A load of 240 +j 120 is connected to a source of 240 V with a phase angle of 300, through a transmission line with an inductive reactance of 60 ohms. A Capacitor bank of a capacitive reactance of 120 ohms is connected in parallel to the load. Total reactive power supplied by the source to the line is: O A. None of choices are correct O B. 1440 vars O C. 0 vars O D. 480 vars O E. 960 vars

A load of 240 +j 120 is connected to a source of 240 V with a phase angle of 300, through a transmission line with an inductive reactance of 60 ohms. A Capacitor bank of a capacitive reactance of 120 ohms is connected in parallel to the load. Total reactive power supplied by the source to the line is: O A. None of choices are correct O B. 1440 vars O C. 0 vars O D. 480 vars O E. 960 vars

Introductory Circuit Analysis (13th Edition)

13th Edition

ISBN:9780133923605

Author:Robert L. Boylestad

Publisher:Robert L. Boylestad

Chapter1: Introduction

Section: Chapter Questions

Problem 1P: Visit your local library (at school or home) and describe the extent to which it provides literature...

See similar textbooks

Similar questions

27. In an RC parallel circuit, the voltage across the resistor and the voltage across the capacitor are a. in phase b. 180° out of phase c. less than 90° out of phase with the resistor voltage lagging d. less than 90° out of phase with the resistor voltage leading
Desian aproblem for wye delta transform adions Determinc the eauivalend resistance between the terminals A andA B.
1. Calculate the complex power delivered to each passive component of the circuit in figure, and determine the power factor of the source. 2. What value of capacitance must be added in parallel to the 10 Q resistor to increase the PF of the source to 0.95 at 50 Hz? j30 Q 50/-17° V rms ( L -j25 Q 46 102 15Ω
4) Find current phasor I for the following AC steady state circuit. j35 O -j14 2 12/0° V 103 n3 j25 Q
In an L-R-C series circuit the source voltage leading the current with the phase angle of 30°. The resistance of the resistor is 100 Ohm. If the average power delivered by the source is 100 W, what is the rms voltage of the source? 165 V O 115 V 30 V O 200 V 60 V
supply 3. Three circuits A, B and C are connected in series across 350 V supply. The voltage across circuit A is 80 V lagging the voltage by 330 and the voltage across circuit C is 140 V leading the supply voltage by 48°. Determine the voltage circuit B and its phase displacement from the supply voltage using wave and vector solution. across 4. Draw the phasor and wave diagram of the following sinusoidal current:
please answer alll subparts for like either dislike... 1. Find the total real power supplied by the source 2. The total reactive power supplied by the source is 3. The magnitude of the total apparent power is 4. The power factor of the source is 5. A capacitor is connected across the loads as indicated in Figure 1 to improve the power factor to 0.95 pf lagging The required reactive power supplied by the capacitor is 6. The value of the capacitor is
A voltage and current applied to a single phase load is v= 25 sin (300t+35°) and i= 12 sin (250t- 20°). Find the single and three phase active and reactive power of the circuit if the voltage and current are in cos waveform. Phase Angle (Theta) Active Power Reactive Power Three Phase Active power Three phase Reactive Power
For the circuit shown in the below figure, the value of capacitor 'C such that the power factor will be unity is 230 V, 50 Hz z = 30240°
For the circuit shown below, determine the total impedance and current
Please do it fast please
Problem 1 • A sinusoidal source with frequency of 60 Hz and rms-voltage of 100 V is connected to an RL load of 10 ohms and 100 uH. Find Power Factor From Calculation Find Power Factor From Plot L=10mH find power factor from calculation only