A lossless 50Q transmission line was terminated witha load of = 17.7+ jl1.82.The length of the line is = 1/ 6. The reflectioncoefficients at the entrance of the line and at the loadcalculation.

The solution can be achieved as follows.

Answered: A lossless 50 transmission line was…

A lossless 50 transmission line was terminated with a load of = 17.7 + jl1.8N. The length of the line is = 1/6. The reflection coefficients at the entrance of the line and at the load calculation.

Power System Analysis and Design (MindTap Course List)

6th Edition

ISBN:9781305632134

Author:J. Duncan Glover, Thomas Overbye, Mulukutla S. Sarma

Publisher:J. Duncan Glover, Thomas Overbye, Mulukutla S. Sarma

Chapter5: Transmission Lines: Steady-state Operation

Section: Chapter Questions

Problem 5.17MCQ

See similar textbooks

Related questions

Q: What do you understand by impedance matching? Also write the formula of characteristic impedance for…

A: Impedance matching is a phenomenon in electrical engineering in which the impedance of electrical…

Q: What is the dispersion taking place in long transmission lines? State the condition to obtain…

A: In long transmission lines frequency dispersion takes place. In which transmission lines have…

Q: For the Figure 7 shown: A 395 -km long, 34 Hz, three-phase, 3-wire, transmission line is composed of…

A: In this question We need to determine the value of inductance L per line in (mH) We know Inductance…

Q: Why the Capacitance effect is neglected in Short Transmission Line. Note please don’t handwringing

A: The explanation is as follows.

Q: g) Why the Capacitance effect is neglected in Short Transmission Line.

A: As per the guidelines, we supposed to answer one question at a time so, please ask other question…

Q: .Define the return loss, reflection coefficient and if the return loss (R.L) for a load is 12dB.…

Q: 5. Two cascaded lossless transmission lines are terminated by Z₁-250, as shown below. a) Calculate…

Q: One circuit of a single-phase transmission line is composed of three solid 0.12" radius wires. The…

A: According to the question, One circuit of a single-phase transmission line is composed of three…

Q: For a lossless trabsmisison line, the characteristic impedance is 80 ohm. If the capacitance per…

A: A transmission line can be characterized by 4 parameters: 1. Resistance per unit length (R) in ohm/m…

Q: 4- The charactersitic and load impedances of a lossless transmission Line are Zo and Z₁ = = = Zo' a-…

A: The load impedance is given by; ZL=13Zo Here ZL is the load impedance, Zo is the characteristic…

Q: How does inductance impact the performance of a transmission line in terms of signal integrity and…

A: Signal Integrity: a. Impedance Mismatch: Inductance plays a crucial role in maintaining proper…

Q: A 105MHz, 90 v peak signal is incident on a 50-ohm transmission line. The line is 125m long and is…

Q: Derive an expression for sag in a transmission line of equal height poles

A: Consider the diagram for the transmission line between two supports of of equal height as point A…

Q: A single-phase transmission line consisting of two conductors, the radius of each conductor is 0.4…

A: 1..>>Capacitance of line without effect of ground Radius of conductor is 0.4cm Distance…

Q: What is the justification in neglecting line capacitance in short length transmission lines?

Q: Which Transmission Line Parameter is neglected or ignored in most classifications of Transmission…

A: The G boundary is liable for the spillage current stream between the conductors and the ground. As…

Q: A double-circuit its capacitance to neutral per mile. line is shown below. The conductor radius is…

Q: A lossless 60 ohm line is terminated by a 60+j60 ohm load .If Zin =120- j60ohm. How far (in term of…

A: The wave is function of space and time. The EM wave is formed when electric field is in contact with…

Q: A 702 high-frequency lossless line is used at a frequency where 2 = 80cm with a load of 140+j91 2 a.…

Q: 4/ Which parameter is neglected or ignored in Short Transmission Lines? A. SHUNT CAPACITANCE ONLY…

Q: The conductor of a single-phase 60-Hz line is a solid round aluminum wire having a diameter of 0.412…

Q: 1. Three conductors for a 3-phase 60 Hz transmission line are placed in a horizontal plane with…

A: We will use formula of inductance to find distance between phase conductors.

