a L The inductor above has inductance 0.25H and carries a current in the direction shown. The current is changing at a constant rate and the potential difference between points a and b is 1.16V. If the current at t = 0 is 16.1A, what is the

a L The inductor above has inductance 0.25H and carries a current in the direction shown. The current is changing at a constant rate and the potential difference between points a and b is 1.16V. If the current at t = 0 is 16.1A, what is the

College Physics

11th Edition

ISBN:9781305952300

Author:Raymond A. Serway, Chris Vuille

Publisher:Raymond A. Serway, Chris Vuille

Chapter1: Units, Trigonometry. And Vectors

Section: Chapter Questions

Problem 1CQ: Estimate the order of magnitude of the length, in meters, of each of the following; (a) a mouse, (b)...

See similar textbooks

Related questions

Q: An LR circuit is hooked up to a battery which the switch initially open. The resistance in the…

A: Formula of current passing through the LR circuit is as follows: I=VsR1-e-tRL…

Q: An inductor of inductance 6.0H and resistance 640 ohms is connected in series to two resistors which…

A: Given: The value of first resistor is R1=640 Ω The inductor has a value of L=6 H. Out of the…

Q: A circuit is constructed with four resistors, one inductor, one battery and a switch as shown. The…

Q: An RL circuit has an emf source of 28 v, a 62 resistor, a 38 H inductor, and a switch. At what rate,…

A: Given:- In the RL circuit The emf of the source voltage V = 28 V The resistance R = 6 ohm The…

Q: In the LR circuit shown below the switch is closed at t=0. If the voltage source is 90 volts, the…

A: Introduction:-The circuit is open. No current will flow from it.Given:-LR circuit…

Q: An emf of 9.7mV is induced in a coil while the current in a nearby coil is decreasing at a rate of…

Q: An emf of 9.7 x 10-3 V is induced in a coil while the current in a nearby coil is decreasing at a…

A: Given that,The mutual inductance of two coils is 3.6×10-3 Hwhere, ε=9.7×10-3 Vand dIdT=2.7 A/sEmf of…

Q: An emf of 0.50 V is induced across a coil when the current through it changes uniformly from 0.20 A…

A: solution is given by

Q: en the current in one coil changes at a rate of 7.0 A/s, an emf of -9.5 x 10-3 v is induced in a…

Q: A coiled telephone cord forms a spiral with 90.0 turns, a diameter of 1.30 cm, and an unstretched…

A: Given that,Nymber of turns (N) = 90Diameter of coiled telephone (D) = 1.30 cmRadius of of coiled…

Q: In the circuit shown in the figure, the inductor has inductance L = 4.00 H and negligible internal…

Q: An inductor that has an inductance of 15.0 H and a resistance of 30.0 Q is connected across a 100-V…

A: An RL circuit is made by connecting a resistor and an inductor in series or in parallel. The…

Q: The diagram shows a simple electric circuit consisting of a power source, a resistor, and an…

A: The current flowing through the circuit at time t is given as, I = VR(1-e-Rt/L)

Q: An ideal inductor L=100 mH is connected to a source whose peak potential difference is 65 V. a) If…

Q: The circuit shown in the figure contains a resistor and a solenoid. A battery is connected by…

Q: The current I flowing rightward through inductor L is at a steady rate of 0.1280 A/s. The magnitude…

A: GivenThe steady rate of flow of current ,dIdt=0.1280 A/sεL=0.0160 V

Q: Tia needs to produce a solenoid that has an inductance of 3.33 ?H She constructs the solenoid by…

Q: A coiled telephone cord forms a spiral with 60.0 turns, a diameter of 1.30 cm, and an unstretched…

A: Write the expression for the inductance of the solenoid.

Q: An RLC circuit has source εo cosωt, where εo= 10.0 V. R = 201ohms and L = 902 mH and C = 2.01 μF.…

A: Given, εo= 10.0 V. R = 201ohms and L = 902 mH and C = 2.01 μF.

