A loss less power system has to serve a load of 250 MW. There are tow generation (G₁ and G₂) in the system with cost curves C₁ and C₂ respectively defined as follows; C₁ (PG1) PG1 + 0.055 × P²1 C₂ (PG2) = 3PG2 + 0.03 × P²2 = Where PG1 and PG2 are the MW injections from generator G₁ and G₂ respectively. Thus, the minimum cost dispatch will be O O O O PG1 = 250 MW; PG2 = 0 MW PG1 PG1 = = 150 MW; PG2 100 MW; PG2 PG1 = 0 MW; PG2 = 100 MW = = 150 MW : 250 MW
Load flow analysis
Load flow analysis is a study or numerical calculation of the power flow of power in steady-state conditions in any electrical system. It is used to determine the flow of power (real and reactive), voltage, or current in a system under any load conditions.
Nodal Matrix
The nodal matrix or simply known as admittance matrix, generally in engineering term it is called Y Matrix or Y bus, since it involve matrices so it is also referred as a n into n order matrix that represents a power system with n number of buses. It shows the buses' nodal admittance in a power system. The Y matrix is rather sparse in actual systems with thousands of buses. In the power system the transmission cables connect each bus to only a few other buses. Also the important data that one needs for have a power flow study is the Y Matrix.
Types of Buses
A bus is a type of system of communication that transfers data between the components inside a computer or between two or more computers. With multiple hardware connections, the earlier buses were parallel electrical wires but the term "bus" is now used for any type of physical arrangement which provides the same type of logical functions similar to the parallel electrical bus. Both parallel and bit connections are used by modern buses. They can be wired either electrical parallel or daisy chain topology or are connected by hubs which are switched same as in the case of Universal Serial Bus or USB.
Step by step
Solved in 2 steps with 1 images