Q: For the Figure 6 shown: A 441 -km long, 59 Hz, three-phase, 3-wire, transmission line is composed of…

A: To calculate the inductance per line (in mH) of the given transmission line, we can use the formula…

Q: Ideally, a dc load line is a straight line drawn on collector characteristic curves between which of…

A: The DC Load Line of BJT Biasing Circuit is a straight line drawn on the transistor output…

Q: The conductor of a single-phase 60-Hz line is a solid round aluminum wire having a diameter of 0.412…

A: Inductance: It is a passive two-terminal electrical component and measured in Henry (H). When…

Q: For the Figure 9 shown: A 273-km long, 47 Hz, three-phase, transmission line is composed 2 parallel…

A: It is given that: L=273 kmf=47 HzGMR=13.59 mmD=4.78 m

Q: A single-phase transmission line consisting of two conductors, the radius of each conductor is 0.4…

Q: The 50 ohm transmission line isterminated with an unknown load. The magnitude of the reflection…

A: Transmission line

Q: g) Why the Capacitance effect is neglected in Short Transmission Line.

A: The transmission line that is less than length of the 80 km is considered as short transmission line…

Q: For the Figure 9 shown: A 65 -km long, 59 Hz, three-phase, transmission line is composed 2 parallel…

Q: Question 1: The circuit below shows a reactor being disconnected from its supply. During the process…

A: In the circuit reactor being disconnected from its supply, Given, L1=15mH L2=352mH C=3.2nF Assuming…

Q: Why the Capacitance effect is neglected in Short Transmission Line.

A: The explanation is as follows.

Q: 5-A lossless T.L. has Zo = 100 Q and is loaded by ZL. The VSWR = 2 . The first two voltage minima…

Question

A lossless 50Q transmission line was terminated with
a load of = 17.7+ jl1.82.
The length of the line is = 1/ 6. The reflection
coefficients at the entrance of the line and at the load
calculation.

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Introduction

VIEW

Solution

VIEW

Step by step

Solved in 2 steps with 1 images

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Single Phase Controlled and Uncontrolled Rectifiers

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, electrical-engineering and related others by exploring similar questions and additional content below.

Similar questions

Use any assumption needed
How does inductance impact the performance of a transmission line in terms of signal integrity and power losses?
Which Transmission Line Parameter is neglected or ignored in most classifications of Transmission Line Equivalent Circuits? A. The Line Inductance B. The Line Resistance C. The Shunt Conductance D. The Shunt Capacitance
5. Two cascaded lossless transmission lines are terminated by Z₁-2502, as shown below.. a) Calculate the reflection coefficient and the standing wave ratio at the load, i.e., the CC' terminal. b) Determine the characteristic impedance of the quarter-wavelength transformer, Zol, to match the cascaded line to a 6492 generator. B A- A'. Zol 11= 2/4 B' Zo2=75 92 12=32/4 C C ZL=2592
Due to line mismatch, a voltage standing wave ratio of 10 is calculated. The total volatge at the load is 5Vrms. What is the peak amplitude of the incident voltage at the load? Assume that the incident and reflected voltages are in phase at the point of reflection.
4/ Which parameter is neglected or ignored in Short Transmission Lines? A. SHUNT CAPACITANCE ONLY B. SERIES CONDUCTANCE AND SHUNT CAPACITANCE C. SHUNT CONDUCTANCE AND SHUNT CAPACITANCE D. SHUNT CONDUCTANCE ONLY
Three conductors for a 3-phase 60 Hz transmission line are placed in a horizontal plane with a separation between two conductors is D meters. The conductor geometrical mean distance is 2.0 cm. The line reactance is 0.486 ohm/kilometer. Find the phase conductor separation D
Why the Capacitance effect is neglected in Short Transmission Line.
Don't copy
The conductor of a single-phase 60-Hz line is a solid round aluminum wire having a diameter of 0.412 cm. The conductor spacing is 3 m. Determiņe the inductance of the line in millihenrys per mile. How much of the inductance is due to internal flux linkages? Assume skin effect is negligible.
5-A lossless T.L. has Zo = 100 Q and is loaded by ZL. The VSWR = 2. The first two voltage minima are located at z= -10 and -35 Cm from the load where z = 0. Determine ZL.
Subject Is power transmission lines and Distrubtion