A load of 40 -j 30 is connected to a source of 100 V with a phase angle of 300, through a transmission line with an inductive reactance of 60 ohms. The total reactive power absorbed by the line is: O A. None of choices are correct O B. 177 vars O C. 240 vars O D. 120 vars O E. 78.5 vars

A load of 40 -j 30 is connected to a source of 100 V with a phase angle of 300, through a transmission line with an inductive reactance of 60 ohms. The total reactive power absorbed by the line is: O A. None of choices are correct O B. 177 vars O C. 240 vars O D. 120 vars O E. 78.5 vars

Introductory Circuit Analysis (13th Edition)

13th Edition

ISBN:9780133923605

Author:Robert L. Boylestad

Publisher:Robert L. Boylestad

Chapter1: Introduction

Section: Chapter Questions

Problem 1P: Visit your local library (at school or home) and describe the extent to which it provides literature...

See similar textbooks

Related questions

Q: Find Z for the maximum average Power transfer to the Lead for the circuits Shown below. JIr

Q: A sinusoidal voltage is applied to a single phase load. The input current wave form is as shown…

A: Phaser diagram is given, From the diagram, vm=1202 V RMS voltage is given by, Vr=Vm2=12022=120 V

Q: (b) Given that a total impedance of a series circuit is Z = 10 – j13 Q and the operating frequency…

A: In this question, Total impedance Z= 10-13j Operating frequency f= 60Hz. Sketch the series and…

Q: 52 13 j2 12 ww 5:1 50 20 V 20 V1 For the circuit shown, the value of the primary side of the ideal…

Q: You make a circuit with a function generator at 1.02 kHz battery, a 43.0 Q resistor, and a capacitor…

A: The RC series circuit with a voltage source is shown below: The RMS voltage across the capacitor…

Q: The of air surrounding the power conductor is the phenomenon of corona. capacitors are used across…

A: Ionisation of air surrounding the power conductor is the phenomenon of corona Synchronous…

Q: For the circuit shown, what is the reactive power, Q, consumed by the 1+j5 N load impedance? (Assume…

Q: 23 an ac circuit has a frequency of 400 hz. A 16 ohm resistor, 0.0119 inductor and a 16.6 capacitor…

Q: A single-phase load has an active power of P = 2 kW at 180 V @60HZ and the power factor is cos% =…

A: a) Apparent power, S S=20000.75 =2666.67VAQ=2666.67*1-0.752 =1763.83VAR

Q: is course Given the circuit below and the associated set of voltages and currents, the reactive…

A: Reactive power

Q: A voltage and current applied to a single phase load is v= 26 cos (300t+25°) and i= 12 cos (250t-…

A: Voltage and current signals are given Find the active power and reactive power ?

Q: For the circuit shown, determine the current through the 2+j5 ohms impedance.

Q: 1. Deternine Vo in the circuit below 2 H 42 ww 32 sin 41 V 4 cos 4t A

A: Given that Electrical network as follows

Q: A load of 60 -j80 has a current of 9.60 A with a phase angle of 30°, the total reactive power is:

Q: 1. a) Find the rms magnitude and the phase angle of ICA in the circuit shown. 2. b) What percent of…

A: (a) The given load is connected as a delta load. Convert it into a star connected load.

Q: solve the circuit to determine the following parameters: active power P, reactive power Q, and…

A: Step 1:### Step 1: Calculate the Impedance in Each PhaseFor each phase, the impedance \( Z \) can be…

Q: The following AC power source connected to two impedances and one resistive load. Analyze the…

A: The Given circuit is To analyze the circuit reactive components and reactive power developed…

Q: If the mesh current 12 = 0.827117.17° A, the supply curent l=1.2L45° A, and R=2.2 0, for the…

A: To find the power factor of current source in the given circuit

Q: A 5-ohm resistor is connected in series with a 25 micro-farad capacitor. A source voltage of 158…

Q: Problem 6: Given the circuit below, find the total complex, average, and reactive power absorbed by…

A: In this question, We need to determine the total complex power, average power and reactive power.…

Q: 22. A circuit has a real power of 250 W and a reactive power of 150 VAR. Is the circuit more…

A: In this question we need to choose a correct option

Q: c) Three identical inductors are connected in Y-across a three-phase 400V/50Hz line. The line…

A: Given data, Three identical inductors are connected in Y across a three- phase line. Line voltage,…

Q: For the circuit of the following figure, if R=26 Q, Zc=-J18 Q, and ZL=J18 Q, and if the value of the…

A: To find The value of reactive power supplied by 3L-41° v

Q: the shunt capacitance is a capacitor O a. Between a phase and the ground O b. between phases and a…

A: In this question, We need to choose the correct options What is shunt capacitance is a capacitor?…

