of the given transmission line.

Q: Q) A source of 10 V and frequency 1000 KHz with internal resistance of 10 2 is connected to the…

Q: For a lossless trabsmisison line, the characteristic impedance is 80 ohm. If the capacitance per…

A: A transmission line can be characterized by 4 parameters: 1. Resistance per unit length (R) in ohm/m…

Q: 4.) A 3-p, 50 Hz, 30-km transmission line supplies a load of 5 MW at p.f. 0.7 lagging to the…

Q: (a) The base impedance in (N) (b) The reactive power drawn by the load (p.u.) (c) The total current…

Q: A lossless transmission line has a capacitance per unit length of 90 uF/m (microFarad/meter) and an…

A: Lossless transmission line: A transmission line with no line resistance and no dielectric loss is…

Q: A lossless transmission line has a characteristic impedance of 100 and is loaded by 100 + j100 N. A…

Q: Problem 6- A Three-phase 60 Hz transmission line has its conductors arranged in a triangular…

A: we need to find GMD and radius of conductor to calculate the required parameters.

Q: Example15/ T-L with Zo=600 ,ZR 2 100 . Find the length and location of the single stub terminated by…

A: Using the formula, τ=ZL-ZoZL+Zo Putting values, τ=100-600100+600 So, τ=-500700 τ=57∠-180°

Q: A three-phasc 60-Hz transmission line has its conductors arranged in a triangul formation so that…

A: In this question ACSR conductor in triangle formation is given....We have to find capacitance per…

Q: 64 12 lossless transmission line by using a quarter-wave

Q: phasor diagram, the line drop phasor due to resistance is in phase

A: In this question , we have to find out that in medium transmission line T configuration phasor…

Q: 8. A transmission line has a characteristic impedance of 500 and a resistanc of 0.1 02/m. If the…

A: In this question we will find attenuation constant for distortionless transmission line....

Q: 1-The dc source supplying an inverter with a bipolar PWM output is 96 V. The load is an RL series…

A: Bartleby has policy to solve only first question. Reupload the second question.

Q: Impedance matching is provided at D = 0.074? and L = 0.094? values for an unknown load using the end…

Q: C- Considering the model of a medium length transmission line where the capacitive effect is equally…

A: In this question we need to draw a phasor diagram of the given transmission line.

Q: Estimate the distance over which a load of 12000 kW at a p.f. 0-65 lagging can be delivered by a…

A: The solution can be achieved as follows

Q: A 702 high-frequency lossless line is used at a frequency where 2 = 80cm with a load of 140+j91 2 a.…

Q: A lossy capacitor Cx, rated for operation at 5 kV, 50 Hz is represented by an equivalent circuit…

A: Given: An equivalent circuit with an ideal capacitor in parallel with a resistor, Cp=0.102 μFRp=1.25…

Q: A lossy capacitor Cx, rated for operation at 5 kV, 50 Hz is represented by an equivalent circuit…

A: Given- An equivalent circuit with an ideal capacitor in parallel with a resistor, Cp=0.102 μFRp=1.25…

Q: spectively per mile. Find the percent efficiency of the line.

Q: Q) A source of 10 V and frequency 1000 KHz with internal resistance of 10 N is connected to the…

Q: j0.25 For the two coupled branches shown above, Ya =-j0.5, Yb = -j1 & Ym = j0.25. Using Equivalent…

Q: Q5 (Large Single Phase Resistive load connected to 3 phase supply) Single Phase Resistive Load eg…

A: Given A large single phase load of Resistance = 0.25 ohm is to be connected to a three phase…

Q: The char. impedance of the trans. line is 50-Ohm and the resistance of it is 0.1Ohm/meter. What will…

A: For the distortion less transmission line the attenuation constant is independent of the frequency.…

Q: Normalized admittance values zL= 0.4 - j0.3 with two load impedances connected in parallel with a 50…

A: To find the distance of voltage maxima and minima, we need to first calculate the wavelength of the…

Q: In a series axperiment with R=1n and R, 42 across a power Supply E, the slope g (E, V,) and of…

Q: Derive an expression for sag in a transmission line of equal hight poles.

