A line of levels is run from BM1 to BM2, which is 12 km long. Elevation of BM1 was found out to be 100 m and that of BM2 is 125.382 m. Average backsight and foresight distance were 150 m and 100 m respectively. m. a) (Situation 2) if the average backsight reading is 3.4 m and every time it is taken, the rod is inclined to the side from vertical by 4°, what should be the corrected elevation of BM2?

A line of levels is run from BM1 to BM2, which is 12 km long. Elevation of BM1 was found out to be 100 m and that of BM2 is 125.382 m. Average backsight and foresight distance were 150 m and 100 m respectively. m. a) (Situation 2) if the average backsight reading is 3.4 m and every time it is taken, the rod is inclined to the side from vertical by 4°, what should be the corrected elevation of BM2?

Structural Analysis

6th Edition

ISBN:9781337630931

Author:KASSIMALI, Aslam.

Publisher:KASSIMALI, Aslam.

Chapter2: Loads On Structures

Section: Chapter Questions

Problem 1P

See similar textbooks

Similar questions

The instrument used was a transit with an internal focusing telescope and a stadia interval factor of 99, compute for the gradient from A to B if all the stations are in a straight line.
العنوان не ➤ The following observations were recorded when carrying stadia level between two temporary bench marks. ➤ If the elevation of TBM1 is 750.0 m, compute the elevation of TBM2. Back sight Fore sight Stat. interval Rod read. v.angle interval Rod v.angle read TMB1 3.14 8.6 -0° 25' TP1 5.02 4.5 -3 15 5.02 6.3 +1 52 TP2 4.88 10.0 -1 02 2.74 2.2 +6 20 TP3 6.08 8.0 +0 36 8.06 5.0 +6 13 TP4 1.96 5.5 -5 52 4.81 8.5 -4.00 5.92 12.2 -1 13 TBM2 ۱/۱ S で T =T [く] M
A transit with a stadia interval factor of 99.89 was set at C on the line between points A and B, the following stadia readings were observed. (draw the Instrument set up) If the stadia constant is 0.31 m determine the following: Length of line AB (horizontal). ANSWER: ____________________ If the elevation at B is 752m what is the elevation at B. ANSWER: ___________________
The HI of the instrument placed on top of a 50 m high hill is 1.2 m . The top of the water tank located 500 m away was sighted and has an angle of depression of 5 degrees. What is the elevation of the top of water tank? a. Not listed on the given choices b. 7.439 m c. 7.473 m d. 14.944 m e. 4.31 m
When performing a leveling process for the longitudinal section of a road, the following readings were recorded: The first reading was taken on the leveling number (B.M1), whose Tevel is (60 meters), while the rest of the points were taken on the section points (00+0. 0+50 + 00+ 1... . (While working, lift the device after the fourth, seventh, and tenth reading. Arrange the readings in a table, then complete the table and verify the correctness of the calculations. Draw the segmént and establish a slope line inclined by 0.4% - and its level at the beginning of the project is 60 meters. Find the burial depth in each station. " Reading sequence 1 2 3 4 5 6 7 8 9 10 11 12 13 Reading the ruler 1.35 1.72 1.98 2.05 2.17 2.76 2.98 0.67 1.78 2.48 |2.88 3.10 3.39|
Module 03- Coursework Activity 04 A transit with stadia interval factor of 100.8 was set up at point C on the line between points A and B. The following readings were observed: A B ROD VERTICAL ANGLE +15-25 -09-07 1.972 1.330 UPPER HAIR READINGS MIDDLE 1.854 1.175 1.732 1.010 LOWER If the distance from the instrument to the focus is 0.38m, determine the following: a) Horizontal distance between A and B. b) Difference in elevation between A and B.
7) Please include complete solution and diagram if possible.
pls help me solve this. 1) a transit with stadia interval factor of 100.8 was set up at point C on the line bet. A and B. The ff. readings were observed: (*see from attached photo) If the distance from the focus is 0.38m. determine the ff.: a) horizontal distance bet. A and B b) Diff. in elevation bet. A and B of the value of HI are 300m and 315m respectively.
Please answer all questions and clearly label!!! Thank You.
From the given data of a differential leveling as shown in the tabulation: STA. B.S. H.I. F.S. ELEV. A 5.87 329.25 7.03 6.29 3.48 6.25 D 7.25 7.08 E 10.19 5.57 9.29 4.45 G 4.94 a.) Find the difference in elevation of station F and station E. b.) Find the difference in elevation of station G and station B. c.) Find the elevation of station D.
2. The following data were obtained by stadia observation; vertical angle, +12 deg 30 min; upper stadia hair reading and lower stadia hair readings, 4.5 and 3.25m, respectively. The rod reading was taken at 3.875m above the stadia point at A. and the height of the instrument above the instrument station B, is 1.620m. If the stadia interval factor is 99.5 and the instrument constant is0.381m, find a) the horizontal distance between the instrument station and the stadia point. b) The inclined distance from the center of the instrument to the rod reading c) The difference in elevation between the two ground point.
Determine vertical deflection at point D.