A load is supported by four 304 stainless steel wires that are connected to the rigid member’s AB and DC. The members were originally horizontal, and each wire has a cross-sectional area of 0.025 in2.  a) Determine the angle of tilt of each member after the 500 lb load is applied.  b) If the load is reduced to 450 lb but we desire to maintain the same tilt in each of the members, can I change the       temperature to achieve it and by how much?

Q: *3-44. Determine the magnitudes of F₁, F2, and F3 for equilibrium of the particle.

A:

Q: Hello I am try to solve this loads and reactive forces problem 1.7 problem as I am having difficult…

A: Given data: The total length of the beam, L = 14 ft. The point load acting, P = 4000 lb. The…

Q: Required Information NOTE: This is a multi-part question. Once an answer is submitted, you will be…

A:

Q: Find the force generated by the deltoid (right arm) if: His arm length (d) is: 0.84 m The COG of the…

A: Arm Length d=0.84mCOG=37%Wa=7.9NWw=126NAngle=90°Insertion=0.17mAngle for line of pull=11°…

Q: Question 3 A weight of 1881 N resting over a smooth surface inclined at 30° with the horizontal, is…

A:

Q: (13%) Problem 5: A shop sign weighing msg hangs from one end of a uniform beam weighing mpg. A hinge…

A:

Q: 30° 45°C_B

A:

Q: A 2-in.-diameter round steel rod 10 ft long is subjected toa tensile force of 60 kips. How much will…

A: Given Data⇒Diameter of round steeld=2 inLength of round steelL=10 ft=120 inTensile ForceF=60…

Q: The assembly is the same as in problem 2. It consists D of two rods AC and BD attached to the 100-lb…

A:

Q: 3. A rod is composed of an aluminum section rigidly attached between steel and bronze sections, as…

A:

Q: E F G 3 ft 5 ft H D C -1 ft-F - 2 ft 1.8 ft I A B 3 ft 1 ft- 500 lb

A:

Q: Q2) A building wall consists of 12-in. clay brick and --in. fiberboard on one side. If the wall is…

A:

Q: QUESTION 4: A machine with a mass of "600" tons was placed on 6 legs. Feet are square section; its…

A:

Axial Load

When a bar of the uniform cross-section is acted by a load, such that the load acts along the longitudinal axis of the bar, such kinds of loadings are known as axial loadings. In general terms, a load is an external force acting on a component. An axial load acts perpendicular to the geometric cross-section of the component. Based on the direction of the application of the load, an axial load can be tensile or compressive. The analysis of bodies under the action of axial loads is generally studied under the branch of mechanics, known as statics.