A lamp is plugged into a 120 V outlet. The light bulb has a power rating of 60 W. What is the current drawn by the light bulb?2 AmpsO 720 AmpsO 0.5 AmpsO 240 Amps

The power of the light bulb is define as the product of the voltage and current.…

Answered: A lamp is plugged into a 120 V outlet.…

A lamp is plugged into a 120 V outlet. The light bulb has a power rating of 60 VW. What is thè current drawH by the ngh O 2 Amps O 720 Amps O 0.5 Amps O 240 Amps

Inquiry into Physics

8th Edition

ISBN:9781337515863

Author:Ostdiek

Publisher:Ostdiek

Chapter7: Electricity

Section: Chapter Questions

Problem 12P

See similar textbooks

Related questions

Q: a student in the laboratory connects a 13 resistor, a 26 resistor, and a 36 resistor in parallel and…

A: The resistance of resistors are 13 Ω, 26 Ω and 36 Ω. The voltage of the dc source is 42 V.

Q: В 30 Ω

Q: A device is connected to 12.5 V battery. The amount of energy transformed is proportional to the…

A: According to the Ohm's law, the voltage drop across the circuit is defined as the product of the…

Q: A series circuit is comprised of a 200VDC battery, a switch, a 1 kΩ resistor and a 10000 µF…

Q: 30 052 12 V - 2002 1502 t wants to build a series of circuits to heat a ski lodge. Of the following…

A: Given values:- R1=300-ohm -----(1) R2=200-ohm -----(2) R3=150-ohm -----(3) The potential…

Q: There is a 120V 40 W light bulb, which statement is INCORRECT? Why? the rate of energy…

A: Given that the value of voltage and power then we have to discuss about incorrect statement.

Q: 92 2452 3052

A: Power = I2 R Current I = V/R

Q: A mobile phone charger draws O.2 A of current from the 120 V wall outlet. How much energy does it…

A: Energy = Power × Time # Power = IV where I is current and V is voltage P = (0.2)120 = 24 Watt =…

Q: What current I is needed to transmit 125 MW of power over a transmission line held at a voltage of…

Q: A 1kV battery, a 3 kW resistor, and a 0.50-mF capacitor are connected in series with a switch. What…

A: Current in an RC circuit after two time constants

Q: O N resistor has 2.0 V of potential difference across it. What is the power dissipated by the stor?…

A: Given Resistance R = 10 ohm Potential difference V = 2 V

Q: A 793 W television, a 172 W microwave, and a 65.2 W computer are plugged into an outlet in a 20 A…

Q: A device operates for 8 consecutive days without ever turning off. It uses about 2A when connected…

A: Given data: Current used from voltage source, I = 2 A total number of days for which device is used…

Q: A circuit has a 12V battery attached to a 3 Ohm resistor. What is the value of the * current in the…

Q: A student in the laboratory connects a 14 Ω resistor, a 23 Ω resistor, and a 33 Ω resistor in…

Q: In an old house, the wires leading to a 120 V outlet have a total resistance of 0.45 Ω . When you…

Q: A water pump draws about 3.8A when connected to 240 V. What is the cost (with electrical energy at 9…

A: Given:current, I= 3.8 AVoltage, V=240 VRate of electrical energy= 9 cents per kWhTotal time, t=10 h

Q: A 180.0 V power line is protected by a 20 A fuse. What is the maximum number of 405 W lamps that can…

Q: The following appliances are connected to a single 120 V, 15 A circuit in a kitchen: a 330 W…

Q: Draw a schematic diagram showing the true directions of currents and their corresponding values.…

Q: student in the laboratory connects a 13 Ω resistor, a 24 Ω resistor, and a 38 Ω resistor in parallel…

A: Given Data: The value of resistance of resistors is R1 = 13 Ω. The value of resistance of resistors…

Q: 0.8 A direct current passes through a resistor . What is the voalue of current after 3 s?

A: DC- Direct current is a one directional flow of current (i.e. the polarity of the current remains…

Q: Knowing that current through the 200 Q resistor is zero, the emf E (in V) shown in the circuit is:…

Q: In the figure, which of the following is the value of the current (in ampere ) that passes through…

Q: toaster, a speaker, and a lamp are each plugged in parallel into a 110 V outlet with a 20 A fuse.…

A: P=VI

Q: A 4.0-2 resistor is connected to a 12-2 resistor and this combination is connected to an ideal dc…

A: Given:- Resistance of the resistors are R1=4 Ω, R2=12Ω Voltage of the supply source is V=12 V…

Q: An electric device draws 6.5 A at 240 V. If the voltage drops by 15%, what will be the new current?…

Q: The UL panel on the bottom of an electric toaster oven indicates that it operates at 1500 W on a 110…

A: Given: P = 1500 W V = 110 V

Q: A 1500 W microwave oven runs off of a 240 V supply. The current drawn is by the microwave is…

A: Given data: Power P = 1500 W Voltage V = 240 V Current I = 6.25 A Cost per kWh = $0.0925 Time t = 5…

Q: A 200-V battery is attached to a 100-Ohm resistor and a 10 μF capacitor. What is the time constant…

Q: A student in the laboratory connects a 17 Ω resistor, a 26 Ω resistor, and a 34 Ω resistor in…

A: Write the given values of this problem. R1=17 ohmR2=26 ohmR3=34 ohmV=46 V

Q: An electric utility company supplies a customer’s house from the main power lines (120 V) with two…

A: Potential difference at the customer's house

Q: I5 (A)

Concept explainers

Ohm's law

Ohm’s law is a prominent concept in physics and electronics. It gives the relation between the current and the voltage. It is used to analyze and construct electrical circuits. Ohm's law states that the voltage across a conductor is directly proportional to the current flowing through it.

