(a) In a refrigerating plant using R12 the vapour leaves the evaporator dry saturated at 1.826 bar and is compressed to 7.449 bar. The temperature of the vapour leaving the compressor is 45°C. The liquid leaves the condenser at 25°C and is throttled to the evaporator pressure. Calculate: (i) the refrigerating effect; (ii) the specific work input;

(a) In a refrigerating plant using R12 the vapour leaves the evaporator dry saturated at 1.826 bar and is compressed to 7.449 bar. The temperature of the vapour leaving the compressor is 45°C. The liquid leaves the condenser at 25°C and is throttled to the evaporator pressure. Calculate: (i) the refrigerating effect; (ii) the specific work input;

Elements Of Electromagnetics

7th Edition

ISBN:9780190698614

Author:Sadiku, Matthew N. O.

Publisher:Sadiku, Matthew N. O.

ChapterMA: Math Assessment

Section: Chapter Questions

Problem 1.1MA

See similar textbooks

Similar questions

35. What is a temperature of -5°C in degrees Kelvin?
a.) If the specific weight of a liquid is 55 lb/ft³, what is its density? b.) If the specific weight of a liquid is 9.6 kN/m³, what is its density? c.) If the specific volume of a gas is 295 ft³/slug, what is its specific weight in Ib/ft?
What is the velocity of car in m/min, when it is travelling with 35 km /hr.
The following are units of heat except:Select one: a.Cal b.BTU c.0C d.J
A transmission shaft used to transmit power of 55 kW. During transmission shaft is subjected to a 30 N.m torque. Calculate the number of revolution of the shaft in one minute.
A gage on the suction side of a pump shows a vacuum of 275 mm of mercury. Compute the pressure in kPa (answer in 2 decimal places)
The cylinder pressure vessel has an inner radius of 1.25 m and a wall thickness of15 mm. It is made from steel plates that are welded along the 45oseam. The vesselis internally pressurized by 10 Mpa. a. Is it a thin or thick wall? b. What are the general state of stresses for this problem? c. Is it plane stress problem? d. Using Mohr’s circle, find out the principle stresses. e. What would be the shear stress values associated with the principle stresses? f. Determine the normal and shear stress components along this seam, usinganalytical equation, and then show the normal stress and shear stress componentsin your Mohr’s circle. ONLY A,B & C PLEASE
Please answer ASAP. I will rate helpful thank you.
3) The unit of force in S.I. system of units is dyne O kilogram O Newton watt
1. In region A, the pressure on Earth's crust is 4,200 psi, which is double the pressure in region B. Write and solve an algebraic equation to find the pressure in region B. 2. The pressure on the Earth's crust in region A is 11 MPa, which is half the pressure in region B. Write and solve an algebraic equation to find the pressure in region B.
a. What is the elevation of liquid on end A? b. What is the elevation of liquid on end B? c. What is the elevation of liquid on end C? d. What is the elevation of liquid on end D? dont round off the values if its not the final answer. three decimal on the final answer thank you
1. Round off to FOUR DECIMAL PLACES for all calculations made.