Q: During a 58-ms interval, a change in the current in a primary coil occurs. This change leads to the…

Q: Consider an induction stove utilizing a primary heating coil located just beneath the stove top. The…

A: Given : V=340V f=50kHz L=88mu.H R=1ohm To find: Average power dissipated in the coil

Q: The figure below shows a conducting sheet bent into a tube of width W = 0.586 m and radius R =…

A: Let's assume the tube as solenoid.Now we imagine dividing the tube (or solenoid) into 𝑁 small…

Q: The figure shows an R-L circuit with a switch, a 166.7- resistor, an inductor and a 13.1-V battery.…

Q: A 1.25 H inductor in an RL circuit (with resistance 2.2 Ω) is initially fully charged. A switch is…

A: When the switch is at position 2, the expression for the current will be,

Q: A constant inductance of one henry and a variable resistance R are connected in series with a…

Q: The figure below shows a circuit with a battery of & = 3.78 V, a resistor with R = 2.97 2, and an…

A: Let's double-check each step and ensure the solution is accurate and clear. Steps to Find the Time…

Q: (a) What is the characteristic time constant of a 23.9 mH inductor that has a resistance of 3.89 ?…

Q: Which of the following statements are true? Choose all that apply. O A changing magnetic field will…

Q: A 506-turn solenoid has a radius of 7.80 mm and an overall length of 12.6 cm. (a) What is its…

A: Given, Number of turns, n=506 radius =7.80 mm length =12.6 cm a. When a coil whose length is much…

Q: n the circuit shown in the figure the coil has an inductance L = 0.33 H and a resistance of 21 Ω .…

Q: The maximum allowable potential difference across a 230 mH inductor is 300 V. You need to raise the…

A: L=230 mHV=300Vdi=3.5-1.2=2.3 A

Q: In the circuit, the capacitor is fully charged when switch S is closed. Calculate the time needed…

A: Given data,

Q: A circuit is constructed with a resistor, two inductors, one capacitor, one battery and a switch as…

Q: An emf of 9.7 x 10-3 V is induced in a coil while the current in a nearby coil is decreasing at a…

A: Given that-EMF of a coil, ε=-M×dIdt ..... Equation 01 where, ε is the EMF of the coil,M is…

Q: A 500 mH inductor is connected across an AC generator that produces a peak voltage of 5.0 V.a. At…

A: Given: The inductance is 500 mH. The peak voltage is 5.0 V. The peak current is 50 mA.

Q: The current flowing through a circuit is changing at a rate of 6.00 A/s. If the circuit contains a…

A: We know that,The rate of change of current,didt=6.00 A/sInductance, L=190.0HWe know that,Inductance…

Q: 1. In an alternating current circuit containing resistance R and inductance L the current i is given…

Q: An inductor stores 775.79J of energy at a current of 3.19A. What is the inductance of the inductor?

A: Energy stored in an inductor with inductance L and carrying current I is given by E=12LI2 This…

Q: 13 R2 R1 L An inductor with inductance L = 1 H and negligible resistance is connected to a battery,…

Q: A7.00 µF capacitor is connected to a 12.5 mH inductor as shown in the circuit above. What happens to…

A: A circuit containing both an inductor (L) and a capacitor (C) can oscillate without a source of emf…

Q: Calculate the current as time approaches infinity. Imax %3D Calculate the current at a time of 1.85…

A: Since you have posted a question with multiple subparts we will solve the three subparts posted in…

Q: A charged 30 µF capacitor is connected to a 27 mH inductor. What is the angular frequency of free…

A: Given: C = 30 micro Farad = 30 x 10-6 F F = 27 mH = 27 x 10-3 H

Q: Part A) Determine the energy stored in the inductor L as a function of time for the LR circuit of…

A: Given:- We have an LR circuit as Find:- Part a) Determine the energy stored in the inductor L as a…