Path of Least Resistance

In a series of alternate pathways, the direction of least resistance is the actual or metaphorical route that offers the least resistance to forwarding motion by a given individual or body.

Question

A lamp is plugged into a 120 V outlet. The light bulb has a power rating of 60 W. What is the current drawn by the light bulb?
2 Amps
O 720 Amps
O 0.5 Amps
O 240 Amps

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

This is a popular solution!

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Trending now

This is a popular solution!

Step by step

Solved in 2 steps

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, physics and related others by exploring similar questions and additional content below.

Similar questions

A 120-V immersion heater consists of a coil of wire that is placed in a cup to boil the water. The heater can boil one cup of 20.00°C water in 180.00 seconds. You buy one to use in your dorm room, but you are worried that you will overload the circuit and nip the 15.00-A, 120-V circuit breaker, which supplies your dorm room. In your dorm room, you have four 100.00-W incandescent lamps and a 1500.00-W space heater, (a) What is the power rating of the immersion heater? (b) Will it trip the breaker when everything is turned on? (c) If it you replace the incandescent bulbs with 18.00-W LED, will the breaker nip when everything is turned on?
Three identical 60.0-W, 120-V lightbulbs are connected across a 120-V power source as shown in Figure P28.72. Assuming the resistance of each lightbulb is constant (even though in reality the resistance might increase markedly with current), find (a) the total power supplied by the power source and (b) the potential difference across each lightbulb.
Integrated Concepts (a) What energy is dissipated by a lightning bolt having a 20,000-A current, a voltage of 1.00102 MV, and a length of 1.00 ms? (b) What mass of tree sap could be raised from 18.0°C to its boiling point and then evaporated by this energy, assuming sap has the same thermal characteristics as water?
A man foolishly tries to fish a burning piece of bread from a toaster with a metal butter knife and comes into contact with 120-V ac. He does not even feel it since, luckily, he is wearing rubber-soled shoes. What is the minimum resistance of the path tire current follows through the person?
Integrated Concepts (a) Assuming 95.0% efficiency for the conversion of electrical power by the motor, what current must the 12.0-V batteries of a 750-kg electric car be able to supply: (a) To accelerate from rest to 25.0 m/s in 1.00 min? (b) To climb a 2.00 102-m- high hill in 2.00 min at a constant 25.0-m/s speed while exerting 5.00 102 N of force to overcome air resistance and friction? (c) To travel at a constant 25.0-m/s speed, exerting a 5.00 102 N force to overcome air resistance and friction? See Figure 20.44.
Figure P27.48 shows a circuit model for the transmission of an electrical signal such as cable TV to a large number of subscribers. Each subscriber connects a load resistance RL between the transmission line and the ground. The ground is assumed to be at zero potential and able to carry any current between any ground connections with negligible resistance. The resistance of the transmission line between the connection points of different subscribers is modeled as the constant resistance RT. Show that the equivalent resistance across the signal source is Req=12[(4RTRL+RT2)1/2+RT] Suggestion: Because the number of subscribers is large, the equivalent resistance would not change noticeably if the first subscriber canceled the service. Consequently, the equivalent resistance of the section of the circuit to the right of the first load resistor is nearly equal to Req. Figure P27.48
Find the current through a person and identify the likely effect on her if she touches a 120-V AC source: (a) if she is standing on a rubber mat and offers a total resistance of 300 k; (b) if she is standing barefoot on wet grass and has a resistance of only 4000 k .
A battery with an internal resistance of 10.0 produces an open circuit voltage of 12.0 V. A variable load resistance with a range from 0 to 30.0 is connected across the battery. (Note: A battery has a resistance that depends on the condition of its chemicals and that increases as the battery ages. This internal resistance can be represented in a simple circuit diagram as a resistor in series with the battery.) (a) Graph the power dissipated in the load resistor as a function of the load resistance. (b) With your graph, demonstrate the following important theorem: The power delivered to a load is a maximum if the load resistance equals the internal resistance of the source.
(a) What is the unknown emfx in a potentiometer that balances when Rxis 10.0 O, and balances when Rsis 15.0for a standard 3.000-V emf? (b) The same emfx is placed in the same potentiometer, which now balances when Rsis 15.0for a standard emf of 3.100 V. At what resistance Rxwill the potentiometer balance?
For the circuit shown in Figure P28.55. the ideal voltmeter reads 6.00 V and the ideal ammeter reads 3.00-k. Find (a) the value of K, (b) the emf of the battery, and (c) the voltage across the 3.00-kft resistor.
A young man owns a canister vacuum cleaner marked 535 W [at] 120 V and a Volkswagen Beetle, which he wishes to clean. He parks the car in his apartment parking lot and uses an inexpensive extension cord 15.0 m long to plug in the vacuum cleaner. You may assume the cleaner has constant resistance, (a) If the resistance of each of the two conductors in the extension cord is 0.900 , what is the actual power delivered to the cleaner? (b) If instead the power is to be at least 525 W, what must be the diameter of each of two identical copper conductors in the cord he buys? (c) Repeat part (b) assuming the power is to be at least 532 W.
The power dissipated by a resistor with a resistance of R=100 is P = 2.0 W . What are the current through and the voltage drop across the resistor?