A large lawn sprinkler with four identical arms is to be converted into a turbine to generate electric power by attaching a generator to its rotating head. Water enters the sprinkler from the base along the axis of rotation at a rate of 10 kg/s and leaves the nozzles in the tangential direction at a velocity of 50 m/s relative to the rotating nozzle. The sprinkler rotates at a rate of 400 rpm in a horizontal plane. The normal distance between the axis of rotation and the center of each nozzle is 30 cm. Estimate the electric power produced. (a) 4704 W (b) 5855 W (c) 6496 W (d) 7051 W (e) 7840 W

Q: Number of parallel paths in a wave winding is equal to the number of magnetic poles True False

A: Number of parallel paths in wave winding is 2. In wave winding : A = 2   In case of lap winding…

Q: In a d.c generator, the critical resistance can be increased by increasing it speed

A: As per the guidelines, we supposed to answer one question at a time so please ask other questions…

Q: Q/ 16 pole nine slot per pole 500 rpm Turns/phase 360 Flux per pole 0.0534 web Tow slot Find :- Kd…

A:

Q: A three-phase supply is generated, when three coils are placed apart and the whole rotated in a…

A: Space angle between the windings for n phase supply is 360n where n is the no. of phases

Q: Determine the closed loop poles for a 2nd orde underdamped system knowing its peak time an angle…

A: Given Data: β = 54tP=5 s

Q: A synchronous generator generates 310 V at 50 Hz when the field current is 4.1A. The e.m.f generated…

A:

Q: On the other side, if the rotor rotates at synchronous speed, i.e. s = 0, the induced voltage and…

A: This question belongs to electrical machine . It is based on the concept slip in induction machine.

Q: An isolated 50 Hz synchronous generator is rated at 15 MW which is also maximum continuous power…

A: An isolated 50 Hz synchronous generator rated at 15 MW, Droop=5%, Three loads of 4 MW each at 50 Hz,…

Q: What component of a DC generator rectifies the internally produced alternating current into DC

A: In a DC generator, AC current is produced inside the rotor winding. The current is taken out from…

Q: A synchronous generator has 15 slots per pole. If each coil spans 7 slot pitches, the value 0.5877…

A: Pitch factor (Kp)=cosα2Coil span angle =βshort pitch angle =α(β)+ (α)=180°

Q: (the Greek letter phi). The first alternator Assessment activity 4.2 alternating current. dynamo…

A:

Q: The synchronous speed of a four-pole induction motor operating at 50Hz is A 25 rps B C D 40 rps 35…

A: Given Data:-Pole=P=4frequency=f=50Hz

Q: Explain why the phasor and the impedance have the same angle

A:

Q: The alternator frequency is direct function of rotational speed and number of poles. O True O False

A:

Q: A 100kW generator, 250V, 6 poles have a wave wound armature with 300 turns then the number of…

A: The solution can be achieved as follows.

Q: The number of stator poles produced in the rotating magnetic field of a 3-ϕ  induction motor having…

A: We can use the formula,P = 2n- P is the number of stator poles- n slots per pole per phase Given,n =…

Q: If the voltage is 400v its 3 phase its frequency is 50hz it has 4 poles per phase its running speed…

A: Step 1:

Q: If the armature of an 8-pole machine were wound with a simplex wave winding, find the number of…

A:

Q: The figure shows a rotating loop between curved 6 pole faces, the poles cover 70% of the rotor area,…

A: Hi! Thank you for the question, As per the honor code, we are allowed to answer three sub-parts at a…

Q: Consider a step down converter supplied by a DC power source of magnitude Vs = 220 v. The switching…

A: Rectifier: Because nearly every electrical appliance runs on DC (Direct Current), the rectifier…

Q: A pump station uses an induction motor that requires a complex power of S1 = 55<30° kVAand a…

A:

Q: Determine the magnitude of the resulting magnetic field in the stator at time wt=60, 90 and 120

A:

Q: If a 16 m/s wind is blowing on a wind turbine and the tips of its blades are rotating at 60 m/s.…

A: tip speed ratio =  speed of blade/ wind speed  speed of blade = 60m/s wind speed = 16 m/s

Q: across the j16 2 j40 2 ணை j40 2 24 2 100 V/30° ( -jl Q j4 2 =-j82 -j10 2= j10 2 j9 2 10 Ω 32 8 Ω ll…

A: Assume 100[30°] is a RMS Value.

Q: A synchronous generator generates 345 V at 50 Hz when the field current is 4.4A. The e.m.f generated…

A: Given Data: E1 = 345 V I1 = 4.4 A f 1= 50 Hz E2 = ? f2 = 40 Hz I2 = 2.9 A

Q: The sync be regula speed.

A:

Q: A synchronous generator has 15 slots per pole. If each col spans 7 slot pitches, what n the valan of…

A: Given : A synchronous generator having slot per pole = 15  And coil span = 7 slot pitches  To find :…

Q: Find the magnetic flux φ established in the seriesmagnetic circuit

A: Given data: N=100A=0.009 m2R=0.08 m The expression for the length is given as, l=2π×R=2π×0.08=0.502…

Q: A self excited DC generator has no residual flux, comment how it can be excited

A:

Q: Question 5 A synchronous generator has 6 poles. Determine the speed of the steam turbine driving it…

A:

Q: In a three-phase inductive motor circuit, I want the name of each element and the symbol in this…

A:

Q: A a Single phase 400W, 50 Hz motor takes Suply current of SOA at power factor of 0.6 Lagging The…

A:

Q: False True The speed of d.c shunt motor is decreased if the field current is increased Wave windings…

A: We are authorized to answer three subparts at a time, since you have not mentioned which part you…

Q: The toroid has a coil of 1000 turns wound on its core. If Po = 10 cm and a = 1 cm, what current is…

A: The EM wave is formed when electric field is in contact with magnetic field.  Magnetic field exert…

Winding and Constructions

Alternating Current (AC) winding is generally of the 3-phase type due to the inherent advantages of the 3-phase machine. Armature coils must be connected to the yield balance (equivalent in magnitude and 2/3 of the series phase difference of the rod) 3-phase electromotive forces (emf). The armature should be divided into step-bands to start with slots around the perimeter.In the construction of AC machines, the frame is used as an external protective shield to protect it from environmental conditions. The frame also serves as the outer perimeter, allowing the interior to be easily placed. The static state section of the devices is the stator winding attached stator.