Q: Find Hhe ntegrating factor of aloa d ty =2 lnx. -2 lox. da

A: Given that xln(x) (dy/dx) +y = 2ln(x) Convert the above in to (dy/dx )+Py = Q

Q: QUESTION 50 RG180B/U is a coaxial cable with a nominal impedance of 95 2 and a capacitance per foot…

A: Nominal impedance ZC=95 Ω Capacitance per foot. C=15.5 PF/foot

Q: j 20 ll a b 100/20° V -j 5 2 Figure 04 Q4. (a) Find the Thevenin equivalent circuit looking from the…

A: "Since you have asked multiple question , we will solve the first question for you if you want any…

Q: the RMS value of the current is? /2) the peak value of the voltage is?/3) the value of the reactive…

Q: A 5+j1552 15-j5r

A: Given data, Circuit diagram is given as,

Q: Use the results of Problem 5 to find the value of phase o that minimizes the (peak value of) current…

A: The solution is given in picture

Q: Given Zc - j339 , R₁ = 414 , RL = 12420 2 and a=0.24, what is the magnitude of the source voltage Vs…

Q: For the circuit shown, determine the Thevenin equivalent voltage seen from the terminals marked A)…

Q: The reactive factor is the cosine of the phase angle between the voltage and the current Select one:…

Q: 22.) The figure below shows a series-parallel circuit. Find the magnitude of the total circuit…

A: The solution is given below

Q: A voltage and current applied to a single phase load is v= 27 cos (300t+20°) and i= 17 cos (250t-…

A: Voltage and current signals are given Find the active power and reactive power of the system.

Q: 3. A 1-d Sul Conviester, Conneeted to 230 v, so M. Sousre . feedng a loael R: 10 n n series wish a…

Q: Three series loads are drawing 20A ms current through a 60HZ source. Load 1 is an 400W, 0.8 lagging…

A: As per guidelines we can only solve 3 subparts of seperate question, so kindly repost remaining in…

Q: Solve the following: Compute the total impedance (Z) What is the total current (I)? Compute the…

A: In this question we will find total impedance , current and voltage drop across each components ....

Question

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

This is a popular solution!

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Step 3

VIEW

Trending now

This is a popular solution!

Step by step

Solved in 3 steps with 1 images

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Single Phase Controlled and Uncontrolled Rectifiers

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, electrical-engineering and related others by exploring similar questions and additional content below.

Similar questions

1. Calculate the complex power delivered to each passive component of the circuit in figure, and determine the power factor of the source. 2. What value of capacitance must be added in parallel to the 10 Q resistor to increase the PF of the source to 0.95 at 50 Hz? j30 Q 50/-17° V rms ( L -j25 Q 46 102 15Ω
Three loads are connected in parallel to a 240-V, 60 Hz supply. Load 1 is composed of three 600-W heaters, Load 2 is a 3 HP, inductive motor with an efficiency of 90% and a p.f. of 0.88, while Load 3 has an impedance of 12-j16 ohms. Determine the following: a) The apparent power of each load b) The Total Power, Total Reactive Power, Total Apparent Power, Power Factor c) The source current
please answer alll subparts for like either dislike... 1. Find the total real power supplied by the source 2. The total reactive power supplied by the source is 3. The magnitude of the total apparent power is 4. The power factor of the source is 5. A capacitor is connected across the loads as indicated in Figure 1 to improve the power factor to 0.95 pf lagging The required reactive power supplied by the capacitor is 6. The value of the capacitor is
A voltage and current applied to a single phase load is v= 25 sin (300t+35°) and i= 12 sin (250t- 20°). Find the single and three phase active and reactive power of the circuit if the voltage and current are in cos waveform. Phase Angle (Theta) Active Power Reactive Power Three Phase Active power Three phase Reactive Power
Power coefficient 0.9 back by connecting capacitors parallel to a 100kW load with 0.7 back power coefficientis being done. The line voltage is 49 V. Reactive power produced by capacitors and Line currentcalculate the decrease
For the circuit shown below, determine the total impedance and current
between total current and the current in the capacitor 1. The input voltage V; is sinusoidal. Compute the frequency where the phase shift is 45°. + Vi 5Ω 20mF 10 +
Please do it fast please
For a source which has load has the following characteristics: • Vrms = 125 20° V • P= 400 W • pf = 0.925 lagging What is the rms current and reactive power?
Q4 a) A three-phase system has a rms phase voltage of 6.3 kV. What is the line voltage?
12 Power factor of pure inductive load is O ZERO, Lagging ut of UNITY (1), Lagging estion UNITY (1), Leading O ZERO, Leading lo improve power factor by static capacitor me
Represents values in rectangular and polar form. Having positive reactance. Having negative reactance. Options for 1,2,3 answer Phasor domain Capacitor Impedance Alternating current Frequency Inductor Period Amplitude Phase shift Resistor Effective valueAverage value