A line 50 m long was paced by an engineer three times and recorded the following results: 58, 60, and 61. He also paced another line three times and again obtained the following results: 231, 236, and 227. Determine the length of the line.

Q: A distance AB is observed repeatedly using the same equipment and procedure, and the results in…

A: computation of most probable value in 4 and 5 part  since most probable length is that length of…

Q: Given in Figure 3.1 are the observed forward and back bearings of a closed compass traverse. Adjust…

A: Submission of all angle for 6 line should be 720° Fore bearing and back bearing of traverse change…

Q: Fundamentals of Surveying: Please show your solution. A line with bearing, S 9° 45' W intersects…

A:

Q: The distance between point A and B was measured 15 times. The mean of the 15 measurements is…

A: Given data- Sample size n = 15Mean=124.555'Standard deviation σ= 0.500'To Find-The 50% Error E

Q: A distance AB is observed repeatedly using the same equipment and procedures, and the results, in…

A: The most probable length is given by the mean of measurements. Therefore the most probable length x…

Q: Use Richardson Extrapolation to solve the finite element method in engineering; refer to the…

A: Step 1: Step 2: Step 3: Step 4:

Q: A vector, F , has components F--286.9 N andF, = 410.6 N. What is the angle made with the horizontal?…

A:

Q: Four interior angles of a five-sided polygon traverse were observed as A = 110°4759", B =…

A: Observation Station  Interior Angle  A 110°47'59" B 121°06'12'' C 122°33'32" D 114°02'25"…

Q: A team of Civil Engineering Students performed a reciprocal leveling along the edge of a dam. The…

A:

Traverse Survey

Traverse surveying is a popular method of surveying. Traversing is that type of survey where several connected survey lines form a framework and the directions and lengths of the survey lines are measured with the help of a tool to measure angles and tape or chain respectively. Traverse networks involve placing survey stations in a queue or trail and using pre-tested points as a basis for looking at the next point. This type of surveying is different from Tacheometric surveying, where only angles are measured and the process of chaining is reduced.