Concept explainers

Voltage Across Inductor

An actor is a passive electrical component that consists of a coil bent in the form of wire which uses electromagnetism to produce electric current through the coil. When the electric current flows through a conductor that is the coil, a magnetic flux is developed around the conductor. This flow of current through the coil creates a magnetic field based on Fleming's Right-hand thumb rule. If there is any decrease in the current passing through the inductor, then the magnetic field will also decrease and energy is released through the generation of electric current. There is also a secondary voltage inducing in the same coil due to the magnetic flux, since it opposes any changes in the electric current flowing through the circuit. An inductor is also called choke, coil, or solenoid. A choke is designed to block certain frequencies when the DC current passes. A winding coil is coated with insulation to give extra insulation and protect the circuit. They are usually tightly wrapped around a central core which is cylindrical in nature so that the magnetic flux can be induced. The solenoid is a three-dimension coil that is used to exhibit electromagnetism when the magnetic field is developed due to the current flowing through the coil. The sign convention of the inductor is the same as the power dissipating device. When the current flows into the positive side of the voltage across the inductor, the value is positive and the inductor dissipates power whereas when the inductor releases the power back to the circuit, the current has a negative sign convention. 

Question

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

This is a popular solution!

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Trending now

This is a popular solution!

Step by step

Solved in 2 steps with 2 images

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, physics and related others by exploring similar questions and additional content below.

Similar questions

An inductor of L = 6.95 H with negligible resistance is placed in series with a 8 = 15.7 V battery, a R = 3.00 resistor, and a switch. The switch is closed at time t = 0 seconds. L. Calculate the initial current at t= 0 seconds. ww R. 1(t = 0 s) = Calculate the current as time approaches infinity. Imax = Calculate the current at a time of 1.85 s. I(t = 1.85 s) = %3D %3D Determine how long it takes for the current to reach half of its maximum. S 0000
An inductor is connected across an oscillating emf. The peak current through the inductor is 2.0 A. ▼ Part A What is the peak current if the inductance L is doubled? Express your answer with the appropriate units. I = Submit Part B I = Submit Part C 0. μA Value I = Request Answer What is the peak current if the peak emf &o is doubled? Express your answer with the appropriate units. μA Value Request Answer μÀ Value Units Submit Request Answer C Units What is the peak current if the frequency w is doubled? Express your answer with the appropriate units. w B Units ? ? ?
Do it
Please answer it within 30 minutes. I will upvote!
A V = 50.0 V power supply fully charges a capacitor with capacitance C= 1.33 μF. The capacitor is then connected to a L = 92.7 mH inductor. Find the maximum current (in A) in the resulting oscillations. A
A loop of wire has a self-inductance of 5.5 mH. You pass a current of 9.0 Amps though the loop, and then drop the current to 0 at a contastant rate over 3.5 seconds. What is the EMF generated?
V06
A voltage of 0.35 V is induced across a coil when the current through it changes uniformly from 0.1 to 0.55 A in 0.35 s. What is the self-inductance of the coil? Hint The self-inductance of the coil is H.
b. If a current of (0 + 2) A is applied to an inductor of (0 + 55) mH, find the energy stored in the inductor.
In the circuit shown in the Figure with 3.0 mH for the inductance and 6.0 uF for the capacitance, S1 has been closed for a long enough time so that the current reads a steady 3.50 A. Suddenly, S2 is closed and S1 is opened at the same instant. What is the maximum charge that the capacitor will receive? What is the current in the inductor at this time? At an instant when the charge on the capacitor is 0.1 mC, what is the current in the inductor? At an instant when the charge on the capacitor is 0.1 mC, what is the rate at which the current in the inductor is changing?
Say we have an inductor with an inductance of 2.5 H. How fast does the current through it change when the voltage across it is 10 V?
An inductor has an inductance of 0.120 mH. Calculate the number of turns per unit length (meter) of this inductor if it has a total of 719 turns in it. The cross-sectional area of the solenoid is 2.83 cm². Take Ho = 4TT x 10-7 T.m/A. X Submit your answer after rounding off to zero decimal place. You are required to show your work in the file you submit.