A: Given: The poles are of equal height.

Q: a line characteristic impedance 600 ohm and 3 db loss is a half wavelength .it is fed by a source of…

A: A line characteristic impedance 600 Ω and 3 dB loss is a half wavelength. It is fed by a source of…

Q: A lossless transmission line has 100 ? characteristic impedance. The line is terminated in a load…

A: Load impedance given is ZL=R-jXC which means it comprises a resistor and a capacitor. The circuit…

Q: A sinusoidal signal of 1 W average power is transmitted down 10 m of coaxial cable. of 0.1 mW is…

Question

A lossless transmission line with
characteristic impedance of 50n is
an unknown load
is terminated with impedance. 1/4
from the load on the line
at some point away
voltage and current values as V
10
j10v, I = -0.2 + j0.6A
respectively.
are given. Find the load impedance
accordingly.

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

This is a popular solution!

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Trending now

This is a popular solution!

Step by step

Solved in 2 steps with 1 images

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Transmission Line Parameter and Scattering Parameter (S-parameter)

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, electrical-engineering and related others by exploring similar questions and additional content below.

Similar questions

The 50 ohm transmission line isterminated with an unknown load. The magnitude of the reflection coefficient is R=0.5.Thedistancebetween the voltage maximum and the load is0.15 lambda. What is the imaginary partof the load impedance?
A coaxial cable with a characteristic impedance of 50 Ohm is used to deliver mi- crowave signal to a TV antenna which has an impedance of 75 Ohm. What fraction of the signal (in terms of power) can be coupled into the antenna?
Q1) Derive an expression for the input impedance Zin in terms of the load impedance ZL and the characteristic impedance of the line Zo. What is the importance of this case? State briefly.
2. Estimate the distance over which a load of 12000 kW at a p.f. 0-65 lagging can be delivered by a 3-phase transmission line having conductors each of resistance 2 2 per kilometer. The voltage at the receiving end is to be 132 kV and the loss in the transmission is to be 4%.
The impedance of a transmission line with a length of 50 km is given as z = 0.08 + j0.48 22/km. At the end of the line, a power of 250 MW is drawn with a lagging power factor of cosy = 0.95 under 220 kV voltage. Under these conditions, find the voltage, current, and power factor at the beginning of the line.
Q) A source of 10 V and frequency 1000 KHz with internal resistance of 10 2 is connected to the sending end of a transmission line which can be represented by a resistance of 70 Q in series with capacitance of 0.001 µF connected across the line at the receiving end. An inductive load of inductance 0.002 H and resistance 100 Q is connected across the receiving end of the line. Determine the load current.
Blue is the numerical answer, I need a detailed solution.
4. (a) A transmission line with a characteristic impedance of 100 has a load of 1 k2 resistance in parallel with a 0.005 µF capacitor connected across the far end. A surge voltage of magnitude 10 kV and unit function form (i.e. step function) travels along the line. Derive an expression for the time variation of the voltage across the load, and calculate the value of this voltage 10us after the arrival of the wave front of the surge
Find current
Hw2.2-4: 3-phase, 15 MVA, 13.6 KV, 2-pole, 50 Hz alternator of synchronous reactance 8.94 Q. Find the parameters and draw the phasor diagram for each of: a- normal excitation at 10 MW b- maximum power at 13.6 KV excitation
Q) A transmission line of negligible loss has a characteristic impedance of 600 Q. Calculate the VSWR along the line when it is terminated by an impedance of (400+j300) . What is the VSWR if the load is changed to a purely resistive one of 500 0?
The input of a transmission line with Z. = 300 ohms is connected in parallel with the input of another transmission with 200-ohm characteristic impedance. Each line is terminated with a load that is equal to its characteristic impedance. The inputs of the two lines are connected to a third transmission line which supplies power to the first two lines. Find the Z of the third line such that there will be no reflected signal on the third line.