a) Illustrate the contents of a synchronous TDM multiplexer that combines five sources to send the following characters. Note that the characters are sent in the same order that they are typed, and the third source is silent. Five signal sources Source 1 message: VIRUS Source 2 message: CO VID Source 3 message: Source 4 message: PENJANA Source 5 message: FLU

a) Illustrate the contents of a synchronous TDM multiplexer that combines five sources to send the following characters. Note that the characters are sent in the same order that they are typed, and the third source is silent. Five signal sources Source 1 message: VIRUS Source 2 message: CO VID Source 3 message: Source 4 message: PENJANA Source 5 message: FLU

Database System Concepts

7th Edition

ISBN:9780078022159

Author:Abraham Silberschatz Professor, Henry F. Korth, S. Sudarshan

Publisher:Abraham Silberschatz Professor, Henry F. Korth, S. Sudarshan

Chapter1: Introduction

Section: Chapter Questions

Problem 1PE

See similar textbooks

Similar questions

One of the 193 bits in the DS-1 transmission format is used for frame synchronization. Explain its use.
3. A binary sequence, 01...., formatted using bipolar-AMI is transmitted over a noisy channel. The received waveform that contains an error is shown below. Locate the position of this error and identify the transmitted data bit pattern. 1
Computer science What is the maximum number of slots in a TDM frame if n signal sources with the same data rate are to be sent at the same time?
b
communication systems help pls
For a 4 bits/level transmission, how many quantization levels are there?
Sketch the signal to carry through the medium if the sequence of bits to send using NRZ-I line encoding scheme is 1110010110
In synchronous TDM, it is possible to interleave hits, one bit from each channel participating in a cycle. If the channel is using a self-clocking code to assist synchronization, might this bit interleaving introduce problems because there is not a continuous stream of bits from one source?
Timing error occurs in synchronization as a result of frequency difference between two physically oscillators (transmitter and receiver). Analyze the effects of frequency difference in asynchronous character transmission with data rate of 10 kbps as shown in figure below
Digital logic design