A liquid is boiling in a airtight vessel. Using an exhaust tube the vapour is pumped out at a faster rate. What will happen to the liquid? 1) Temperature will go down but boiling will continue 2) Temperature will rise and boiling will continue 3) Bolling will stop 4) Whatever vapour inside will condense

A liquid is boiling in a airtight vessel. Using an exhaust tube the vapour is pumped out at a faster rate. What will happen to the liquid? 1) Temperature will go down but boiling will continue 2) Temperature will rise and boiling will continue 3) Bolling will stop 4) Whatever vapour inside will condense

Elements Of Electromagnetics

7th Edition

ISBN:9780190698614

Author:Sadiku, Matthew N. O.

Publisher:Sadiku, Matthew N. O.

ChapterMA: Math Assessment

Section: Chapter Questions

Problem 1.1MA

See similar textbooks

Similar questions

15. Describe a superheated vapor.
If the mass flow is 5 kg/s, how long will it take to fill a container with 7000 g of fluid? O a. 0.7 s O b. 0.0233 min O c. 0.7 min O d. 1.4 min
Pressure drop and heat transfer in suction line Decrease compression ratio & discharge temperature Increase compression ratio & discharge temperature Decreases specific volume of refrigerant at suction All of the above O
A reciprocating compressor is operating at 800RPM. Suction pressure and discharge pressure are held constant by other means that have nothing to do with the compressore . The speed is increased from 800 - 840 Rpm (a 5% increase) a) What is the change in the flow rate through the compressor? b) What is the change in the pressure rise through the compressore? c) What is the change in the power that must be delivered to the compressor?
In the following piston-cylinder system, the initial dryness rating at 100 kPa is 0.5.There is a saturated liquid-vapor mixture. Initially the system is based on stoppers. SystemThe volume is tripled by heating. Constant movement at 200 kPa pressure due to piston weightit's starting to do.a) Find the final temperature. b) Find the heat transferred.
Given the conditions on a converging-diverging wind tunnel. At the reservoir pressure is measured to be 200,000 Pa and density is 1.4 kg/m^3. At the throat section Mach number is 1.0 and speed of sound is 390 m/s. At the exit/exhaust the Mach number is 2.5.
QUESTION 19 Determine the type of steam given: Pressure - 1.5 MPa: Temperature - 250°C Saturated Vapor O Superheated Steam O Saturated Liquid Wet Vapor
If the mass flow is 5 kg/s, how long will it take to fill a container with 7000 g of fluid? O a. 0.7 s O b. 0.0233 min O c. 0.7 min Od. 1.4 min
QUESTION 16 Determine the type of steam, given: Pressure = 10 MPa: Temp = 300°C O Saturated Liquid O Saturated Vapor Superheated Vapor O Subcooled
Problem 1 Given: Find: A 5 ft' tank is initially evacuated (total vacuum). A leak develops and air enters the tank at a constant rate of 0.004 lbm/s. The air is at 70 "F and behaves as an ideal gas. The pressure (lb/in) in the tank 30 seconds after the tank starts leaking.
Why would a pump experience cavitation?
QUESTION 18 Determine the type of steam, given: Pressure: 6.4 MPa Enthalpy: 3.2 kl/kg.K O Wet vapor O Saturated Vapor O Superheated Vapor