A load Centre is at an equidistant from the twothermal generating stations G₁ and G₂ as shownin Figure The fuel cost characteristics of thegenerating stations are given byG₁LoadteG₂F₁ = a + bP₁ + cP² Rs/hourF₂ = a +bP₂ +2cP² Rs/hourwhere P₁ and P₂ are the generation in MW of G₁and G₂, respectively. For most economicgeneration to meet 300 MW of load, P₁ and P2,respectively, are

Given the two thermal generating stations G1 and G2 as shown in the figure, F1=a+bP1+cP12…

A load Centre is at an equidistant from the two thermal generating stations G₁ and G₂ as shown in Figure The fuel cost characteristics of the generating stations are given by G₁ Load F₁ = a +bP₁ + cP2 Rs/hour 1 1 te G₂ F₂ = a +bP₂ +2cP² Rs/hour 2 where P₁ and P₂ are the generation in MW of G₁ and G₂, respectively. For most economic generation to meet 300 MW of load, P₁ and P2, respectively, are

A load Centre is at an equidistant from the two thermal generating stations G₁ and G₂ as shown in Figure The fuel cost characteristics of the generating stations are given by G₁ Load F₁ = a +bP₁ + cP2 Rs/hour 1 1 te G₂ F₂ = a +bP₂ +2cP² Rs/hour 2 where P₁ and P₂ are the generation in MW of G₁ and G₂, respectively. For most economic generation to meet 300 MW of load, P₁ and P2, respectively, are

Introductory Circuit Analysis (13th Edition)

13th Edition

ISBN:9780133923605

Author:Robert L. Boylestad

Publisher:Robert L. Boylestad

Chapter1: Introduction

Section: Chapter Questions

Problem 1P: Visit your local library (at school or home) and describe the extent to which it provides literature...

See similar textbooks

Similar questions

Here X =165 plzzz solve urgent with detail...
What are ‘load curves’ and ‘load duration curves’? Discuss their utility in the economics of generation.
The steady-state voltage drop between the load and the sending end of the line seen in (Figure 1) is excessive Suppose that V-4950/0° V (rms). A capacitor is placed in parallel with the 192 kVA load and is adjusted until the steady-state voltage at the sending end of the line has the same magnitude as the voltage at the load end, that is, 4950 V (rms). The 192 kVA load is operating at a power factor of 0.8 lag. Part A Calculate the size of the capacitor in microfarads if the circuit is operating at 60 Hz. In selecting the capacitance, use the value that results in the lowest possible power loss in the line. Express your answer in microfarads to three significant figures. ▸ View Available Hint(s) Figure 1 of 1 202 1100 192 kVA 0.8 lag ΜΕ ΑΣΦ. 11 vec C= 22.8 Submit Previous Answers Incorrect; Try Again; 5 attempts remaining Provide Feedback ? F
A generating station having two thermal generating units shown below with minimum and maximum generations of 45 MW,60 MW and 600 MW, 800 MW respectively, have the Gen-2 following cost equations. Gen-1 C, = 0.065 Pc1? + 25 Pc1 + 400 OMR / Hr C2 = 0.082 Pc2² + 8 Pc2 + 320 OMR / Hr Calculate the saving when they share load as per economic load dispatch compared to load sharing proportional to their maximum generation. Neglect line losses. 280 MW 400 MW
How many different load groups are there in power plants? Explain by drawing on a power-time curve.
I need the answer as soon as possible
Explain the concept of load flow analysis in power systems. How does it help in determining the steady-state operating conditions of a power grid, and what are its limitations?
Pls. Answer thank you! A generating station has a maximum demand of 25MW, a load factor of 60%, a plant capacity factor of 50% and a plant use factor of 72%. Find the reserve capacity of the plant in MW.
e)
Two parallel loads are connected to a 120 volt rms, 60 Hz power line. One load absorbs 10 k watts at 0.8 power factor lagging. The second load absorbs 4 k watts at 0.9 power factor leading. Determine the real (watts) and reactive (VARS) power of the combined load.
Q2) The bus-bar (A) and (B) are linked by a bus-bar reactor of 1000 KVA with 10% reactance on bus-bar (A). The system has 2 generators each one of 5000 KVA with 5 % reactance, and on bus-bar (B) two motors each one of 5000 KVA with 12% reactance. Find the steady state apparent power (MVA) given to the symmetrical short circuit occurred on bus-bar (B) in the circuit shown below. Ма Mi B Gi A G₂ Xr m
A generating station has a maximum demand of 30MW, a load factor of 65%, a plant capacity factor of 50% and a plant use factor of 72%. Solve for the reserve capacity of the plant, daily energy produced and maximum energy that could be produced daily if the plant while running as per schedule, were fully loaded.